a) b) Obtain the frequency response H(w) of h(t) and draw magnitude spectrum. Find the Fourier Transform of the input x(t) = cos(5t) + 1 Find the output y(t) for the given system h(t) and input x(t) using Fourier Transform methods. If y(t) is sampled with sampling period Ts=1s, find y[n], compute DTFT of y[n]. d)

a) b) Obtain the frequency response H(w) of h(t) and draw magnitude spectrum. Find the Fourier Transform of the input x(t) = cos(5t) + 1 Find the output y(t) for the given system h(t) and input x(t) using Fourier Transform methods. If y(t) is sampled with sampling period Ts=1s, find y[n], compute DTFT of y[n]. d)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

5) The message signal m (t) = 2 cos (400 π t) + 4 cos(500 π t) modulates a carrier signal c(t) = 50 cos (8000π t), using double-sideband dual-sideband modulation with carrier Suprinda (DSB-SC) A/ Find the expression in the time domain B/ Find and plot the Fourier transform of the signal C/ Determine the bandwidth of the signal
If x[n] is input to a discrete time LTI system with impulse response h[n], find the Fourier series coefficients for the output y[n], where in the image
Let x(t) = sin^2(2pit), a periodic signal of fundamental period T0 = 1, and y(t) = |sin(2pit)| also periodic of the same fundamental period (a) A trigonometric identity gives that x(t) = 0.5[1-cos(4pit)]. Use this result to find its complex exponential Fourier series (b) Use the Laplace transform to find the Fourier series of y(t) (c) Are x(t) and y(t) identical? Explain. (d) Indicate how you would use an ideal low-pass filter to get a dc source from x(t) and y(t). Indicate the bandwidth and magnitude of the filters. Which of these two signals is used for generating full-waved rectified dc source?
Discrete-time x[n]=[1 6 2 7 8 3] Let the N=8 point discrete Fourier transform (DFT) be denoted by X[k]. ( x[n] ↔ X[k] )
x(0)=4, x(1)=3, x(2)=2, x(3)=1, x(4)=0, x(5)=0 give as, x(n) series ( 0≥ ? ≥ 5 ). a) calculate x(k) with discrete fourier transform coefficients (every calculation step must be given)
Find the Fourier transform x1(jw) and x2(?^(jw)) of the signals given below.a) x1(t) = cos(3t) . cos(8t)b) x2[n] = (3)n u[−n]
The following finite digital signal x[n] was acquired during sampling. The samples outside of the finite bounds of the given signal are x[n] = [0.5,-0.7,0.3,-0.2,1.5] a. Write the expression for the Discrete Fourier Transform (DFT) of the given signal as a function of discrete frequency Be sure to expand the summation over all n, but you DO NOT have to substitute the k values. Simply state what the k values are. You DO NOT have to compute the actual values of b. Compute the magnitude of the DC component of the given signal using the appropriate k value and X(k) determined in (a).
The x (t) sign applied to the input of a linear time invariant continuous time system and the system unit impulse response h (t) are given below.a) Calculate the Fourier transform ? () 'of the signal at the system output.
Find the fourier transform of cos(2πf0t + θ) ?
a. Show that 2-D discrete Fourier Transform of a M × N digital image is periodic.That is, you must prove that F(u + M, v + N) = F(u, v). b. Suggest two methods to bring the frequency origin of a discrete Fourier Transform of an image to the center ofthe 2-D array of frequency plane.
The Fourier transform of a continuous-time signal x(t) is denoted by X(ω). Apply CTFT properties to obtain the Fourier Transform of x(3t+7).
Find the inverse fourier transform of rect[(2πf − 10)/2π] ?