A four-lane freeway with 12 ft lanes and 5 shoulders is on a 2% grade for the 1.25-mi analysis stretch. There are 2 ramps in this section. If the traffic mix is generally 6% heavy vehicles with a 70/30 SUT/TT split and a PHF of 0.8, how many vehicles can the freeway carry in the peak hour without dropping below Level of Surface (LOS) C?

A six-lane freeway (three lanes in each direction) has regular weekday users and currently operates at maximum LOS C conditions. The lanes are 11 ft wide, the right-side shoulder is 4 ft wide, and there are two ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The highway is on rolling terrain with 10% large trucks and buses (no recreational vehicles), and the peak-hour factor is 0.90. b.) Determine the adjustment factor (f). (Express in three decimals)

An eight-lane freeway section is designed to have a lane width of 10 ft, right-side shoulder width is 4 ft, and 5 ramps over a 2-mile-long centerline. What is the free-flow speed for this freeway section? a. 75 mph b. 70 mph c. 65 mph d. 60 mph

traffic engineering - Q / A freeway is being designed to carry a heavy volume of 5000 veh / h on a regular weekday in rolling terrain . If the PHF is 0.9 and the traffic consists of 90 % passenger cars and 10 % trucks , determine the number of 12 - ft lanes required in each direction if the highway is to operate at level of service C. The free - flow speed is 70 mi / h , there is no lateral obstruction , and interchanges are 3 mi apart .

A divided hwy is to be built in a suburban level terrain, forecasted AADT = 12,000 vehicle/day, with 5% trucks, the fraction of traffic in the peak direction of flow is 0.7, PHF = 0.85, desired LOS is "C", assume K factor = 0.12, the number of lanes that will be needed in each direction is:

A segment of rural freeway is being designed for a FFS of 65 mph using 11 ft lanes in a mountainous area. The lateral clearance is nominal (1 ft). The directional (i.e. one-way) design flow rate is expected to be 2,400 passenger cars per hour. How many lanes in one direction will be needed to provide at least a LOS B?

The C-5 Southlane Freeway/Expressway having 6 lanes (three lanes in each direction) is 3.6m wide per lane and has an edge distance of 2 m to the nearest obstruction. A total of 26 on-or off-ramps within the 40 km span, from which 3 ramps are located within 5 km upstream and 4 ramps within 5 km downstream from the midpoint of the analysis segment can be observed. Determine the free-flow speed of the existing freeway, in kph. Do not round-off your FFS

A six-lane urban freeway (three lanes in each direction) is on rolling terrain with 11-ft lanes, obstructions 2 ft from the right edge of the traveled pavement, and nine ramps within three miles upstream and three miles downstream of the midpoint of the analysis segment. The traffic stream consists primarily of commuters. A directional weekday peak-hour volume of 2300 vehicles is observed, with 700 vehicles arriving in the most congested 15-min period. If the traffic stream has 15% large trucks and buses and no recreational vehicles and at some point, further along the roadway there is a 6% upgrade that is 1.5 mi long.  (assuming that the proportion of vehicle types and the peak-hour factor remain constant) Determine the FFS value in mi/hDetermine the PHF or Peak Hour FactorDetermine the fHVDetermine the value of vp

A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak- hour factor is 0.90, and all drivers are regular users. The lanes are 12 ft wide, there are no lateral obstructions within 10 ft of the roadway, and the total ramp density is 1.0 ramps per mile. A bus strike will eliminate all bus traffic, but it is estimated that for each bus removed from the roadway, seven additional passenger cars will be added as travelers seek other means of travel. a.) What is density, before the bus strike? b.) What is the volume-to-capacity ratio, before the bus strike? c.) What is the level of service of the upgrade segment before the bus strike? d.) What is density, after the bus strike? e.) What is the volume-to-capacity ratio, after the bus strike? f.) What is the level of service of the upgrade segment after the bus strike?

A 4-lane rural basic freeway segment is with hourly flow rate = 1528 pcphpl. The interchange density is 0.8/km, average lane width is 3.7m, sufficient lateral clearance. Using the HCM 2000 procedure, the estimated FFS speed (kph) and the current segment LOS are …………. and …………….. respectively. a. 108 & LOS D b. 107 & LOS E c. 114 & LOS C d. 104 & LOS B e. none