Answered: A 60-kg object is attached to one end…

A 60-kg object is attached to one end of a steel tube 2.40 m long whose mass is 40 kg. The distance from the loaded end to the balance point is ________________?

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 1STP

See similar textbooks

Related questions

Q: You have been hired to design a famıly-friendly see-saw. Your design will feature a uniform board…

Q: The following figure shows a 4 m bar fixed to the wall through a hinge that rotates freely, but is…

Q: A homogeneous, 10 m-long beam has a total weight of 80N and is divided to 10 equal segments. Object…

A: Given:- A homogeneous, 10 m-long beam has a total weight of 80 N and is divided into 10 equal…

Q: A 60 kg diver stands at the end of a 30 kg springboard, as shown. The board is attached to a hinge…

A: Given data The mass of the springboard is, M1= 30 kg The mass of the diver is, M2= 60 kg Step 1 The…

Q: A worker of weight 758.6 kg stands on the end of a beam of weight 1651 N and length L= 109.2 m,…

A: Given Mass of worker m=758.6kg Weight if beam =1651N L=109.2m X=29.2m

Q: The boom in the figure is 2m long and weighs 100 N. If the 800N load is suspended 50cm from the end,…

Q: A uniform stick can be balanced on a knife edge 10cm from one end when a load of 200N is hung from…

A: (a)initial condition200×0.1=mg(x-0.1).........(1)next…

Q: A worker of weight 756.5 kg stands on the end of a beam of weight 1699 N and length L= 118.7 m,…

A: Given Mass of worker =756.5kg Weight of beam =1699N L=118.7m X=26.7m

Q: Answers only, please. Thank you 18. A uniform rectangular board has a length of 8.0 cm and a width…

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 92.0 kg.The pivot under the…

A: (a) Condition for rotational equilibrium τnet=0n2l-mgx-MgL2=0n2=mgx+MgL2l

Q: . A torsion prescription balance has a sensitivity requirement of 0.004 g. Explain how you would…

Q: The system in the figure below is in equilibrium. A 50 kg beam that is hinged on the floor is also…

Q: The uniform seesaw shown below is balanced on a fulcrum located 3.0 m from the left end. The smaller…

Q: A father and his daughter are playing a see-saw made of a plank of length 5.1 m and of weight 118 N…

Q: A 0.120 kg, 50.0-cm-long uniform bar has a small 0.055 kg mass glued to its left end and a small…

A: Given: Mass of the bar = 0.120 Kg Length of the bar = 50 cm Mass at the other end = 0.110 Kg

Q: Determine the additional mass required for stable equilibrium. Meter stick: Xcm = 50.0 cm, m = 150.0…

Q: A solid rod of mass 200 g and length L = 0.50 m is suspended using two strings with equal tensions…

A: given Mass of rod, M = 200 gm Length of rod, L = 0.50 m Mass of object to be put on rod, m = 50…

Q: An equal arm balance is made by placing a meter stick at its center so it looks like a seesaw. The…

A: To maintain the state of equilibirum,

Q: 6.3. The angle of twist for a shaft subjected to twisting torque can be expressed by the following…

A: Bartleby's guidelines allowing answer only the first question.

Q: A uniform rod has a mass of 2.53 kg and has a length of 1.17 m. It is hinged to a wall by a pivot at…

A: The free-body diagram is shown below. Here, T, m, and L are the tension, mass, and the length.

Q: A hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a basket of goodies…

Q: As shown below, a beam of length L is in equilibrium and is attached to a cable which is pulling it…

A: Weight of box = 702 N Wall is frictionless and exerting normal force only Angle between cable and…

Q: Two figures show a system of two pulleys and a block of mass m attached to each other with string in…

Q: The foot of a ladder rests against a wall and its top is held by a tie rope, as shown. The ladder…

A: The free-body diagram is

Q: 6 kg 30 kg 12 1 1.25 1.5/ 1.75 0.25 0.5 0.75 0.75 0.5 0.25 Meters 1 1.75 1.5 1.25 Meters Check 15 kg

A: Torque is the rotational analog of linear force. The torque is given by the cross product of the…

Q: Four cylindrical rods are stretched. The force magnitudes, the cross sectional area, the initial…

A: Given, We know the expression for young modulus is Y=FA(L0∆L)

Q: A horse weights 5000 Newtons. The distance between the front and rear hooves is L1= 1.8 meters and…

A: The torque (τ) about the rotation axis is given by the product of the perpendicular force (F) that…

Q: A uniform beam with a mass of 125 kg and a length of 6.00 meters rests on a fulcrum, which is…

A: (a) The FBD of the given situation can be drawn as shown below: Here, F, W, and T are the…

Q: Weights of 2, 5, 8, and 10 N are hung from a 10-m rod at distances of 2, 4, 6, and 8 m from the left…

A: 2, 5, 8 and 10 N Weights are hung at a distances of 2, 4,6 and 8 m respectively on the rod.

