A 9-bit asynchronous counter has a 128-kHz clock signal applied. (i) What is the MOD number of this counter? MOD number = (ii) What will be the frequency at the MSB output? fmsb (iii) Assume that the counter starts at zero. What will be the count after 635 input pulses? After 635 input pulse, Count =

A 9-bit asynchronous counter has a 128-kHz clock signal applied. (i) What is the MOD number of this counter? MOD number = (ii) What will be the frequency at the MSB output? fmsb (iii) Assume that the counter starts at zero. What will be the count after 635 input pulses? After 635 input pulse, Count =

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

What is an MSDS?
A 9 bit asynchronous counter has a 128 - kHz clock signal applied. i) What the mod Number of this counter ? ii) What will be the frequency at the MSB output ? iii) Assume that the counter starts at zero.What will be the count after 6.15 input pulse?
2.Assuming the processor frequency is 20 MHz, find the highest square wave frequency that can be generated using Timer0 in 16-bit mode. (Calculations only, no code needed).
A)What will be the frequency at C if the clock is 320 kHz? B) What is the modulo of the circuit? C) What is the output (in binary) after 737 pulses?
A 16-bit successive approximation ADC is to be designed to operate at 50,000 conversions/second. What is the clock frequency? How rapidly mustthe unknown and reference voltage switches change state if the switch timing delay is to be equivalent to less than 0.1 LSB time?
A frequency counter is gated on for 10 ms and counts 540 pulses from a periodic input signal . What is the input frequency? a) If the gate time is changed to 100 ms , approximately how many counts would you expect from the same source during the gate time? b) In what way does the change in the gate time affect the resolution?
6.) Select all the 8088 input signals that can cause the microprocessor to take an interrupt. a.) OSC b.) INTA c.) NMI d.) READY e.) INTR f.) IRQ 7.) Given the 8088 instruction "INT nn", how many possible types of interrupts are there for the 8088? a.) 2 b.) 4 c.) 8 d.) 256
Explain each component of the block diagram of a frequency counter. - Input: - Accurate time-base / clock: - Decade dividers and flip-flop: - Gate: - Counter/ latch: - Display:
A voice frequency channel, a signal voltage is 40mV and noise voltage is 40fV.What is the maximum data rate that can be transmitted if parameter resistances are equal?
Write a Verilog code with testbench for 16-bit up/down counter with synchronous reset and synchronous up/down.If up/down is set the counter is up counter and if it is not set, the counter is a down counter. submit the module code, testbench code, and the simulation results. PLEASE EXECUTE CODE IN VERILOG
Assuming the processor frequency is 20 MHz, find the lowest square wave frequencythat can be generated using Timer0 in 16-bit mode
design and draw the full circuit diagram for the control circuit for the pc register