a) Calculate the pressure (in atm) 1.8 m below the surface of the container. Show your solution in detail. b) What will happen to the pressure if the container is tightly sealed? Explain the answer in your own words.

Q: Propane is burned in a furnace according to the following chemical reaction.   C3H8+5O2→3CO2+4H2O…

A: Propane is burned with air.

Q: Ethylene is the largest single chemical commodity in the world. It is the precursor for…

A: Given reaction for cracking ethane is- C2H6→C2H4+H2 The temperature required for cracking is…

Q: concentration of P

A:

Q: space-time and space-velocity

A:

Q: Choose the correct option: 8. Considering the physical and chemical properties, abundance, and even…

A:

Q: (please give clear handwritten answer) Starting from the general Ergun equation, derive the…

A: Given reaction is- A+B→C+D It is an isothermal gas phase elementary reaction.  Pressure drop, y=PP0…

Q: Convert a humidity ratio of 0.010 lbm H2O/lbm dry air into units of kg H2O/kg dry air. 0.010 0.0045…

A: Given that humidity =0.010lbm H2Olbm dry air

Q: Find the Orsat analysis of the burner gas when pure sulphur is burned with 20% excess air. Of the…

A:

Q: Why does the fluid drop in the fluid level measurement experiment when the pump is turned off?

A: In a typical fluid level measurement experiment, the pump is used to recirculate the fluid in a…

Q: A perfectly insulated, concentric tube countercurrent heat exchanger is used to cool lubricating oil…

A:

Q: The cumene process is used to convert benzene in the presence of oxygen and acetone via the…

A: Given reaction is- C6H6 + C3H6 + O2 → C6H5OH + C3H6O The molar ratio of benzene to propene in the…

Q: Benzene is flowing through a pipeline (4.0 cm inside diameter) at a rate of 175 kmol/h.

A:

Q: Consider a 1000 m^2 impoundment, 1 m deep. Benzene is present at 100 micrograms/L when the wind…

A: Given that, Area of impoundment, A=1000 m2  Depth, h=1 m Speed of wind over surface, u=2 m/s…

Q: The purge gases from a synthetic ammonia plant contain 4% ammonia by volume and 96% hydrogen,…

A: Given, The pressure, P = 5 atm×760 torr1 atm = 3800 torr The temperature, T = 68 °F The mole flux of…

Q: (2.17) A rectangular steel (k = 58.7 W/m K) fin 25 mm thick and 150 mm long is attached to a wall…

A: Given that- k=58.7 W/m.K Thickness of fin, t=25 mm = 0.025 m Length of fin, l=150 mm=0.15 m…

Q: How did you assume the coefficient of discharge Cd? Did you get it from a table?    Thx

A: Orifice meter is a flow measuring device.

Q: What is the weight percent of 1-pentene in a mixture of 1-pentene(SG=0.626) and octane (SG=0.703)…

A: Specific gravity of the mixture = 0.65 Specific gravity of the 1-pentene = 0.626 Specific gravity of…

Q: 5. (a) State the technique used to separate Crude Oil into its various fractions (b) Explain how the…

A: To answer Q 5 (a), (b) and (c)

Q: After crude oil is found what happens to it?

A: Crude oil broadly undergoes 3 processes before it reaches consumers. 1) Upstream 2) Midstream 3)…

Q: A coaxial tube exchanger is operated under the following conditions. Tout K Cold fluid Hot fluid m…

A: Given, The mass flow rate of cold fluid, m˙c = 0.125 kg/s The mass flow rate of hot fluid, m˙h =…

Q: 1. A triple effect evaporator system connected for backward feeding is used to concentrate a…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: Benzene is held at 425 K. Find the fugacity and fugacity coefficient at: a.) Psat b.) 2 bar c.) 12…

A:

Q: find the value of delta H in j/mol

A: Enthalpy change of propane gas is to be calculated.

Q: As part of a process to fabricate materials with ordered pore arrays, the diffusion‐limited solvent…

A: No of cylindrical pores = 16 Diameter of each pore = 0.1 cm Depth of each pore = 0.5 cm Maximum…

Q: A gas-phase reaction of the type like 2A +4B→2R is conducted in a continuous system at a constant…

A:

Q: Consider the binary mixture of ethyl ethanoate (1) and n-heptane(2). The following are the…

A: (1) Given, The saturation pressure of ethyl ethanoate, P1sat = 79.8 kPa The saturation pressure of…

Q: 1. Natural gas usually contains a mixture of methane and ethane. Methane (CH4) and ethane (C₂H6)…

A: Given, The pressure of stream A, P = 5 atm The temperature of stream A, T = 400°C = 400+273.15 K =…

Q: D2. We are separating a mixture of propylene, propane, and isobutane in a distillation column with a…

A: Fractional recovery of propylene in distillate = 0.999 Fractional recovery of propane in bottom =…

Q: A reversible liquid-phase reaction, 2 A B, is to be run in one or more adiabatic reactors. The rate…

A: A reversible liquid phase reaction is carried out in a non-isothermal constant stirred tank reactor.

