A 86.25 V peak full-wave rectified voltage is applied to a capacitor filter. If fin = 80.76 Hz, RL = 10 kohm and C=15µF, the ripple voltage, Vr(p-p) (in V) is Add your answer A 69.37 V peak full-wave rectified voltage is applied to a capacitor filter. If fin = 86.82 Hz, RL = 15 kohm and C=10µF, the DC voltage, VDc (in V) is Add your answer

A 86.25 V peak full-wave rectified voltage is applied to a capacitor filter. If fin = 80.76 Hz, RL = 10 kohm and C=15µF, the ripple voltage, Vr(p-p) (in V) is Add your answer A 69.37 V peak full-wave rectified voltage is applied to a capacitor filter. If fin = 86.82 Hz, RL = 15 kohm and C=10µF, the DC voltage, VDc (in V) is Add your answer

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1.)A full-wave rectified signal of 18 V peak is fed into a capacitor filter. What is the voltage regulation of the filter if the output is 17 V dc at full load? 2.)A full-wave rectified voltage of 18 V peak is connected to a 400uF filter capacitor. What are the ripple and dc voltages across the capacitor at a load of 100 mA? pls provide complete solution
A 25 V peak full-wave rectified voltage is applied to a capacitor filter. If fin = 60 Hz, RL = 10 kohm and C=10µF, the DC voltage, VDC (in V) is
calculate the ripple of a capacitor filter for a peak rectified voltage of 30 V, capacitor C = 50 mF, and a load current of 50 mA.
An inductor L is connected in parallel to the series combination of capacitor C and resistor R. If L = 0.02122 H, C = 0.000421 F and R = 5 Ω, the impressed voltage E = 120 volts AC. Determine the voltage drop across the capacitor and the Quality Factor Q.
In the circuit in the figure, Rs = 3.8 kohm, R₁ = 82 kohm, R₂ = 22 Kohm, Rc = 5.6 Kohm, RE = 1.5 k and R₁ = 3.3 k and B = 150. Since the capacitances are C1 = 0.5 µF and C2 = 0.8 µF, what is the low cutoff frequency of the given circuit? NOTE-1: In the middle band frequency, B = 150 will be taken and frequency dependence of B will not be taken into account. NOTE-2: The output impedance of the transistor will be neglected in ro calculations.
Search relevant data and data bases for 2 of the most commonly used Band Stop filters in Microwave Communications. State 2 applications of the Filters mentioned.
Which of the the following statements concerning the phase angle compensator is true? A. It is a dc voltage source B. It is an ac voltage source with a controllable amplitude and uncontrollable phase angle C. It is an ac voltage source with a controllable amplitude and uncontrollable amplitude D.t is an ac voltage source with both a controllable amplitude and phase angle
An inductor L is connected in parallel to the series combination of capacitor C and resistor R. If L = 0.02122 H, C = 0.000421 F and R = 5 Ω, the impressed voltage E = 120 volts AC. Find the following: a. Circuit Diagram, total impedance, total current. b. Determine the frequency at which the inductive reactance is equal to capacitive reactance. c. Determine the voltage drop across the capacitor and the Quality Factor Q.
Hey May you please help me to determine the energy stored in the capacitor, C=44 mu,F. WC=?
Solve no.17 and show solutions. (Situation no.08 image below)
A 15 Ω source is connected to an antenna of impedance of 350 Ω, then the value of VSWR assuming that the source impedance is decreased by 25% is........... Microwave antenna has a wavelength of 0.0363 meters and a directivity 897.Then the maximum effective aperture of the antenna assuming directivity is increased by 50% . (0.0941-0.1411-0.0470-0.1881) A half-wavelength antenna is having a wavelength of 26 meters. Then the inner boundary of the Fresnel region is at a distance of___________ meters.
Given than: Rc=5.8 kohms Rs=1.8 kohms R1=80 R2=10