Q: As shown below, a horizontal beam is in equilibrium. The orange circle represents the hinge and the…

A: Given:T=363 Nlength of cable L=5mlength of beam d=4mF=76 N

Q: You place a 15 kg brick 0.5 m to the left of the fulcrum. Where on the right side would you place a…

A: Given data: Mass on left side (m1) = 15 kg Distance from fulcrum (r1) = 0.5 m Mass on right side…

Q: If the beam attached to a hinge is 4 meters long and weighs 600 Newtons, and the sign weighs 400…

Q: A uniform beam of length L = 7.70 m and weight 4.95 x 10² N is carried by two workers, Sam and Joe,…

A: Given data: Length of the beam is, L= 7.70 m Weight of the beam is, W= 4.95×102 N Formula used: At…

Q: 50 N 0.20 L 60 N 0.60 L 80 N 30 0 70

Q: A 6.20 [kg] square plate has side length of 3.25 [m] and is pivoted about an axis through its center…

Q: A uniform 10.0 m ladder of weight WL=375 N leans against a frictionless wall. There is a force of…

Q: Kendra holds the end of a rope that is .5 kilograms and .60 meters long, while her friend Lupita…

A: We are allowed to give the explanation of first question only which is given below. Please repost…

Q: Two plastic toys are hung from the ends of a uniform rod of mass 20.0 g and length 0.500 m to form a…

Q: The system in the figure below is in equilibrium. A 50 kg beam that is hinged on the floor is also…

Q: The thin rod has a mass m = 10 kg applied at its center of gravity and rests against the rough floor…

A: Given The mass of the rod is m=10 kg. The coefficient of friction is μA=0.25. The free-body…

Q: For the system to be in equilibrium the sum all the clockwise moments acting on the system must be…

A: Clock wise moment must be equal to anti Clockwise moment for the sytem to be in equilibrium.For the…

Q: A 45.1 kg man is walking on a 147 kg uniform beam that is attached 19.0 m below the top of a…

A: Draw the free-body diagram of the system.

Q: A rigid beam (light grey), 1.40 m in length and weighing 8.00 N, is supported at an angle of 30° to…

A: Given data: The mass of the beam is w=8.0 N. The length of beam is L=1.4 m. The angle of beam with…

Concept explainers

Center of Gravity of a system

The centre of gravity is a property that is based on the geometry of a rigid body or any particle. It is described as an equilibrium point or a hypothetical location where the total weight of the body is concentrated.

Question

A 60-kg object is attached to one end of a steel tube 2.40 m long whose mass is 40 kg. The distance from the loaded end to the balance point is ________________?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A man is attempting to raise a 7.5 m long, 28 kg flagpole that has a hinge at the base by pulling on a rope attached to the top of the pole. With what force does the man have to pull on the rope to hold the pole motionless in this position?
A rigid vertical rod of mass 75 kg and length 4.0 m is connected to the floor by a bolt through its lower end A. The rod also has a wire connected between its top end B and the floor as shown in the figure. A horizontal force F = 500 N is applied at the midpoint of the rod. What is the tension in the wire?
A man is attempting to raise a 7.5-m-long, 28 kg flagpole that has a hinge at the base by pulling on a rope attached to the top of the pole, as shown. With what force does the man have to pull on the rope to hold the pole motionless in this position?
A father and his daughter are playing a see-saw made of a plank of length 5.1 m and of weight 118 N in a park. If the daughter weights 274 N and sits at one edge of the plank, where the father with a weight of 523 N should sits from the pivot point to balance the see-saw in m, assuming that the plank has uniform density? Keep three significant figures.
The following figure shows a 4 m bar fixed to the wall through a hinge that rotates freely, but is tied to the wall at its other end so that the system is in equilibrium. If the bar weighs 40 N and the tension in the rope is 20 N, find the angle of inclination θ that the bar makes with the x-axis.
A 13.2-kg object hangs in equilibrium from a string with a total length of 6.00 m and a linear mass density of ? = 0.00500 kg/m. The string is wrapped around two light frictionless pulleys that are separated by a distance of d = 2.00 m. Two figures show a system of two pulleys and a block of mass m attached to each other with string in a triangular arrangement. The pulleys are at the top left and top right of the triangle, separated by a distance d. The block connects directly to the bottom corner of the triangle, pulled downward by gravity vector g. In figure (a), the string connecting the pulleys is completely horizontal and unmoving. In figure (b), the string connecting the pulleys is oscillating as a standing wave such that there is one and a half wavelengths between the pulleys. (a) Determine the tension in the string. N(b) At what frequency must the string between the pulleys vibrate in order to form the standing-wave pattern shown in Figure b?
A horse weights 5000 Newtons. The distance between the front and rear hooves is L1= 1.8 meters and the distance from the rear hooves to the center of mass L2=1.1 meters for the horse are shown in the attachment. What fraction of the horses weight is borne by the front hooves?
A 0.120 kg, 50.0-cm-long uniform bar has a small 0.055 kg mass glued to its left end and a small 0.110 kg mass glued to the other end. The two small masses can each be treated as point masses. You want to balance this system horizontally on a fulcrum placed just under its center of gravity. How far from the left end should the fulcrum be placed?
Two children of mass 16 kg and 37 kg sit balanced on a seesaw with the pivot point located at the center of the seesaw. If the children are separated by a distance of 5 m, at what distance from the pivot point is the small child sitting in order to maintain the balance?
A uniform rod of length 100cm and mass 0.4 kg is placed on a fulcrum at a distance of 80cm from the left end of the rod. At what distance from the left end of the rod should a 1.2 kg mass be hung to balance the rod? a) 80 cm from the left end. b) 10 cm from the left end. c) 90 cm from the left end.
An object that weighs 1180 N rests on a lever at a point 0.390 m from a support. On the same side of the support, at a distance of 3.00 m from it, an upward force with magnitude F is applied. Ignore the weight of the board itself. If the system is in equilibrium, what is F? Express your answer in Newtons. where P = 1180 and x = 0.390. _____N
Two children are trying to balance on a seesaw, which includes a fulcrum and a board that is 10m long. Boy A has a mass of 50kg, and boy B has a mass of 35kg. How far from the pivot point should boy B be to maintain stable equilibrium?