A 50 MVA, 11 kV synchronous generator has internal reactance of 0.8 Q. The generator is connected to system of 100 MVA base power, then... | a) The internal generator reactance in per unit is unchanged when connected to this power system b) The internal generator reactance will increase to 1.6 Q when connected to this power system |c) The internal generator reactance is 0.33 pu referred to the generator power rating d) The internal generator reactance in per unit is doubled when connected to this power system

A 50 MVA, 11 kV synchronous generator has internal reactance of 0.8 Q. The generator is connected to system of 100 MVA base power, then... | a) The internal generator reactance in per unit is unchanged when connected to this power system b) The internal generator reactance will increase to 1.6 Q when connected to this power system |c) The internal generator reactance is 0.33 pu referred to the generator power rating d) The internal generator reactance in per unit is doubled when connected to this power system

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter8: Symmetrical Components

Section: Chapter Questions

Problem 8.34P

See similar textbooks

Similar questions

With the same transformer banks as in Problem 3.47, Figure 3.41 shows the oneline diagram of a generator, a step-up transformer bank, a transmission line, a stepown transformer bank, and an impedan load. The generator terminal voltage is 15 kV (line-to-line). (a) Draw the per-phase equivalent circuit, aounting for phase shifts for positive-sequence operation. (b) By choosing the line-to-neutral generator terminal voltage as the reference, determine the magnitudes of the generator current, transmiss ion-line current, load current, and line-to-line load voltage. Also, find the three-phase complex power delivered to the load.
Figure 3.39 shows a oneline diagram of a system in which the three-phase generator is rated 300 MVA, 20 kV with a subtransient reactance of 0.2 per unit and with its neutral grounded through a 0.4- reactor. The transmission line is 64km long with a cries reactance of 0.5-/km. The three-phase transformer T1 is rated 350MVA.230/20kV with a leakage reactance of 0.1 per unit. Transformer T2 is composed of three single-phase transformers, each rated 100 MVA, 127/13.2kV with a leakage reactance of 0.1 per unit. Two 13.2kV motors M1 and M2 with a subtransient reactance of 0.2 per unit for each motor represent the load. M1 has a rated input of 200 MVA with its neutral grounded through a 0.4- current-limiting reactor, M2 has a rated input of 100 MVA with its neutral not connected to ground. Neglect phase shifts associated with the transformers. Choose the generator rating as base in the generator circuit and draw the positive-sequence reactance diagram showing all reactances in per unit.
Equipment ratings for the five-bus power system shown in Figure 7.15 are as follows: Generator G1:Â Â Â Â 50Â MVA,Â 12kV,Â X=0.2 per unit Generator G2: 100Â MVA, 15 kV, X=0.2 per unit Transformer T1: 50 MVA, 10 kV Y/138kVY,X=0.10 per unit Transformer T2: 100 MVA, 15 kV /138kVY,X=0.10 per unit Each 138-kV line: X1=40 A three-phase short circuit occurs at bus 5, where the prefault voltage is 15 kV. Prefault load current is neglected. (a) Draw the positive-sequence reactance diagram in unit on a 100-MVA, 15-kV base in the zone of generator G2. Determine (b) the ThĂ©venin equivalent at the fault, (c) the subtransient fault current in per unit and in kA rms, and (d) contributions to the fault from generator G2 and from transformer T2.
A three-phase, 250 MVA, 16 kV rated synchronous generator is feeding into an infinite bus bar at 15 kV. The generator has a synchronous reactance of 1.62 pu. It is found that the machine excitation and mechanical power input are adjusted to give E = 24 kV and power angle δ = 30◦. a) Determine the line current and active and reactive power fed to the generator terminal. b) With reference to part (a) current is to be reduced by 20% at the same power factor by adjusting mechanical power input to the generator and its excitation. Determine E, angle δ and mechanical power input. c) With the reduced current as in part (c), the power is to be delivered to generator terminal at unity power factor, what are the corresponding values of E and δ and also the mechanical power input to the generator. Per-unit values are given on machine rating as the base.
