A 40 kg block is attached to the wall with a wire and is resting on the 50 kg and 30 kg blocks on an inclined surface. The coefficients of friction for each contact between the blocks and the surface are shown in the figure. Determine the smallest force P which will cause sliding.

A 40 kg block is attached to the wall with a wire and is resting on the 50 kg and 30 kg blocks on an inclined surface. The coefficients of friction for each contact between the blocks and the surface are shown in the figure. Determine the smallest force P which will cause sliding.

Name: 40 kgMs = 0.4.50 kgP30 kgHs = 0.3-30°shown in the figure. Determine t
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: 40 kgMs = 0.4.50 kgP30 kgHs = 0.3-30°shown in the figure. Determine the smallest force P which will causesliding.Hs = 0.45A 40 kg block is attached to the wall with a wire and is resting on the50 kg and 30 kg blocks on an inclined surface. The coeff

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter5: Further Applications Of Newton's Laws: Friction, Drag, And Elasticity

Section: Chapter Questions

Problem 19PE: Repeat Exercise 5.18 with the contestant pulling the block of ice with a rope over his shoulder at...

See similar textbooks

Similar questions

An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the wire be before the stress at its upper end reaches the proportionality limit, which is 8.0107N/m2 ?
A brass wire and a steel wire, both of the same length, are extended by 1.0 mm under the same force. Is the cross-sectional radius of the brass wire more, less, or equal to the cross-sectional radius of the steel wire? Explain. Youngs moduli for brass and steel are 1.0 1010 N/m2 and 2.0 1011 N/m2, respectively.
In order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?
A rod of length 4.00 m with negligible mass is hinged to a wall. A rope attached to the end of the rod runs up to the wall at an angle of exactly 45, helping support the rod, while a sign of weight 10.0 N is hanging by two ropes attached to the bottom of the rod. The ropes make an angle of exactly 30 with the rod as shown in Figure P14.79. Another sign with a weight of 10.0 N is attached to the top of the rod with its center of mass at the midpoint of the rod. The entire system is in equilibrium. Find the magnitude of the tension in the rope above the rod that is also attached to the wall. FIGURE P14.79 Problems 79 and 80. N In Problem 79, find the magnitude of the vertical and horizontal components of the force that the hinge must exert on the rod to keep the system in equilibrium.
A steel cable 2.00 m in length and with cross-sectional radius 0.350 mm is used to suspend from the ceiling a 10.0-kg model aircraft that is flying in a horizontal circle with an angular speed of 6.00 rad/s. What is the strain produced in the cable?
Bruce Lee was famous for breaking concrete blocks with a single karate chop. From slow-motion video, the speed of his 1.50-kg hand descending on a block was estimated to be 15.0 m/s, which decreased to a speed of 0.500 m/s in the 2.50 103 s during which his hand made contact with and broke through the block. The maximum shear stress a concrete block can be subjected to before breaking is 9.50 105 N/m2. a. What was the force exerted by Lees hand on the block? b. If a typical concrete block broken by Lee was 3.00 cm thick and 15.2 cm wide, what is the shear stress experienced by the concrete block? c. Will the concrete block succumb to Lees karate chop?
(a) What force must be exerted by the wind to support a 2.50-kg chicken in the position shown in Figure 9.33? (b) What is the ratio of this force to the chicken's weight? (c) Does this support the contention that the chicken has a relatively stable construction? Figure 9.33
One end of a uniform 4.00-m-long rod of weight Fg is supported by a cable at an angle of = 37 with the rod. The other end rests against the wall, where it is held by friction as shown in Figure P12.23. The coefficient of static friction between the wall and the rod is s= 0.500. Determine tile minimum distance x from point A at which an additional object, also with the same weight Fg can be hung without causing the rod to slip at point A.
(a) Estimate the force with which a karate master strikes a board, assuming the hands speed at the moment of impact is 10.0 m/s and decreases to 1.00 m/s during a 0.002 00-s time interval of contact between the hand and the board. The mass of his hand and arm is 1.00 kg. (b) Estimate the shear stress, assuming this force is exerted on a 1.00-cm-thick pine board that is 10.0 cm wide, (c) If the maximum shear stress a pine board can support before breaking is 3.60 106 N/m2, will the board break?
Assume Youngs modulus for bone is 1.50 1010 N/m2. The bone breaks if stress greater than 1.50 108 N/m2 is imposed on it. (a) What is the maximum force that can be exerted on the femur bone in the leg if it has a minimum effective diameter of 2.50 cm? (b) If this much force is applied compressively, by how much does the 25.0-cm-long bone shorten?
A flexible chain weighing 40.0 N hangs between two hooks located at the same height (Fig. P12.9). At each hook, the tangent to the chain makes an angle = 42.0 with the horizontal. Find (a) the magnitude of the force each hook exerts on the chain and (b) the tension in the chain at its midpoint. Suggestion: For part (b), make a force diagram for half of the chain. Figure P12.9
A 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 N