A certain half-reaction has a standard reduction potential Ered =-0.96 V. An engineer proposes using this half-reaction at the cathode of a galvanic cell that must provide at least 0.90 V of electrical power. The cell will operate under standard conditions. Note for advanced students: assume the engineer requires this half-reaction to happen at the cathode of the cell. Is there a minimum standard reduction potential that the half-reaction used at the anode of this cell can have? O yes, there is a minimum. = Ov If so, check the "yes" box and calculate the minimum. Round your answer to 2 decimal places. If there is no lower limit, check the "no" box. O no minimum Is there a maximum standard reduction potential that the half-reaction used at the anode of this cell can have? O yes, there is a maximum. = 0v If so, check the "yes" box and calculate the maximum. Round your answer to 2 decimal places. If there is no upper limit, check the "no" box. O no maximum By using the information in the ALEKS Data tab, write a balanced equation describing a half reaction that could be used at the anode of this cell. Note: write the half reaction as it would actually occur at the anode. 0 red Ered ローロ 00

A certain half-reaction has a standard reduction potential Ered =-0.96 V. An engineer proposes using this half-reaction at the cathode of a galvanic cell that must provide at least 0.90 V of electrical power. The cell will operate under standard conditions. Note for advanced students: assume the engineer requires this half-reaction to happen at the cathode of the cell. Is there a minimum standard reduction potential that the half-reaction used at the anode of this cell can have? O yes, there is a minimum. = Ov If so, check the "yes" box and calculate the minimum. Round your answer to 2 decimal places. If there is no lower limit, check the "no" box. O no minimum Is there a maximum standard reduction potential that the half-reaction used at the anode of this cell can have? O yes, there is a maximum. = 0v If so, check the "yes" box and calculate the maximum. Round your answer to 2 decimal places. If there is no upper limit, check the "no" box. O no maximum By using the information in the ALEKS Data tab, write a balanced equation describing a half reaction that could be used at the anode of this cell. Note: write the half reaction as it would actually occur at the anode. 0 red Ered ローロ 00

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 160MP

See similar textbooks

Similar questions

Consider a galvanic cell for which the anode reaction is 3 Pb(s)Pb2+(1.0102M)+2e and the cathode reaction is VO2+(0.10M)+2H3O+(0.10M)+eV3+(1.0105M)+3H2O(l) The measured cell potential is 0.640 V. Calculate E for the VO2+V3+ half-reaction, usingE(Pb2+Pb) from Appendix E. Calculate the equilibrium constant (K) at 25°C for thereaction Pb(s)+2VO2+(aq)+4H3O+(aq)Pb2+(aq)+2V3+(aq)+6H2O(l)
a Calculate G for the following cell reaction: Tl(s)Tl+(aq)Pb2+(aq)Pb(s) The Gf for Tl+(aq) is 32.4 kJ/mol. b From G, calculate the standard cell potential for the cell reaction and from this, determine the standard potential for Tl2+(aq)+eTl(s).
Consider a galvanic cell based on the following half-reactions: a. What is the standard potential for this cell? b. A nonstandard cell is set up at 25C with [Mg2+] = 1.00 105 M. The cell potential is observed to be 4.01 V. Calculate [Au3+] in this cell.
Consider a voltaic cell in which the following reaction takes place in basic medium at 25°C. 2NO3-(aq)+3S2(aq)+4H2O3S(s)+2NO(g)+8OH(aq) (a) Calculate E°. (b) Write the Nernst equation for the cell E. (c) Calculate E under the following conditions: PNO=0.994atm,ph=13.7,[S2]=0.154M,[NO3-]=0.472M, .
The mass of three different metal electrodes, each from a different galvanic cell, were determined before and after the current generated by the oxidation-reduction reaction in each cell was allowed to flow for a few minutes. The first metal electrode, given the label A, was found to have increased in mass; the second metal electrode, given the label B, did not change in mass; and the third metal electrode, given the label C, was found to have lost mass. Make an educated guess as to which electrodes were active and which were inert electrodes, and which were anode(s) and which were the cathode(s).