A 89.0 kg person is being pulled away from a burning building as shown in the figure below. 10° (a) Calculate the tension (in N) in the first rope, T₁, if the person is momentarily motionless. (Enter the magnitude only.) N (b) Calculate the tension (in N) in the second rope, T2, if the person is momentarily motionless. (Enter the magnitude only.) N

A 89.0 kg person is being pulled away from a burning building as shown in the figure below. 10° (a) Calculate the tension (in N) in the first rope, T₁, if the person is momentarily motionless. (Enter the magnitude only.) N (b) Calculate the tension (in N) in the second rope, T2, if the person is momentarily motionless. (Enter the magnitude only.) N

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter3: Vectors

Section: Chapter Questions

Problem 15P: The helicopter view in Fig. P3.15 shows two people pulling on a stubborn mule. The person on the...

See similar textbooks

Similar questions

Two blocks, each of mass m, are hung from the ceiling of an elevator as in Figure P4.33. The elevator has an upward acceleration a. The strings have negligible mass. (a) Find the tensions T1 and T2 in the upper and lower strings in terms of m, a, and g. (b) Compare the two tensions and determine which string would break first if a is made sufficiently large. (c) What are the tensions if the cable supporting the elevator breaks? Figure P4.33 Problems 33 and 34.
(a) What is the minimum force of friction required to hold the system of Figure P4.74 in equilibrium? (b) What coefficient of static friction between the 100.-N block and the table ensures equilibrium? (c) If the coefficient of kinetic friction between the 100.-N block and the table is 0.250, what hanging weight should replace the 50.0-N weight to allow the system to move at a constant speed once it is set in motion? Figure P4.74
(a) Find the tension in each cable supporting the 6.00 102-N cat burglar in Figure P4.35. (b) Suppose the horizontal cable were reattached higher up on the wall. Would the tension in the other cables increase, decrease, or stay the same? Why? Figure P4.35
A certain orthodontist uses a wire brace to align a patients crooked tooth as in Figure P4.88. The tension in the wire is adjusted to have a magnitude of 18.0 N. Find the magnitude of the net force exerted by the wire on the crooked tooth. Figure P4.38
Give reasons for the answers to each of the following questions: (a) Can a normal force be horizontal? (b) Can a normal force be directed vertically downward? (c) Consider a tennis ball in contact with a stationary floor and with nothing else. Can the normal force be different in magnitude from the gravitational force exerted on the ball? (d) Can the force exerted by the floor on the ball be different in magnitude from the force the ball exerts on the floor?
The helicopter view in Fig. P3.15 shows two people pulling on a stubborn mule. The person on the right pulls with a force F1 of magnitude 120 X and direction of 1 = 60.0. The person on the left pulls with a force F2 of magnitude 80.0 N and direction of 2 = 75.0. Find (a) the single force that is equivalent to the two forces shown and (b) the force that a third person would have to exert on the mule to make the resultant force equal to zero. The forces are measured in units of newtons (symbolized N). Figure P3.15
Give reasons for the answers to each of the following questions: (a) Clan a normal force be horizontal? (b) Can a normal force be directed vertically downward? (c) Consider a tennis ball in contact with a stationary floor and with nothing else. Can the normal force be different in magnitude from the gravitational force exerted on the ball? (d) Can the force exerted by the floor on the hall be different in magnitude from the force the ball exerts on the floor?
(a) What is the minimum force of friction required to hold the system of Figure P4.74 in equilibrium? (b) What coefficient of static friction between the 100.-N block and the table ensures equilibrium? (c) If the coefficient of kinetic friction between the 100.-N block and the table is 0.250, what hanging weight should replace the 50.0-N weight to allow the system to move at a constant speed once it is set in motion? Figure P4.74
In the figures, the masses are hung from an elevator ceiling. Assume the velocity of the elevator is constant. Find the tensions in the ropes (in N) for each case. Note that θ1 = 37.0°, θ2 = 53.0°, θ3 = 60.0°, m1 = 5.00 kg, and m2= 9.00 kg. (Due to the nature of this problem, do not use rounded intermediate values in your calculations A) look at attached IMG-5878 T1= T2= T3= B) look at attached IMG-5879 T1= T2= T3=
A block with a mass of m = 46 kg rests on a frictionless surface and is subject to two forces acting on it. The first force is directed in the negative x-direction with a magnitude of F1 = 10.5 N. The second has a magnitude of F2 = 23.5 N and acts on the body at an angle θ = 23° measured from horizontal, as shown. a) Write an expression for the component of net force, Fnet,x, in the x-direction, in terms of the variables given in the problem statement. b)Write an expression for the magnitude of the normal force, FN, acting on the block, in terms of F2 and the other variables of the problem. Assume that the surface it rests on is rigid. c)Find the block's acceleration in the x-direction, ax, in meters per second squared.
A block with a mass of m = 46 kg rests on a frictionless surface and is subject to two forces acting on it. The first force is directed in the negative x-direction with a magnitude of F1 = 10.5 N. The second has a magnitude of F2 = 23.5 N and acts on the body at an angle θ = 23° measured from horizontal, as shown. a)Write an expression for the component of net force, Fnet,x, in the x-direction, in terms of the variables given in the problem statement. b)Write an expression for the magnitude of the normal force, FN, acting on the block, in terms of F2 and the other variables of the problem. Assume that the surface it rests on is rigid.
A block of mass m1 = 38.4 kg on a horizontal surface is connected to a mass m2 = 15.2 kg that hangs vertically as shown in the figure below. The two blocks are connected by a string of negligible mass passing over a frictionless pulley. Assume that the horizontal surface is smooth. a) What is the acceleration (in m/s2) of the hanging mass? (Enter the magnitude only.) b) Determine the tension (in N) in the cord. (Enter the magnitude only.)