Answered: A carrier wave of peak voltage 12 V is…

A carrier wave of peak voltage 12 V is used to transmit a message signal. What should be the peak voltage of the modulating signal in order to have a modulation index of 75%?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 69P: An LC circuit in an AM tuner (in a car stereo) uses a coil with an inductance of 2.5 mH and a...

See similar textbooks

Related questions

Q: The ideal condition of AM is when the modulation index is equal to one hundred. True O False The…

A: Amplitude Modulation is a commonly used transmission technique, by which the signal containing…

Q: What capacitance is needed in series with an 800−µH inductor to form a circuit that radiates a…

A: Given: L = 800 µH = 800 x 10-6 H = 8 x 10-4 H wavelength = 196 m

Q: The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a…

A: Given: AM band ranges between 500 Hz - 1600 Hz That is, fmin=500 kHz=500×10-3 Hz & fmax=1600…

Q: A message signal of frequency 10 kHz and peak voltage 10 V is used to modulate a carrier of…

A: Given data: A message signal of frequency is, fm = 10 kHz A message peak voltage is, Vm = 10 V A…

Q: A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz).…

Q: An AM radio antenna picks up a 1000 kHz signal with a peak voltage of 5 0 nmV The tuning circuit…

A: Given: Peak Voltage = 5.0 mV=5×10-3V Inductance = 60μH = 60×10-6 H Coil resistance = 0.25 ohms

Q: The instantaneous value of an 800-Hz sine wave current is 5A when t =0.5ms. What is the peak…

Q: In a pure A.C capacitive circuit O Current lags the voltage ,by a phase angle of 30 deg O Current…

A: AC capacitive circuit is given

Q: A carrier wave of peak voltage 12 V is used to transmit a message signal. Calculate the peak voltage…

A: The relation for the modulating index is given by μ = AmAc where, Am is the peak voltage if the…

Q: An FM radio station broadcasts at a frequency of 95.5 MHz. What inductance (in uH) should be paired…

Q: Determine the %modulation of an AM signal if the maximum voltage is 50 V and the minimum voltage is…

Q: A 10 μF capacitor is connected to a 1000 Hz oscillator with a peak emf of 5.0 V. What is the peak…

Q: Calculate the RMS value of the voltage waveform below

Q: If the propagation losses (PEL) for a link that operates at a frequency of 4 GHz are 120dB, when…

A: Initially data given that, When frequency was 4 GHz the propagation losses was 120dB We have to…

Q: A common emitter amplifier has a voltage gain of 50, an input impedance of 100 2 and an output…

Q: An oscillating LC circuit, with L = 1.5 mH and C = 0.01 µF, stores a maximum energy of 10 uJ. al…

Q: What is the RMS noise voltage associated with a 10 Q resistor at room temperature when the system…

A: Mean square noise voltage is given by- vn2¯=4kBTRhere,kB is Boltzmann'constant=4.138×10-23 J/KT =…

Q: An AM signal in which the carrier is modulated 70% contains 1500 W at the carrier frequency.…

Q: The capacitive reactance of a capacitor at 60.0 Hz is 105 Ω. Atwhat frequency is its capacitive…

A: Given values: Capacitive reactance, XC1=105 Ω Frequency, f1=60.0 Hz Capacitive reactance, XC2=72.5 Ω…

Q: CONNECTING A TRANSMITTER WITH AN IMPEDANCE ANTENNA (ZR=300 OHMS) BY A TRANSMISSION LİNE WITH ITS…

A: Given: Impedance of antenna τb= 300Ω…

Q: A certain FM radio tuning circuit has a fixed capacitor C=810 pFTuning is done by a variable…

A: The tuning frequency can be given as, Here, L and C represent the inductor’s inductance and the…

Q: A carrier signal given by (cos2Tt105t) volt is AM modulation by the message signal given by…

A: The correct option for the following Ques is Option B Ps= 64, Pc = 128, bandwidth = 2khz, and u =…

Q: The current amplitude in a pure inductor in a radio receiver is to be 250 µA when the voltage…

Q: In the Maxwell bridge shown in Figure2, let the fixed-value bridge components have the following…

Q: For what absolute value of the phase angle does a source deliver 74 % of the maximum possible power…

A: The expression for the phase angle is,

Q: What inductance must be connected to a 20 pF capacitor in an oscillator capable of generating 590 nm…

Q: If the peak value of a 1.5-kHz audio oscillator is 25V, what is the instantaneous voltage when ϴ =…

A: ϴ = 215 degree Vmax=25 V

Q: A 4G phone has a data receiver with an inductance of 0.3 μH. When the capacitance is tuned to 2e-13…

A: Write the given data. L=0.3×10-6 HC=2×10-13 F

Q: An LC circuit containing a 2.00-H inductor oscillates at such a frequency that it radiates at a…

A: Given data: Inductance of inductor is, L=2.00 H. Wavelength of radiation is, λ=1.00 m.

Q: The input power to a 3-phase load is measured as 12KW. If the line voltage and power factor of the…

Q: The AM band extends from approximately 500. kHz to1 600. kHz. If a 2.0 - µH inductor is used in a…

Q: a carrier signal vc(t) = 10 cos(2 pi 3000t) Volts is modulated by a sine wave vm(t) =7 cos(2 pi…

A: Modulation index = Em /Ec

Question

A carrier wave of peak voltage 12 V is used to transmit a message signal. What should be the peak voltage of the modulating signal in order to have a modulation index of 75%?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An ac source of voltage amplitude 10 V delivers electric energy at a rate of 0.80 W when its current output is 2.5 A. What is the phase angle between the emf and the current?
The voltage across a parallel-plate capacitor with area A=800cm2 and separation d = 2 mm varies sinusoidally as V = (15 mV) cos (150t), where t is in seconds. Find the displacement current between the plates.
The AM band extends from approximately 500. kHz to1 600. kHz. If a 2.0 - µH inductor is used in a tuning circuit fora radio, what are the extremes that a capacitor must reach tocover the complete band of frequencies?
A message signal of frequency 10 kHz and peak voltage 10 V is used to modulate a carrier of frequency 1 MHz and peak voltage 20 V. Determine (i) the modulation index, (ii) the side bands produced.
A station is given a carrier frequency of 88 kHz. Having a modulating frequency of 12 kHz, compute for the upper and lower sidebands of the station.
An FM radio station broadcasts at a frequency of 95.5 MHz. What inductance (in uH) should be paired with a 13.0 pF capacitor to build a receiver circuit for this station?
For what absolute value of the phase angle does a source deliver 74 % of the maximum possible power to an RLC circuit?
The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a tuning circuit for a radio, what are the extremes that a capacitor must reach in order to cover the complete band of frequencies? Cmax = nF Cmin = n
A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz). If its LC circuit has an effective inductance of 200 µH, what must be the range of its variable capacitor?
For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 500us/cm and the volt/cm switch is on 5V/cm. The width of one complete cycle is 4cm and peak to peak height is 5cm. Find for the waveform a) the frequency, b) the peak to peak voltage, c) the amplitude, and d) the r.m.s value
An RLC circuit is driven at its resonance frequency. Is its voltage ahead of, behind, or in phase with the current?