A circuit has resistance of 20 ohms and a reactance of 30 ohms. What is the power factor of the circuit? a. 0 b. 0.55 c. 0.832 d. 0.99

Q: Calculate the output voltage if V₁ = 1.47V,

A: Operational amplifier- An integrated circuit which amplifies weak electric signals into a strong…

Q: A circuit having a resistance of 20 W and an inductance of 0.5 H is connected suddenly across a 200…

A:

Q: 3. An ON-OFF temperature controller controls a room air conditioner. The bandwidth (OH) is set to 4,…

A:

Q: (B)-ndicate whether the following statements are true or false and correct the faise statements.…

A:

Q: Solve the approximate value of Rc of Figure 44. VCC 12V V=7.6V V = 2.4V V₂ RB 2.2 ΚΩ 2.7 ΚΩ 1.8 ΚΩ…

A: We need to find out collector resistance value for given circuit

Q: Compute the value of the following integral: L (t) cos() 8 (t-1)dt where 8(t) is the unit impulse…

A: In this question,  We need to determine the value of the given function?  We are solving this…

Q: The voltage v(t) = 12 cos(60t+45°) is applied to a 0.1 H inductor. Find the steady state current…

A: In this question we need to find a steady state current through the inductor.

Q: 2. Analyze and determine the Leq for the circuits in Figure 1 (a) and (b). L m L L Lea m ell ell L…

A: In this question we need to find a equivalent inductance of the given circuit

Q: 1. Rearrange the above three equations. 2. Write the set of equations in matrix form (A.x = b) 3.…

A: The required parameters can be calculated by using the mesh analysis of the circuit. The equation…

Q: 2. Form the Y bus of the following data Given table Bus From To 1 2 1 3 4 4 4 123 Resistance in…

A: Given data of resistances and reactances available for all lines between 4 buses. For Y bus…

Q: Qull Find IR through resisto R=2K ohm using dorton's Theroem IR 2.25 5.6 к R www 8m A ≤16√

A: We need to find out current through given resistor by using of Norton Theorm

Q: Q2: In the figure shown find the power of this circuit if R1-3 KQ, R3-3 KQ, R5=5 ΚΩ , R7=0.5 ΚΩ ,…

A:

Q: Q1. Choose the correct answer (Answer any TEN): 1. The convolution of two signals in time domain is…

A: In this question we will write about convolution and pulse modulation... Note :- as per our…

Q: Q5: A 50-W lossless line terminated in a purely resistive load has a voltage standing wave ratio of…

A:

Q: Calculate the oscillation frequency for the BJT Hartley oscillator circuit if LRFC =0.5 mH, L1 = 750…

A: Here we discuss about the oscillation frequency for the BJT Hartley oscillator circuit if LRFC =0.5…

Q: Q3: derive the sensitivity equation for angular displacement capacitive transducer

A:

Q: Compute the value of the following integral: (t) cos() 8 (t-1)dt where 8(t) is the unit impulse…

A:

Q: 16.a. Enclosures housing motor control equipment in a dusty indoor environment where there is danger…

A: Here we discuss the MCQs as given, about motor drives.

Q: A three-phase motor can be made to run backwards by A. connecting a resistor in series with the…

A:

Q: 1) Find the voltage at node A in the given circuit by applying nodal analysis.

A: The node voltage can be calculated by using the nodal analysis. The node equation can be obtained by…

Q: The following circuit is powered by a polyharmonic voltage whose expression is: v(t) = 100+141.sin…

A: Given:V(t)=100+141sin(1000t)+70.7sin(2000t) V(t) contains three frequency voltage, response for each…

Q: Q3-(A)- Indicate whether the following statements are true or false and correct the false statements…

A: The DC Electrical Generator are used to Generate DC voltage output to power a DC load. These are…

Q: An abrupt silicon P-N junction is doped with acceptor concentration, N₁ = 5 x 1016 cm-³ and donor…

A: We need to find out the saturation current for given semiconductor .

