A 48.2 kg man is walking on a 146 kg uniform beam that is attached 18.8 m below the top of a building and is 21.6 m long. If a wire is attached to both the top of the building and end of the beam, and is able to handle 1.53E3 N of tension, how close to the end can the man walk before the wire breaks?

A 48.2 kg man is walking on a 146 kg uniform beam that is attached 18.8 m below the top of a building and is 21.6 m long. If a wire is attached to both the top of the building and end of the beam, and is able to handle 1.53E3 N of tension, how close to the end can the man walk before the wire breaks?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 33PQ: Problems 33 and 34 are paired. One end of a uniform beam that weighs 2.80 102 N is attached to a...

See similar textbooks

Similar questions

A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.
A person carries a plank of wood 2.00 m long with one hand pushing down on it at one end with a force F1 and the other hand holding it up at .500 m from the end of the plank with force F2. If the plank has a mass of 20.0 kg and its center of gravity is at the middle of the plank, what are the magnitudes of the forces F1 and F2?
A stepladder of negligible weight is constructed as shown in Figure P10.73, with AC = BC = = 4.00 m. A painter of mass m = 70.0 kg stands on the ladder d = 3.00 m from the bottom. Assuming the floor is frictionless, find (a) the tension in the horizontal bar DE connecting the two halves of the ladder, (b) the normal forces at A and B, and (c) the components of the reaction force at the single hinge C that the left half of the ladder exerts on the right half. Suggestion: Treat the ladder as a single object, but also treat each half of the ladder separately.
In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?
A 45.1 kg man is walking on a 147 kg uniform beam that is attached 19.0 m below the top of a building and is 21.2 m long. If a wire is attached to both the top of the building and end of the beam, and is able to handle 1.52E3 N of tension, how close to the end can the man walk before the wire breaks?
A uniform beam of length L = 11.7 meters and mass of 109.3 kg is pinned at one end and is being supported by a wire as shown. The wire is connected to the beam x = 3.3 meters from the pin. A person of mass 81.6 kg is standing all the way out on the edge of the beam. If θ = 17.3 degrees and φ = 79.4 degrees, what is the tension in the wire?
Jack and Rose are carrying a uniform rod that is 3.00m long and weighs 160.N. If Rose lifts at one end with an upward force equal to 60.0N, how far from Rose should Jack lift so that the rod will be horizontal and in equilibrium?
A sign is supported by a uniform horizontal boom of length 3.10 m and weight 72.0 N. A cable, inclined at an angle of 16 °with the boom, is attached at a distance of 2.71 m from the hinge at the wall. The weight of the sign is 108.0 N. What is the tension in the cable and what are the horizontal and vertical forces Fx and Fy exerted on the boom by the hinge? Comment on the magnitude of Fy. T= In N Fx= in N Fy= in N The magnitude of Fy is select (small or large) compared to that of Fx and T.
A diving board 3.00 m long is supported at a point 1.00 m fromthe end, and a diver weighing 500 N stands at the free end (Fig. ).The diving board is of uniform cross section and weighs 280 N. Find(a) the force at the support point and (b) the force at the left-hand end.
Tweedledum and Tweedledee are carrying a uniform wooden board that is L = 3.00 m long and has a weight of www = 160 N. If Tweedledum applies an upward force of magnitude F1 = 60.0 N at the left end of the board, at what point and with what magnitude F2 of force does Tweedledee have to lift for the board to be carried? a) see attached picture for question
An 80 kgkg construction worker sits down 2.0 mm from the end of a 1450 kgkg steel beam to eat his lunch, as shown in: 1) Determine the tension in the cable under this scenario. 2) Given that the cable supporting the beam is rated at 1.5×104 N , should the worker be worried? yes/no
A person carries a plank of wood 2.00 m long with one hand pushing down on it at one end with a force F1 and the other hand holding it up at .500 m from the end of the plank with force F2 . If the plank has a mass of 20.0 kg and its center of gravity is at the middle of the plank, what are the magnitudes of the forces F1 and F2 ?