A clay layer 4 m thick rests beneath a deposit of submerged sand 8 m thick. The top of the sand is located 3 m below the surface of a lake. The saturated unit weight of sand is 25 kN/cu.m and of clay 20 kN/cu.m. Determine the total vertical pressure in kPa at mid-height of the clay layer. (Final answer should be rounded-off to two decimal places) 3m Water Sand, 25 KN/m' 8 m 2 m Clay, 20 KN/m 4 m

A clay layer 4 m thick rests beneath a deposit of submerged sand 8 m thick. The top of the sand is located 3 m below the surface of a lake. The saturated unit weight of sand is 25 kN/cu.m and of clay 20 kN/cu.m. Determine the total vertical pressure in kPa at mid-height of the clay layer. (Final answer should be rounded-off to two decimal places) 3m Water Sand, 25 KN/m' 8 m 2 m Clay, 20 KN/m 4 m

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter3: Natural Soil Deposits And Subsoil Exploration

Section: Chapter Questions

Problem 3.4P: Refer to Figure P3.3. Use Eqs. (3.10) and (3.11) to determine the variation of OCR and...

See similar textbooks

Similar questions

A layer of saturated clay 5 m thick is overlain by sand 4.0 m deep. The water table is 3 m below the top surface. The saturated weights of clay and sand are 18 kN/m3 and 20 kN /m3, respectively. Above the water table, the unit weight of sand is 17 kN/m3. Calculate the effective pressure on a horizontal plane at a depth of 9 m below the ground surface. What will be the increase in effective pressure at 9 m, if the soil gets saturated by capillary up to height of 1 m above water table?
P4: A layer of saturated clay 5 m thick is overlain by sand 4.0 m deep. The water table is 3 m below the top surface. The saturated unit weights of clay and sand are 18 kN/m3 and 20 kN/m3 respectively.Above the water table, the unit weight of sand is 17 kN/m3. Calculate the effective pressures on a horizontal plane at a depth of 9 m below the ground surface. What will be the increase in the effective pressure at 9 m if the soil gets saturated by capillary, up to height of I m above the water table?
Estimate the lateral earth pressure at a depth 20 ft (6.1 m) below the ground surface in a loose sand deposit. The wet unit weight of the sand is 115 pcf (19 kN/m3). What would the total lateral pressure be if the water table rose to the ground surface (in psf or kPa)?
The bottom of a river is 9 m below the water surface. Underneath the bottom of the river is a layer of sand having a specific weight of 18 kN/m3. If the recorded pressure at the tunnel located at the bottom of the sand layer is 305 kPa, how thick is the sand layer?
A clay layer 3.66 m thick rests beneath a deposit of submerged sand of 7.92 m thick. The top of the sand is located 3.05 m below the surface of a lake. The saturated unit weight of the sand is 19.62 kN/m3 and of the clay is 18.36 kN/m3. Compute (a) the total pressure (b) the pore water pressure and (c) the effective pressure all at the mid height of the clay layer. Draw the figure
35.) A dense silt layer has the following properties: void ratio = 0.75, specific gravity = 2.59. Free ground water is 9.49 m. below the ground. Capillary action rise will reach 6.69 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 50.02%. Determine the effective pressure (in kPa) at a depth of 7.51 meters from the ground surface. Round off to three decimal places.
In typical deposit of submerged soil, the approximate depth at which the inter-granular pressure is equal to 60 kN/m² is: (Ysat = 30 kN/m³)
What is the intensity of active earth pressure at a depth of 10.0 m in dry sand with an angle of shearing resistance of 30 degrees and unit weight of 18kN /m ^ 3 ?
Question 32 A dense silt layer has the following properties: void ratio = 0.66, specific gravity = 2.5. Free ground water is 9.47 m. below the ground. Capillary action rise will reach 6.66 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 52.77%. Determine the effective pressure (in kPa) at a depth of 7.42 meters from the ground surface. Round off to three decimal places.
A dense silt layer has the following properties: void ratio = 0.7, specific gravity = 2.58. Free ground water is 10.58 m. below the ground. Capillary action rise will reach 7.46 meters. The soil above capilary action rise is dry while within the zone, it is saturated at 54.74 %. Determine the effective pressure (in kPa) at a depth of 7.5 meters from the ground surface.
A saturated sand layer over a clay stratum is 5 m in depth. The water is 1.5 m below ground level. If the bulk density of saturated sand is 17.66 kN/m3 and G= 2.65, calculate the effective pressure in kPa on the top of the clay layer. a.46.40 b.117.9 c.323.9 d.80.66
A dense silt has the following properties: void ratio = 0.64, specific gravity = 2.5. Free ground water = 10.23m below the ground. Capillary action rise will reach 5.6m. The soil above the capillary action rise is dry while within the zone, it is saturated at 51.53%. Determine the effective pressure (in kPa) at a depth of 7.42m from the ground surface.