Q: Can you break down the chemical pathway for the hydrolysis of nitrile gloves (butadiene and…

A: Nitrile gloves are made from a synthetic compound blend of butadiene and acrylonitrile. When nitrile…

Q: 5. The Haber process to manufacture ammonia is shown in the diagram below. The following chemical…

A: Block flow diagram of Haber process is given

Q: A double effect evaporator is used to concentrate an 18% CuSO4 solution. At the end of evaporation,…

A: Given that composition of M1 = 18 % CuSO4 and 82 % H2O   M4 = 0.5M2 M5 = 26000 Kg/hr composition of…

Q: What si the difference between the Cavendish banana fiber and abaca fiber production? In terms of:

A: Introduction Abaca fiber (also called called Manila hemp) is extracted from the leaf sheath around…

Q: A closed, non-conducting, horizontal cylinder is fitted with a non-conducting frictionless, floating…

A: Given that- For a closed system divided into sections A and B.  Mass of air in sections A and B are…

Q: 5. The Haber process to manufacture ammonia is shown in the diagram below. The following chemical…

A: Process flow diagram of Haber process is given as as follows: Now, the given reaction is-…

Q: A plug flow reactor is currently producing an effluent with C/Co= 0.1. The industry would like to…

A: Assumptions: 1. Configuration of CFSTRs are not given so we will assume that CFSTRs are added in…

Q: What material of storage tank can be suitable of storing methylene diphenyl diisocyanate? is…

A: The selection of material of construction is primary depends on the physical and chemical properties…

Q: 13.4 Use the Dülong formula to calculate the gross and net heating values of coal having the…

A:

Q: The first step in the reaction of Alka-Seltzer with stomach acid consists of one mole of sodium…

A: Write the reaction as follows: NaHCO3 + HCl → H2CO3 + NaCl   Given, The moles of NaHCO3 is 3 mol The…

Q: What properties of the particulate catalyst and process conditions can be changed to enhance the…

A: We need to state the properties of particulate catalyst and process conditions  which can be changed…

Q: A forward feed triple effect evaporator is used to fed 13608 kg/hr of NaOH solution containing 10…

A: Given that- For a forward triple effect evaporator  Feed, F=13608 kg/hr  The feed has- NaOH= 10 wt%=…

Q: Organic compounds that contain large proportions of nitrogen and oxygen tend to be unstable and are…

A: Given reaction- C2(NO2)6→2NO2+4NO+2CO2  The reaction is first order with respect to C2(NO2)6. Rate…

Q: The following data shows the liquid-vapor phase boundary of methane. T(K) 100 190 108 110 112 114…

A: Write the Clausuis Clapeyron equation as follows: lnP = -∆HvapR1T + C   ......1 Here, P is the vapor…

Q: The following data shows the liquid-vapor phase boundary of methane. T/K 100 108 110 112 114 120…

A:

Q: 5.11. The data given below were obtained for the reaction A → B using a laboratory-scale reaction…

A:

Q: Calculate the following for the Given x₁ = 0.33 and T=100°C, find y₁ and P. Y₁ = P=…

A: given = X1 = 0.33 T = 100^c to find = Y1 and P WKT, from Raoult's Law Here,  is the total pressure,…

Q: Choose the correct option: 7. Which of the following metals best transfers heat? a) Gold b) Copper…

A: It is required to determine the metals that transfers the heat best.

Q: Estimate the fugacity of n-pentane at its normal-boiling-point temperature (36°C) and 200 bar.  Take…

A: Given, The temperature of n-pentane, T = 36 °C = 36+273 K = 309 K The saturation pressure, Psat =…

Q: In the process sketched in Figure P6.3.18, Na2CO 3is produced by the reaction Na2S + CaCO 3 → Na2 CO…

A: Process flow diagram for a process consisting multiple unit is given.

Q: Denise, one of your coworkers at a biotech company is leading a project to improve the stability and…

A: Given information The new enzyme degrades(when free in solution) with half life of 10 days. The…