A Chromatographic quantitation of Methylene blue have the following data. Calculate the concentration in mM of Methylene blue in the Sample. (answer must have 3 significant figures) SPL 1 STD 1 STD 2 STD 3 Your answer Run Sample 5 mM 10 mM 20 mM Peak Ht 14.213 12.33 19.45 25.97 Peak Area 35,041 31,397 62,805 125,510

A Chromatographic quantitation of Methylene blue have the following data. Calculate the concentration in mM of Methylene blue in the Sample. (answer must have 3 significant figures) SPL 1 STD 1 STD 2 STD 3 Your answer Run Sample 5 mM 10 mM 20 mM Peak Ht 14.213 12.33 19.45 25.97 Peak Area 35,041 31,397 62,805 125,510

Chemical Principles in the Laboratory

11th Edition

ISBN:9781305264434

Author:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Publisher:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Chapter2: Resolution Of Matter Into Pure Substances, I.paper Chromatography

Section: Chapter Questions

Problem 1ASA

See similar textbooks

Similar questions

Determine the concentration of linalool in a highly valued lavender essential oil. The peak areas of a series of standard solutions (calibrations standards) acquired from GC-MS (gas chromatography-mass spectrometry) is presented below. Concentration (mg/L) Peak area 0 201 25 5214 50 14658 75 23647 100 32657 125 42652 150 52478 QUESTION: Calculate the concentration of linalool in yourhighly valued lavender essential oil which returns a peak area of 27235.
Gas chromatography cannot analyze mixtures due to the sensitivity of the instrument. True False
3c. A solution containing 2.50 mM X (analyte) and 1.20 mM S (standard) gave peak areas of 2509 and 7132 respectively, in a chromatographic analysis. Then, 1.00 mL of 6.00 mM S was added to 5.00 mL of unknown X and the mixture was diluted to 10.0 mL. This solution gave peak areas of 4016 and 3138 for X and S, respectively. Calculate i. the response factor for the analyte ii. the concentration of S (mM) in the 10.0 mL of mixed solutioniii. the concentration of X (mM) in the 10.0 mL of mixed solutioniv. the concentration of X in the original unknown solution
A solution with 0.083 7 M X and 0.050 0 M S9 gave areas AX = 423 and AS9 = 372. Then 10.0 mL of 0.05 0 M S9 plus 10.0 mL of unknown were diluted to 25.0 mL. The chromatogram gave AX = 553 and AS9 = 286. Find [X] in the unknown.
Use the following information collected from a SIZE-EXCLUSION CHROMATOGRAPHY experiment to answer the questions below. MW Standards Molecular Weight (kDa) Elution Volume (mL) blue dextran 1000 85 myoglobin 17.2 200 TIM 53.3 178 hemoglobin 62.2 156 IgG 140 122 ATCase 307.9 94 Prepare a graph showing the linear relationship between log function of molecular weight against Ve/Vo. The R2value must be 0.9 or higher. What is the linear equation from the standards given? What is the R2value?
For an analysis of phthalates by GC-MS, the limits of detection and quantitation are 0.55 and 3.56 mg/g, respectively. Based on the results obtained below, how are the 3 samples reported? Sample Concentration (mg/g) A 4.50 B 0.055 C 0.56
In thin-layer chromatography, what is the Rf value of a compound if the solute travels 2.9 cm and the solvent moves 4.5 cm after 5 minutes? Note: Express answers up to TWO decimal places.
A chromatogram from a certain column has a peak with a w1/ 2 of 12 mm and a tr of 650 mm as measured. What is the number of theoretical plates?
Chromatography 1. External Standard Method A. Calculate the regression equation and the R-squared value. B. Calculate the concentration of cocaine found in the blood samples of the presidentiables. Which presidential candidate “reliably” tested positive for cocaine? 2. Internal Standard Method >Calculate the concentration of party drug X in the blood samples of the presidential candidates. >Suppose the LOD for party drug X is 0.200 ppm, which of the presidential candidates “reliably” tested for party drug X?
The following Rf values were computed from a normal phase chromatography experiment. Arrange them from most polar to least polar. I - 0.25 II - 0.84 III - 0.56 IV- 0.67 Group of answer choices II > IV > III > I I > III > IV > II I > II > III > IV IV > II > III > I
1a) Hexane, CH3(CH2)4CH3, is found to have a long retention time when separated from a mixture. A column with a C18 (18-carbon chain) stationary phase and a methanol-water modal phase is used for the separation. Explain why hexane has a long retention time. 1b)You wish to chromatographically seperate a mixtureof the follwing compunds. Which of the two compounds will be most difficult to seperatate from one another? Why?
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.