Three-phase, 60-Hz synchronous generator is connected through a transformer and paralleltransmission lines to an infinite bus. All reactances are given in per-unit on a common systembase. If the infinite bus receives 1.0 per unit real power at 0.95 p.f. lagging, determinea) the internal voltage of the generator andb) the equation for the electrical power delivered by the generator versus its power angle δ.
A (500 MW) generator is delivering (180 MW) to infinite bus through the unit transformer and double transmission lines. The per-unit ractances for a given system are shown in figure below andall the reactances are based on (100 MW) base. The generator emf is ( 1.35p .u.). Determine whether the system remains stable after one circuit of the lines is switch off?
Question 1: Figure 1 shows a single-line diagram of a three-phase, 60-Hz synchronous generator, connected through a transformer and parallel transmission lines to an infinite bus. All reactances are given in per-unit on a common system base. If the infinite bus receives 1.0 per unit real power at 0.95 p.f. lagging, determine (a) the internal voltage of the generator and (b) the equation for the electrical power delivered by the generator versus its power angle δ.
A three-phase, 250 MVA, 16 kV rated synchronous generator is feeding into an infinite bus bar at 15 kV. The generator has a synchronous reactance of 1.62 pu. It is found that the machine excitation and mechanical power input are adjusted to give E = 24 kV and power angle δ = 30 degree. a) Determine the line current and active and reactive power fed to the generator terminal. b) The mechanical power input to the generator is increased by 20% from that in part (a) but its excitation is not changed. Find the new line current and power factor. c) With reference to part (a) current is to be reduced by 20% at the same power factor by adjusting mechanical power input to the generator and its excitation. Determine E, angle δ and mechanical power input. d) With the reduced current as in part (c), the power is to be delivered to generator terminal at unity power factor, what are the corresponding values of E and δ and also the mechanical power input to the generator. Per-unit values are given on…
A three phase synchronous generator with negligible resistance and Xs=20 ohm has induced voltage as well as terminal voltage per phase equal to 230 V. for the load angle of 30o, power received by the bus is .........W.
A 30 MVA, 13.2KV synchronous generator has a solidly grounded neutral. Its positive, negative and zero sequence impedances are 0.3, 0.4 and 0.05 p.u respectively 1-A 30 MVA, 13.2KV synchronous generator has a solidly grounded neutral. Its positive, negative and zero sequence impedances are 0.3, 0.4 and 0.05 p.u respectively 2-What value of reactance in p.u. must be placed in the generator neutral so that the fault current for a double line to ground fault shall not exceed the rated line current?
As shown in Figure 1, a synchronous generator and motor are rated 100 MVA, 13.8 kV.??"=0.2per unit, ??"=0.15per unit, and ??=0.305per unit. The synchronous generator is operating at 100 MVA, 0.95 p.f. lagging and at 1.05 per unit voltage when a three-phase short circuit occurs atbus 2. Please use the direct method to calculate the per-unit values of (a)subtransient generator current (??"); (b)subtransient motor current (??"); and (c)subtransient fault current (??). Please use the superposition method to calculate the per-unit values of (d)subtransient generator current (??"); (e)subtransient motor current (??"); and (f)subtransient fault current (??).
A three-phase, 250 MVA, 16 kV rated synchronous generator is feeding into an infinite bus bar at 15 kV. The generator has a synchronous reactance of 1.62 pu. It is found that the machine excitation and mechanical power input are adjusted to give E = 24 kV and power angle δ = 30◦. a) Determine the line current and active and reactive power fed to the generator terminal. b) The mechanical power input to the generator is increased by 20% from that in part (a) but its excitation is not changed. Find the new line current and power factor. c) With reference to part (a) current is to be reduced by 20% at the same power factor by adjusting mechanical power input to the generator and its excitation. Determine E, angle δand mechanical power input.