A 40.0-2 resistor is connected across a 15.0-V variable-frequency electronic oscillator. Find the current through the resistor when the frequency is (a) 100 Hz and (b) 100 kHz. 35.16 [I] 35.17 [I] Solve Problem 35.16 if the 40.0-2 resistor is replaced by a 2.00-mH inductor. 35.18 [I] Solve Problem 35.16 if the 40.0-2 resistor is replaced by 0.300-uF capacitor.

A 40.0-2 resistor is connected across a 15.0-V variable-frequency electronic oscillator. Find the current through the resistor when the frequency is (a) 100 Hz and (b) 100 kHz. 35.16 [I] 35.17 [I] Solve Problem 35.16 if the 40.0-2 resistor is replaced by a 2.00-mH inductor. 35.18 [I] Solve Problem 35.16 if the 40.0-2 resistor is replaced by 0.300-uF capacitor.

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section31.5: Oscillations In Lc Circuit

Problem 31.5QQ: (i) At an instant of time during the oscillations of an LC circuit, the current is at its maximum...

See similar textbooks

Similar questions

(II) The generator of a car idling at 1100 rpm produces12.7 V. What will the output be at a rotation speed of2500 rpm, assuming nothing else changes?
Practice Problem 20-5 A lightbulb of resistance 6.0 ␣ is connected with a switch, a 20 H inductor, and a 12 V battery. The switch is initially open and the inductor not energized. How long does it take, after the switch is closed, for the bulb to reach one-half of its maximum brightness?
Problem 6: Consider a 27 mH inductor that has a resistance of 4.25 Ω. Part (a) What is the time constant, τ, of the inductor, in seconds? Part (b) If the inductor is connected to a 12.0 V battery, what is the current, I, in amperes, after 10.5 ms?
1. Two coils (respectively) as ideal inductors, self-inducting L1 and L2 and mutual induction (between them) M. Determine the alternate induction ( L ) when the two coils: (a) close together, and (b) far apart.
Problem 13: Suppose you needed to transmit 75 MW of AC power at a voltage of 35 kV. Part (a) What current (in kA) is required to do this? I = ______ Part (b) Find the power loss in a 1.00 Ω transmission line in MW. P' = ______ Part (c) What percent loss does this represent? P'/P (%) = ______
(I) A step-up transformer increases 25 V to 120 V. What isthe current in the secondary coil as compared to the primarycoil?
6. An rms voltage of 10.0 V with a frequency of 1.00 kHz is applied to a 0.220-mH inductor. (a) What isthe rms current in this circuit? (b) By what factor does the current change if the frequency of thevoltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz.
(II) A heater coil connected to a 240Vrms ac line has aresistance of 38 Ω (a) What is the average power used?(b) What are the maximum and minimum values of theinstantaneous power?
Problem 5: A precision laboratory resistor is made of a coil of wire. The coil is 1.6 cm in diameter, 3.75 cm long, and has 500 turns. Part (a) What is its self-inductance in millihenries? Part (b) What average emf in volts is induced if a 12.0 A current through it is turned on in 5.00 ms (one-fourth of a cycle for 50 Hz AC)? Part (c) What is its inductance in millihenries if it is shortened to half its length and its 500 turns are counter-wound (wound as two oppositely-directed layers of 250 turns each)?
3. After a very long time, across which circuit element is the voltage equal to the emf of the battery? (a) the resistor (b) the inductor (c) both the inductor and resistor
Problem 19: Part (a) What is the rms current that the motor draws, in amperes? Irms = ______ A Part (b) By what angle, in degrees, does the current lag the input voltage? ϕ = ______ o Part (c) What is the capacitance, in microfarads, of the capacitor that should be connected in series with the motor to cause the current to be in phase with the input voltage? C = ______ μF
True or False: 1. If a closed circuit only has an inductor and a capacitor, then the response of the circuit isundamped.