Q: D13.5. Determine the wave angles 0m for the first four modes (m = 1, 2, 3, 4) in a parallel-plate…

A: We need to find out the wave propagation angle of given waveguide

Q: at is the net force and its direction that the of the right triangle ABC and a charge at point D…

A: Solution- Net force on point B in vertical direction is,    FBC+FBDsin30° Distance of point B and D…

Q: can you give the feature, advantage and benefit of LWT700 Whirlpool washing machine

A: Here we discuss the feature, advantage and benefit of LWT700 Whirlpool washing machine.

Q: Write down the trigonometric Fourier series representation of the following signal: x(1)₁ JU 0 -T B…

A:

Q: A coil is wound with 500 turns. When a current of 4 A flows the total flux threading the coil is…

A:

Q: Q₁ = Find to and below. V₁ = 2, in The op. Amp. Circuit s' Rf = loks R₁ - 5K^ wn a Vo Ja Rrz 2-5 Ka…

A:

Q: Solve step by step in digital format, please explain each step XXXXXXXX XXXXXXXXXXX XXXXX Determine…

A:

Q: The attached solution is the solution of the same problem from this site. I am confused! Which…

A: Given  Two solutions for the same problem,we need to determine which one is the correct solution.

Q: what is the main deference between photo diode &photo transistor?

A: Photodiode  Phototransistor Definition: It's a PN-junction diode that generates an electric current…

Q: Q4: An angular displacement capacitance transducer use semicircular plated with 13 mm diameter…

A:

Q: Where does Wye-Delta circuit used in industry application? What specific application and explain

A: Given  We need to enumerate where does Wye-Delta circuit is used in industrial application. Please…

Q: Inductive sensors should not be used to detect _______ objects. A. odd-shaped B. fast-moving C.…

A:

Q: 4. A 300 MVA, 20 kV three-phase generator has a sub transient reactance of 20%. The generator…

A:

Q: A JFET phase-shift oscillator having gm = 6000 μS, rd = 36 kΩ, and a feedback resistor R = 12 kΩ is…

A:

Q: Q1:In the figure shown find the current in each resistor. 15 V 292 m 10 V 452 m ли 6Ω m 852

A:

Q: Determine the total resistance. 4k52 W 6 кл RT M 16 кл ≤8k₂

A: In this question we need to find a total equivalent resistance of the given circuit

Q: c) Calculate the input impedance of the circuit illustrated in Figure Q1c without using Miller's…

A:

Q: 1-3. Given a 3-wire NPN inductive sensor, the black wire is to be connected to the ___________, the…

A: Inductive sensors are used to detect items without making physical contact. There are 2-wire and…

Q: Give a standard current signal _____________ and a standard

A: In this question we will write about standard current signal and standard voltage signal....

Q: Given vector fields in rectangular coordinate system: A = zya₂ + 2yray + 3zxa, and B=yza, + 2zzay +…

A: Given: The vector fields in the rectangular coordinate system: A=xyax+ 2yxay + 3zxazB=yzax+…

Q: What are the different types of Insulators, give examples for each type. Compare the glass insulator…

A: Materials can be classified into three categories namely conductors, insulators and semiconductors.…

Q: 5 Which of the following equations gives the output power of a salient-pole synchronous machine ? *…

A: Synchronous machine: The motor that runs at synchronous speed when the magnetic locking established…

Q: AC in D2 D3 D1 D4 LOAD

A:

Q: Explain briefly in one(1) sentence why the rotor speed is always lower than the synchronous speed in…

A: .

Q: solve for the collector saturation current of an emitter stabilized bias circuit with Vcc=18V,…

A: We need to find out saturation current

Q: A two-winding transformer rated at 100 kVA, is connected as an autotransformer to provide 10kV from…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Transform the vector 10a, to spherical coordinates at the point P(x = −3, y = 2, z = 4).

A:

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.