A book of mass 7 kg rests on a plank. You tilt one end of the plank and slowly increase the angle of the tilt. The coefficient of static friction between the book and the plank is 0.30. What is the maximum angle of tilt for which the book will remain stationary and not slide down the plank?

A book of mass 7 kg rests on a plank. You tilt one end of the plank and slowly increase the angle of the tilt. The coefficient of static friction between the book and the plank is 0.30. What is the maximum angle of tilt for which the book will remain stationary and not slide down the plank?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter6: Applications Of Newton’s Laws Of Motion

Section: Chapter Questions

Problem 21PQ

See similar textbooks

Similar questions

Why is the following situation impossible? Your 3.80-kg physics book is placed next to you on the horizontal seat of your car. The coefficient of static friction between the book and the seat is 0.650, and the coefficient of kinetic friction is 0.550. You are traveling forward at 72.0 km/h and brake to a stop with constant acceleration over a distance of 30.0 m. Your physics book remains on the seat rather than sliding forward onto the floor.
(a) What is the minimum force of friction required to hold the system of Figure P4.74 in equilibrium? (b) What coefficient of static friction between the 100.-N block and the table ensures equilibrium? (c) If the coefficient of kinetic friction between the 100.-N block and the table is 0.250, what hanging weight should replace the 50.0-N weight to allow the system to move at a constant speed once it is set in motion? Figure P4.74
A block of ice (m = 15.0 kg) with an attached rope is at rest on a frictionless surface. You pull the block with a horizontal force of 95.0 N for 1.54 s. a. Determine the magnitude of each force acting on the block of ice while you are pulling. b. With what speed is the ice moving after you are finished pulling? Repeat Problem 71, but this time you pull on the block at an angle of 20.0.
A crate remains stationary after it has been placed on a ramp inclined at an angle with the horizontal. Which of the following statements must be true about the magnitude of the frictional force that acts on the crate? (a) It is larger than the weight of the crate. (b) It is at least equal to the weight of the crate. (c) It is equal to sn. (d) It is greater than the component of the gravitational force acting down the ramp. (e) It is equal to the component of the gravitational force acting down the ramp.
A 4.00 kg box sits atop a 10.0 kg box on a horizontal table. The coefficient of kinetic friction between the two boxes and the lower box and table is 0.600, while the coefficient of static frction between these same surfaces is 0.800. A horizontal pull of 150.0 N to the right is exerted on the lower box, and the boxes move together. What is the friction force on the upper box?
A small box is held in place against a rough vertical wall by someone pushing on it with a force directed upward at 26 ∘∘above the horizontal. The coefficients of static and kinetic friction between the box and wall are 0.40 and 0.30, respectively. The box slides down unless the applied force has magnitude 29 N . What is the mass of the box?
A 100 kg block is at rest on a flat floor with a coefficient of static friction 0.62. A horizontal force of 3.7 N is applied to the block, but it does not budge. What is the magnitude of the frictional force on the block applied?
The static friction coefficient between the block and the inclined surface is 0.2. What is the minimum force that should be applied to the block perpendicular the surface in order to prevent the block from sliding down?
The coefficient of static friction between a block and a horizontal floor is 0.47, while the coefficient of kinetic friction is 0.14. The mass of the block is 4.2 kg. If a horizontal force is slowly increased until it is barely enough to make the block start moving, what is the net force on the block the instant that it starts to slide?
The two blocks (m= 16 kg and M = 88 kg) are not attached to each other.The coefficient of static friction between the blocks is ms =0.38, but the surface beneath the larger block is frictionless. What is the minimum magnitude of the horizontal force required to keep the smaller block from slipping down the larger block?
A 1600 kg truck is sitting stationary on a 20 degree hill. How large is the friction force that holds the truck in place, and how large is the normal force from the hill on the truck?
A small box is held in place against a rough wall by someone pushing on it with a force directed upward at an angle of 260 above the horizontal. The coefficient of static and kinetic friction between the box and the wall are 0.40 and 0.30, respectively. The box slides down unless the applied force has a magnitude of 13 N. What is the mass of the box?