*3.101 A block of volume 0.025 m³ is allowed to sink in water as shown. A circular rod 5 m long and 20 cm² in cross- section is attached to the weight and also to the wall. If the rod mass is 1.25 kg and the rod makes an angle of 12 degrees with the horizontal at equilibrium, what is the mass of the block? 0.25 m 5 m T0 = 12° M ¥ = 0.025 m³3 Р3.101

*3.101 A block of volume 0.025 m³ is allowed to sink in water as shown. A circular rod 5 m long and 20 cm² in cross- section is attached to the weight and also to the wall. If the rod mass is 1.25 kg and the rod makes an angle of 12 degrees with the horizontal at equilibrium, what is the mass of the block? 0.25 m 5 m T0 = 12° M ¥ = 0.025 m³3 Р3.101

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Piston A has a cross-section of 1,200 cm2 while that of B is 800 cm2. B is higher than A by 200cm. If the intervening passages are filled with oil and a force of PB=4.6kn is acting on B. What must be the pressure in N/m2 exerted at A?
A glass-walled fish tank is 2 ft wide by 6 ft long by 3ft deep. When the water (y = 62.4 lb /ft^3) in the tank is 2.5 ft deep, determine the magnitude of the resultant force R exerted on a 2- by 3-ft end plate by the water pressure and the distance from the water surface to the center of pressure.
A gate rotates at point A and releases water when the water's depth, d, exceeds a certain value. The gate's width (perpendicular to the image) is b = 2.95 ft, the water's depth is d = 4.82 ft, and point A is located at h = 2.41 ft. a) What is F, the magnitude of the horizontal force exerted on the gate by the water? The water's specific weight is γw=62.4lb/ft3. b) What are Ax and Bx, the horizontal reaction forces at points A and B that act on the gate from Part A. c) What is dmax, the water's maximum depth before the pressure causes the gate from part A to open?
A gate AB 4 ft long and 2 ft wide is held in position shown due to the spring whose constant is 96.0 Ibf/in. The spring is located compressed 1.5 ft in such a way as to keep the gate in equilibrium. Assume that on the gate (which moves through a circular sector BD as shown in Fig. figure), the force due to the spring is always horizontal. Determine the height d of the water.
Consider the gate shown The gate has a width of 1 m. ρw = 1.0 Mg/m^3. Suppose that a = 2.5 m, b = 1.5 m, c = 1.35 m. Determine the magnitude of the resultant force acting on the gate ABC due to hydrostatic pressure.
An open cylinder tank, D= 1.0m, h=1.5m, contain water at depth 1.0m. If this tank rotate about its central vertical axis. Determine the angular velocity without falling water from its open end
Find a) the total force on gate AB in KN and b) the position of the center of pressure in m with respect to the bottom of the pond. Assume that the gate is 8 feet wide, that 1ft = 0.3048m, and that 1 psi = 6897.1 Pa. Relative density salt water 1.025.
An open horizontal tank 3 m high, 3.5 m wide and 6 m long is initially filled at 2 m of water. a. Determine the required acceleration in m/s2 so that no water will be spilled? b. Determine the required acceleration m/s2 so that 1/3 of the initial volume of water will be spilled. c. Determine the remaining volume in cu.m. if it accelerated at 7 m/s^2. d. Determine the minimum hydrostatic force in kN at the side of the tank if 2/3 of the initial volume will be spilled. e. Determine the maximum hydrostatic force in kN at the side of the tank if it accelerates at 3 m/s^2
For the tank of water shown below, the radius of the circular surface is R=1.0 m, h=1.0m, and the length of the tank is w=2.0 m. Determine (1) the correct expression of the area magnitude whose volume weight is equivalent to the vertical force exerted on the whole curved surfaces_________
The sluice gate shown is a circular arc of radius 6m and angle B=50o. The water level behind the gate flushes to the gate’s top most edge. Knowing that the length of the gate is 5m (dimension perpendicular to the paper), determine the vertical component of the hydrostatic force acting on the gate. a) 84.73kN b) 97.65kN c) 63.45 kN d) 94.12kN e) None
How do you find the external forces' resultant?
A U-tube differential manometer is connected to two pipes at A and B. Pipe A Contains oil of density 1400 Kg/m3 and pipe B is carrying fluid of density 850 Kg/m3. If the pressure at point A is 195 kN/m2. Find the pressure at point B for the following data h1=11 cm, h2=7.5 cm and h3=23.5 cm. The specific gravity of mercury is13.6?