A 4-lane rural basic freeway segment is with hourly flow rate = 1528 pcphpl. The interchange density is 0.8/km, average lane width is 3.7m, sufficient lateral clearance. Using the HCM 2000 procedure, the estimated FFS speed (kph) and the current segment LOS are …………. and …………….. respectively. a. 108 & LOS D b. 107 & LOS E c. 114 & LOS C d. 104 & LOS B e. none

A 4-lane rural basic freeway segment is with hourly flow rate = 1528 pcphpl. The interchange density is 0.8/km, average lane width is 3.7m, sufficient lateral clearance. Using the HCM 2000 procedure, the estimated FFS speed (kph) and the current segment LOS are …………. and …………….. respectively. a. 108 & LOS D b. 107 & LOS E c. 114 & LOS C d. 104 & LOS B e. none

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter9: Capacity And Level Of Service For Highway Segments

Section: Chapter Questions

Problem 16P

See similar textbooks

Similar questions

A new section of Richmond Highway is being designed as a six-lane facility (three ineach direction) with a two-way left-turn lane. Determine the peak-hour LOS.Traffic data:• Directional design hourly volume = 3600 veh/h• PHF = 0.94• Assumed base free-flow speed = 55 mi/h (88 km/h)Geometric data:• Urban setting• Rolling terrain• Lane width = 11 ft (3.3 m)• Shoulder widths = 4 ft (1.2 m) (right side) and 1 ft (0.3 m) (left side)• Average access point spacing = 12 points per mile on each side
Determine the PTSF in each direction for a 4.5 mi (7.2 km) two-lane highway segmentin level terrain. Traffic volumes (two-way) are 1100 veh/h. Trucks: 10%; RVs: 7%; PHF:0.97; directional split: 60/40; no passing zones: 40%.
A 960-m segment of 5.4-km six lane divided TWLTL multilane highway in a suburban area is at a 1.5% grade. The highway is in level terrain and lane widths are 3-m. The peak-hour volume is 3500 veh/hr/ln, PHF is 0.90, and there are 13% trucks and 2% RVs. Determine the LOS for the following:(a) extended directional segments (b) 3% upgrade(c) 4% downgrade
A four-lane freeway with 12 ft lanes and 5 shoulders is on a 2% grade for the 1.25-mi analysis stretch. There are 2 ramps in this section. If the traffic mix is generally 6% heavy vehicles with a 70/30 SUT/TT split and a PHF of 0.8, how many vehicles can the freeway carry in the peak hour without dropping below Level of Surface (LOS) C?
A new section of Richmond Highway is being designed as a six-lane facility (three in each direction) with a two-way left-turn lane. Determine the peak-hour LOS. (Assume commuter traffic, 5% trucks, and no RVs.) Traffic data: demand volume = 3,120 veh/h PHF = 0.95 assumed base free-flow speed = 55 mi/h Geometric data: urban setting rolling terrain lane width = 11 ft shoulder widths = 4 ft (right side) and 1 ft (left side) average access point spacing = 12 points per mile on each side LOS A LOS B LOS C LOS D LOS E LOS F
A two-lane minor road intersects with a four-lane major street at 90 deg, forming a 4-leg intersection with traffic on the minor road controlled by a stop sign. The speed limits were 45 mph on the major road, and 25 mph on the minor road. Determine the intersection sight distance (ISD) when a passenger car wants to make a left turn onto the major street. (The grades of both road are low than 3%)
A freeway is to be designed for the following conditions:Heavy vehicle adjustment factor = 0.80Total ramp density =0.75 ramps/miTwo lanes each way with average lane width = 12 ftRight side lateral clearance = 4 ftNo. of lanes in one-way = 2 What is the free flow speed (FFS) in mph of the basic freeway segmen?
A four-lane undivided multilane motorway in a suburban area has the subsequent characteristics: posted pace restriction = 50 mi/h; eleven-feet lanes; common obstructions located four ft from the proper pavement facet: 30 get right of entry to factors/mi at the proper facet of the fa cility. what is the free-drift velocity for the course defined?
28-7 A long segment of suburban freeway is to be designed on level terrain. The level segment, however, is followed by a 4.5% grade, 2.0 miles in length. If the DDHV is 2,500 veh/h with 15% trucks (standard mix), how many lanes will be needed on the (a) upgrade, (b) downgrade, (c) level terrain segment to provide for level of service C? Lane widths and lateral clearances may be assumed to be 12 ft and 6 ft, respectively. Ramp density is expected to be 1.0 ramps/mi. The PHF is 0.92. Good weather, no incidents, no work zones, and regular users of the facility may be assumed.
A section of four lane (two lanes in each direction) freeway in mountainous terrain, which is 2.5 mi long, is to be improved to carry on a regular weekday a heavy volume of 3000 veh/h, consisting of 80% passenger cars, 15% trucks, 3% buses, and 2% recreational vehicles. The PHF is 0.90. Determine the additional number of 12-ft lanes required in each direction if the road is to operate at LOS B. The base FFS is 65mph, there is a lateral obstruction 4ft from the pavement on the right side of the road, and interchange spacing is 2 mi. Driver population adjustment factor fp= 1.0.
1. Expressway four lane dividing, passing through flat terrain has a horizontal curve ofradius to rulling minimum radius. If the design speed is 120km/hr. Calculate the followingelements of the curve. a) Rulling minimum radiusb) Super elevationc) Extra wideningd) length of transition curve This is the question of Transport Insfrastructure.
The C-5 Southlane Freeway/Expressway having 6 lanes (three lanes in each direction) is 3.6m wide per lane and has an edge distance of 2 m to the nearest obstruction. A total of 26 on-or off-ramps within the 40 km span, from which 3 ramps are located within 5 km upstream and 4 ramps within 5 km downstream from the midpoint of the analysis segment can be observed. Determine the free-flow speed of the existing freeway, in kph. Do not round-off your FFS