A 70 kg box is resting on a reclining floor. The coefficient of friction between the floor and the box is: static = 0.30, kinetic 0.10. 18) If the floor is to be inclined at an angle of 25 deg what would be the acceleration of the object along the direction of the inclined floor? 19) If the floor is to be inclined at an angle of 25 deg what would be the vertical displacement of the box after 1.5 seconds? Express your answer in unit of meters. 20) If the floor is to be inclined at an angle of 25 deg what is the total distance travelled by the box after 1.5 seconds? Express your answer in unit of meters.

A 70 kg box is resting on a reclining floor. The coefficient of friction between the floor and the box is: static = 0.30, kinetic 0.10. 18) If the floor is to be inclined at an angle of 25 deg what would be the acceleration of the object along the direction of the inclined floor? 19) If the floor is to be inclined at an angle of 25 deg what would be the vertical displacement of the box after 1.5 seconds? Express your answer in unit of meters. 20) If the floor is to be inclined at an angle of 25 deg what is the total distance travelled by the box after 1.5 seconds? Express your answer in unit of meters.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 76PQ: Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to...

See similar textbooks

Similar questions

In a television commercial, a small, spherical bead of mass 4.00 g is released from rest at t=0in a bottle of liquid shampoo. The terminal speed is observed to be 2.00 cm/s. Find (a) the value of the constant bin the equation v=mgb(1ebt/m), and (b) the value of the resistive force when the bead reaches terminal speed.
Calculate the maximum acceleration of a car that is heading up a 4.00slope (one that makes an angle of 4.00with the horizontal) under the following road conditions. Assume that only half the weight of the car is supported by the two drive wheels and that the coefficient of static friction is involved—that is, the tires are not allowed to slip during the acceleration. (Ignore rolling.) (a) On wet concrete. (b) On wet concrete. (C) On ice, assuming that s=0.100 , the same as for shoes on ice.
We know from studying friction forces that static friction increases with increasing normal force between the surfaces, which becomes important for vehicles traveling on icy or snowy roads that have coefficients of static friction much smaller than those of dry pavement. In particular, the greater the normal force on the drive wheels (those coupled to the engine), the better the traction. The horizontal position of the center of mass of a typical compact automobile is located 1.1 m toward the rear as measured from the front wheel axle. The wheelbase (distance from the front wheel axle to the rear wheel axle) is 2.7 m. Assume the car is stationary on level ground and has a weight of 12,000 N. Determine the total normal force on the two front tires and on the two rear tires. Which do you suppose are the drive wheels in this case?
Show that the acceleration of any object down an incline where friction behaves simply (that is, where fk=kN ) is a=g(sinkcos). Note that the acceleration is independent of mass and reduces to the expression found in the previous problem when friction becomes negligibly small (k=0).
A 70 kg box is resting on a reclining floor. The coefficient of fricion between the floor and the box is: static = 0.30, kinetic = 0.10. 1. If the floor is to be inclined; What would be the minimum angle of inclination needed so that the box will start to slide down? Express your answer in unit of degrees. 2. If the floor is to be inclined at an angle of 10 deg., What is the needed minimum value of force T (applied to the object with a direction opposite to the direction of sliding) to prevent the box from sliding? Express your answer in unit of N. 3. If the floor is to be inclined at an angle of 25 deg., what is the needed minimum value of force T (applied to the object with a direction opposite to the direction of sliding) to prevent the box from sliding? Express your answer in unit of N.
A 375-lb block rests on a rough plane inclined 35o with the horizontal. If thecoefficients of friction between the block and the plane are 0.58 for static and 0.3 for kinetic respectively, determine whether or not the block is at rest.
A 0.85 kg block of wood is stationary on an incline that is15◦above horizontal. A force of 3.0 N is being applied toit 75◦below horizontal, directly into the incline (the force isperpendicular to the incline). What is the minimum coefficientof static friction required to keep the block stationary?
A hiker who has broken his forearm rigs a temporary sling using a cordstretching from his shoulder to his hand. The cord holds the forearmlevel and makes an angle of 40.0° with the horizontal where it attachesto the hand. Considering the forearm and hand to be uniform, with atotal mass of 1.30 kg and a length of 0.300 m, find (a) the tension inthe cord and (b) the horizontal and vertical components of the force, f>,exerted by the humerus (the bone of the upper arm) on the radius andulna (the bones of the forearm).
Calculate the maximum acceleration of a car that is heading up a 4º slope (one that makes an angle of 4º with the horizontal) under the following road conditions. Assume that only half the weight of the car is supported by the two drive wheels and that the coefficient of static friction is involved—that is, the tires are not allowed to slip during the acceleration. (Ignore rolling.) On dry concrete, assuming that ??=1.0.
A flatbed truck is carrying a crate up a hill of angle of inclination θ = 12.0o, as the figure illustrates. The coefficient of static friction between the truck bed and the crate is μs = 0.340. Find the maximum acceleration that the truck can attain before the crate begins to slip backward relative to the truck.
Two blocks are positioned on surfaces, each inclined at the same angle of 44.0 degrees with respect to the horizontal. The blocks are connected by a rope which rests on a frictionless pulley at the top of the inclines as shown, so the blocks can slide together. The mass of the black block is 6.84 kg, and the coefficient of kinetic friction for both blocks and inclines is 0.250. Assume static friction has been overcome and that everything can slide. What is must be the mass of the white block if both blocks are to slide to the LEFT at an acceleration of 1.5 m/s^2?
Two blocks are positioned on surfaces, each inclined at the same angle of 41.8 degrees with respect to the horizontal. The blocks are connected by a rope which rests on a frictionless pulley at the top of the inclines as shown, so the blocks can slide together. The mass of the black block is 2.76 kg, and the coefficient of kinetic friction for both blocks and inclines is 0.290. Assume static friction has been overcome and that everything can slide. What is must be the mass of the white block if both blocks are to slide to the LEFT at a constant velocity? 5.41 kg 2.76 kg 4.09 kg 1.41 kg