A coal with a higher heating value of 6,700 Kcal/kg is consumed at a rate of 600 kg/hr. in a water tube steam generator with a rated boiler horsepower of 200 HP. The feedwater temperature is 82°C and steam generated is at 11 kg/cm2 absolute, saturated. The developed boiler horsepower is equivalent to 305 HP. Determine: a. Heating surface area in m² b. Steam evaporated in kg/hr c. ASME evaporating units in J/hr

A coal with a higher heating value of 6,700 Kcal/kg is consumed at a rate of 600 kg/hr. in a water tube steam generator with a rated boiler horsepower of 200 HP. The feedwater temperature is 82°C and steam generated is at 11 kg/cm2 absolute, saturated. The developed boiler horsepower is equivalent to 305 HP. Determine: a. Heating surface area in m² b. Steam evaporated in kg/hr c. ASME evaporating units in J/hr

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.4P

See similar textbooks

Similar questions

Heat is transferred at a rate of 0.1 kW through glass wool insulation (density=100kg/m3) with a 5-cm thickness and 2-m2 area. If the hot surface is at 70C, determine the temperature of the cooler surface.
1.67 In beauty salons and in homes, a ubiquitous device is the hairdryer. The front end of a typical hairdryer is idealized as a thin-walled cylindrical duct with a 6-cm diameter with a fan at the inlet that blows air over an electric heating coil as schematically shown in the figure. The design of this appliance requires two power settings, with which the air blown over the electric heating coil is heated from the ambient temperature of to an outlet temperature of and with exit air velocities of 1.0 m/s and 1.5 m/s. Estimate the electric power required for the heating coil to meet these conditions, assuming that heat loss from the outside of the dryer duct is neglected.
An automobile engine consumes fuel at a rate of 22 L/h and delivers 55 kW of power to thewheels. If the fuel has a heating value of 44,000 kJ/kg and a density of 0.8 g/cm3, determinethe efficiency of this engine. Hint, Qa= mass of fuel * heating value.
The U.S. Department of Energy estimates that 570,000 barrels of oil would be saved per day if every household in the United States lowered the thermostat setting in winter by 6°F (3.3°C). Assuming the average heating season to be 180 days and the cost of oil to be $55/barrel, determine how much money would be saved per year.
A classroom that normally contains 40 people is tobe air-conditioned with window air-conditioning units of 5-kW cooling capacity. A person at rest may be assumed todissipate heat at a rate of about 360 kJ/h. There are 10 lightbulbs in the room, each with a rating of 100 W. The rate ofheat transfer to the classroom through the walls and the windows is estimated to be 15,000 kJ/h. If the room air is to bemaintained at a constant temperature of 21°C, determine the number of window air-conditioning units required
. An automobile engine consumes fuel at a rate of 22 L/h and delivers 55 kW of power to the wheels. If the fuel has a heating value of 44,000 kJ/kg and a density of 0.8 g/cm3, determine the efficiency of this engine. Hint, Qa= mass of fuel * heating value. Draw and label the P-V and T-S diagrams.
Determine the following: 1.The Capacity of the Airconditioning Plant, in Tons of Refrigeration 2. The Dew Point Temperature of the coil, in degrees Centigrade.
An automobile engine consumes fuel at a rate of 22 L/h and delivers 55 kW of power to thewheels. If the fuel has a heating value of 44,000 kJ/kg and a density of 0.8 g/cm3, determinethe efficiency of this engine. Hint, Qa= mass of fuel * heating value. Answer: 25.57%
An automobile engine consumes fuel at a rate of 22 L/h and delivers 55 kW of power to the wheels. If the fuel has a heating value of 44,000 kJ/kg and a density of 0.8 g/cm3, determine the efficiency of this engine. Hint, Qa= mass of fuel * heating value. And draw the P-V and T-S diagram.
Consider a classroom for 55 students and one instructor, each generating heat at a rate of 100 W. Lighting is provided by 18 fluorescent lightbulbs, 40 W each, and the ballasts consume an additional 10 percent. Determine the rate of internal heat generation in this classroom when it is fully occupied.
What is the ton of refrigeration required to cool 15,000 lbm of fresh pork from a temperature of 89°F to 32°F in one day? Specific heat above freezing of fresh pork is 0.68 BTU/lbm-°F.
A power station uses oil-fired boilers which are supplied with fuel from 4 cylindrical tanks, each with 12 m diameter and 11 m high. The calorific value of the oil is 38,039 kJ/kg and its relative density is 0.78. The output from the power station is 77 MW. Assuming the only 21% of the heat input is converted to into electrical energy output, how long will the boilers run (in days) on the oil in the tanks. Correct Answer: 4.7 ± 0.1