A 500-turn coil has an inductance of 3.5 mH. If the number of turns are increased to 1000, all other parameters remaining the same, the inductance will be O 3.5 mH O 1.75 mH O7mH O 14 mH

Q: a + 10 V M 50 Ω b C e 25 Ω 75Ω 100 Ω 25 Ω W 50 Ω d

A: According to ohms law, Current,I = voltage,V/resistance,R

Q: rion is a necessary and sufficient criterion for determining the stability of nonlinear systems.

A:

Q: 1. The position of a point in cylindrical coordinates is specified by (4,2π/3,3). What is the…

A: given the position of the point in cylindrical coordinates is specified by  4 , 2π3 , 3 generally in…

Q: a) QUESTION 1 A control system has been identified to have the block diagram as shown in Figure Q1.…

A:

Q: What is the induced voltage Vs in the transformer, if the primary voltage Vp-220 V with number of…

A: Given data, Primary voltage Vp=220 V Number of turns in primary Np=50 Number of turns in secondary…

Q: 4.41) If the Q- factor of a coil at resonant frequency of 1.5 MHz is 150 for a series resonant…

A: Given data, Q-factor Q= 150 Resonance frequency fr=1.5 MHz

Q: An RLC resonant circuit has a resonance frequency of 1.5 MHz and bandwidth of 10 kHz. If C = 150 pF,…

A: Given, An RLC resonant circuit has, Resonance frequency, fo=1.5 MHz Bandwidth, B.W.=10 kHz…

Q: Op-Amps with no feedback has a gain of ?  a. 5   b. zero   c. infinite   d. 10

A:

Q: he following sequence iof bits(right most bit first) appear on the inputs to a 4 bit parallel adder…

A: Given The following sequence iof bits(right most bit first) appear on the inputs to a 4 bit parallel…

Q: the question is for tan(2-j3)

A: Brief description: For the given complex trigonometric function we need to derive its rectangular,…

Q: On a high-end gaming computer, the component that uses the most power is the... What is the maximum…

A: On a high-end gaming computer, video is required because gaming computers require high-quality…

Q: Design a non- inverting amplifier circuit with a variable gain of 20 – 35. Use a potentiometer of…

A: To Design a non- inverting amplifier circuit with a variable gain of 20 – 35. Using a potentiometer…

Q: Determine the efficiency of 1500kVA, 2300V, 3phase, Y-connected alternator, which operates at rated…

A:

Q: For the given close-loop system transfer function, determine its stability Routh-Hurwitz Test for…

A:

Q: 5.1 A 0.18-µum fabrication process is specified to have t = 4 nm, μ, = 450 cm²/V-s, and V, = 0.5 V.…

A: MOSFET- MOSFET is a type of field effect transistor. In MOSFET, a silicon oxide thin layer is…

Q: Find the equivalent capacitance Ceq seen by the terminals A and B in Figure A1 as a function of C…

A: The solution is

Q: What should be the capacitance of a capacitor in series with a 250Ω resistor that will limit the…

A: We need to find out the value of capacitance and power factor

Q: 2. For an ideal amplifier, the input impedance should be output impedance should be OOohm and…

A:

Q: A separately excited DC motor with supply voltage of 420 V, armature resistance of 0.5 Q and K=1.8…

A: Given: Supply voltage, Vi=420VKm=1.8 V-s/radDuty ratio, D=.65Armature resistance, Ra=.5Ω

Q: Find the total capacitance in micro farads of the combination of capacitors shown in the figure…

A:

Q: A 3 delta connected load each phase of which has a capacitive reactance of 30 2 in series with a…

A:

Q: Consider a voltage source v(t) = 220 cos (100nt - 30°) Define a. The amplitude of v(t) b. The…

A:

Q: What are the transistor fabrication techniques, process of fabrication, structure.

