A block is resting on a wooden plank. There is a hinge on one end of the plank which allows the other end to be lifted to create an angle, θ, with respect to the horizontal as shown in the figure. The coefficient of static friction between the block and the plank is μs. If a student measures that the block begins to move at an angle of θ = 20.5°, what is the numerical value of the coefficient of static friction, μs?

A block is resting on a wooden plank. There is a hinge on one end of the plank which allows the other end to be lifted to create an angle, θ, with respect to the horizontal as shown in the figure. The coefficient of static friction between the block and the plank is μs. If a student measures that the block begins to move at an angle of θ = 20.5°, what is the numerical value of the coefficient of static friction, μs?

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.50P: The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the...

See similar textbooks

Similar questions

The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
A 40lb ladder 12ft long leans against the wall making an angle of 30-degree with the wall. When a 190lbf man reached a point 8ft from the lower end, the ladder is just about to slip. Calculate the coefficient of friction between the ladder and the floor. Note: the coefficient of friction between the ladder and the wall is 0.20
A 30 KN of force at one end just supports a weight of 30,000 KN load at the other end. If the rope is run three times around a circular post, what is the coefficient of friction between the rope and the post? How to get the final answer 0.366?
A ladder of length 5 m is resting against a smooth wall, its point of contact being just below a first floor window. The bottom of the ladder rests on the ground and the coefficient of friction between the ladder and the ground is 0.3. A person of mass 75 kg climbs the ladder, which has a mass of 4 kg. The bottom of the ladder is at the point of slipping, outward from the wall, just as the person reaches the mid-point of the ladder’s length. Draw a free body diagram of the ladder and calculate the maximum frictional force opposing the slipping motion. In addition, determine the angle of inclination (θ) of the ladder, when the person is at the mid-point and the ladder is on the verge of slipping.
One end of a uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle ? with the stick. The coefficient of static friction between the end of the meter stick and the wall is us =0.40. B. A block of the same weight as the meter stick is suspended from the stick, as shown, at a distance x from the wall. Assume that angle ? = 15° in this problem. What is the minimum value of x for which the stick will remain in equilibrium? C. When angle ? = 15°, how large must the coefficient of static friction be so that the block can be attached 0.10 m from the left end of the stick without causing it to slip?
A box rests on a horizontal plane. The plane is slowly tilted so that the angle between the surface and the horizontal increases to 20 degrees, at which point the box begins to slip. what is the coefficient of static friction between the box and the surface to 2 s.f.?
A 30 KN of force at one end just supports a weight of 30,000 KN load at the other end. If the rope is run three times around a circular post, what is the coefficient of friction between the rope and the post?
The winch in the figure is used to move the 135kg uniform log. The coefficient of static friction between the log and the plane is 0.40. Which of the following most nearly gives the value of T for impending tipping?
A 75 N force, inclined at an angle a = 45° as shown in Figure 3.5, pulls a 100 N block. The coefficient of static friction between the block and the floor is 1.3, and the coefficient of kinetic friction is 1.1. Determine the friction force between the block and the floor.
A)What force F is needed to get the 300kg block shown in the figure below to move to the right? (b) What is the frictional force developed between the two blocks in N? (c) What is the frictional force developed between the 300kg block and the ground surface in N? The coefficient of static friction for all surfaces is 0.3. The angle, theta=100 The force F = N The frictional force between the two blocks = The frictional force between the 300kg block and the ground=
The two wedges are stacked as shown in figure 1. a.) What is the total reaction at the wall if the coefficient of friction between AB is 0.1 b.) The coefficient of friction between AC and BD is 0.2. c.) How many contact surfaces in the Figure? d.) What is the angle of friction at AC in the figure?
A block whose weight is 40 N rests on a horizontal surface. The coefficient of static friction between the block and the surface is 0.50. A string is attached to the block. The string is pulled horizontally with a force of 15 N. Which one of the following statements is correct? The magnitude of the force of friction on the block is 5 N. The magnitude of the force of friction on the block is 15 N. The force of friction cannot be determined because the coefficient of kinetic friction is not given. The magnitude of the force of friction on the block is 20 N. The force of friction cannot be determined because the normal force of the surface on the block is not known. 2. A block is sliding at constant speed down a ramp. Decide whether each of the following statements is true or false. (a) The net work done on the block as it slides equals zero. True or False (b) The normal force does zero work on the block as it slides. True or False (c) The friction force does positive…