A: According to the question, we need to discuss the transistor fabrication techniques, the process of…

Q: Question 1: A) Derive the transfer function of the electrical circuits shown in Figure below and…

A:

Q: Answer the following: a. Range of frequencies that are within the cut-off frequencies. -pass band…

A: Given

Q: Given: Vin =5V Rin=1K Rf=100 ohms. Identify: a. What is the value of Vout? b. What is the voltage…

A:

Q: Using nodal analysis, find v, in the circuit of Fig. 3.63. 5A 2Ω ΜΕ 8 Ω ΑΜΕ 1Ω 40 V 4Ω 20 V

A: To solve the circuit by nodal analysis, we assume a reference node and write KCL equations at the…

Q: 3. Find V. in the circuit in figure below. 4Ω 60/0° V 1:2 8 Ω V 2 Ω www. Μ 8 Ω

A: 3) To find voltage Vo as shown in the circuit

Q: A JFET shown in the circuit has the following V(GS(off))=-8V and IDSS-16 mA. (a) Plot the Q point of…

A: The JFET circuit diagram is shown below, Where, VGSoff = -8 VandIDSS =16 mA

Q: Q1) A 12KVA, 440V, 4-pole, 3-phase (star-connected synchronous generator has synchronous reactance…

A:

Q: Refer to page 30, the single line diagram shows 1000 kVA. if the transformer capacity rating to be…

A: Given  Refer to page 30, the single line diagram shows 1000 kVA. if the transformer capacity rating…

Q: Determine the collector bias current. Assumeß = 50 and IS = 10^(-17)A

A:

Q: 3.17 Let f(t) be a T-periodic signal and let g(t) be the signal given by 8 (t) = ² ft f(u) du. a…

A: It is given that: gt=1a∫t-atfudu       0<a<T

Q: 11 R, L1, L2, mH mH 2k 10 50 1. graph showing how the amplitude of signal changes when the frequency…

A:

Q: Q1: The voltage wave is on 20 uF capacitor. Find and Draw 1. v (V)| 20 1 1 -t (ms) 0 25 50 75 100…

A: We need to find out the current for given voltage for given capacitor .

Q: Wils 2 (B)- Indicate whether the following statements are true or false and correct the false…

A: In this question we will write about dc shunt motor speed , series motor torque etc... Note :- as…

Q: b) A Permanent Magnet Coil (PMMC) voltmeter has a full-scale reading of 10V corresponding to a…

A: This question is belongs to pmmc instrument with controlling methods

Q: A coil has a resistance of 35-Ω and an inductance of 0.14H the coil is connected to 60cps, 117V…

A:

Q: Q2j Consider the function: (s) = 1−e-T² S X(s) = Show that s = 0 is not a pole of X(s).

A:

Q: 8.13. A 1-T cell memory can be fabricated using PMOS transistors in the array shown in Fig. 8.46.…

A: Given, A 1-T cell memory can be fabricated using PMOS transistors in the array is shown below,

Q: In the AC circuit shown in the figure below, R = 70.0 2 and the output voltage of the AC source is…

A: Given, An Ac circuit shown below, R=70.0 Ωv=∆Vmaxsinωt∆vR=0.270Vmax at t=0.0080 s

Q: For the network of Fig.1, with bypassed capacitance (CE), determine the re equivalent model circuit…

A:

Q: The system H(s) = 10* (s+1000)/(s+10000) is: O A. Bandstop filter O B. Highpass filter O C. Lowpass…

A: Consider the given expression: Hs=10s+1000s+10000

Q: Q21) Find the value of R, if 1,3A Rx Www 562 www 502 www E-24 V 1pm 3A

A:

Q: 35. If the peak amplitude of a low-pass filter output is 5V, what voltage will correspond to the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The position of a point in cylindrical coordinates is specified by (4,2π/3,3). What is the location…

A:

Q: Q.3: For the magnetically coupled circuit shown, find the values of coupling coefficient "k" when…

A:

Q: QII: What do we should add to change the circuit to universal? X Z ED [ x Your answer Z

A:

Q: x(t)= e*u(-t), b) x(t)= etu(-t), h(t)= e²tu(t) h(t)= 8(t) x(t) h(t) y(t)

A:

Q: EX; use phasors and nodal analysis to find U₂ in (2) the circuit that shown below. 3jJz -sjur U2 N₂…

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.