A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this circuit operates at 0.87 pf leading, determine the magnitude of this voltage, Assume voltage acrros the coil and the caapacitor are equal.

A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this circuit operates at 0.87 pf leading, determine the magnitude of this voltage, Assume voltage acrros the coil and the caapacitor are equal.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 3PP: The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the...

See similar textbooks

Related questions

Q: Convert 1000 W into its equivalent mechanical horsepower.

A: Given information: Power of 1000 W is given. This power needs to be converted into its equivalent p...

Q: Using superposition, find V, in the circuit of Fig. 4.76. Check with PSpice or MultiSim.

Q: Solve the following system of equations using the Gau 5. 27x + 6y – 2 = 85, x+ y + 542 = 110, Gx + 1...

Q: Practice Problem 4.17 A Wheatstone bridge has R1 = R3 = 1 kN. R, is adjusted until no cur- rent flow...

A: In this question , wheatstone bridge is given...We have to find out unknown resistance in balanced c...

Q: 6. If V2 = 1.396 V, and V3 = 4.189 V, find V7.

Q: Design a three input NOR layout so that rise time and fall time become equal when input logic switch...

A: Given: A three-input NOR layout so that rise time and fall time become equal when input logic switch...

Q: Given the Boolean expression: A= WXYZ + W'XYZ' + W'X'YZ + WYX'Z', identify the incorrect part of the...

Q: The antenna current of an AM transmitter is 8 amperes when only the carrier is sent, but it increase...

A: In this question , we will find percentage modulation of given AM transmitter and also find current ...

Q: Find the Nyquist rates for the following signals: X(t)= sin (20t) X(t) =4sin (30nt) + 3cos (70nt) X(...

Q: 1. What length of standard RG-8/U coaxial cable would be required to obtain 45 degrees phase shift a...

A: It is given that: Phase shift=θ=45°Frequency=f=200 MHz=200×106 HzVelocity factor=0.66

Q: Triangle Sketch the graph in the time domain and find the Fourier series represen- tation of the fun...

Q: -4 x(t) + y(t) + d dt d dt 2 3.

Q: A 30 ohm resistor is connected in parallel with a 0.106 H inductor. The parallel combination is then...

Q: R2 4 Ohm D: D: Is 5A R1 2 Ohm 4is 21:

Q: 3.By applying karnaugh map method, design a different circuit of full binary adder ucing more than 2...

Q: Perfendicada 3. a. For the capacitors shown, find the potential difference across each of the capaci...

A: The answer of the questions are

Q: 16 states in the truth table requires 4 literals. ( )True ( )False In a 3-input K-map, having...

A: I am giving answer of first 3 questions as per company guildlines.

Q: For the digital circuit below, what are the outputs at Y and Z? O Y is 1, Z is 0 O Y is 0, Z is 0 Y ...

A: Given data,

Q: Problem Solving: What is the CMRR of the circuit? 60v 50v 1 1500v 2000v 20v 30v +,

Q: 2. Calculate the fis, fLc, and flE: Chc = 20 pF Che = 30 pF C« = 12 pF = 8 pF 14 V Cw; = 10 pF Cw. B...

A: We need to find out lower cut off frequency for given circuit

Q: 5. Determine the current I for each of the configurations of Fig. 155 using the approximate equiv- a...

Q: A resistor and a capacitor are connected in series across a supply of 250 Volts. When the supply fre...

Q: R= 50 2 I= ??? V– 24V.

Q: Given the notations F1 (A, B, C) = 1(0,1,2,4) F2 (A, B, C) = r(1,3,5,6) design a combinational circu...

Q: Q2. A 7.2 V zener is used in the circuit shown in Figure below and the load current is to vary from ...

A: In this question, We need to determine the value of resistance R to maintain value of zener diode V...

Q: The depletion load NMOS inverter of Fig Qlb is made with kı = 2.5 mAV² and k2 0.4 mAV². Sketch the t...

A: The depletion load NMOS inverter as shown below is made with k1=2.5 mA/V2 and k2=0.4 mA/V2. We need ...

Q: The transfer function of a MIMO system is given as a 2x3 matrix (2 rows and 3 columns). The number o...

Q: 13-Find the Thevenin and Norton equivalent circuits between ab. 2 A a 6 0 18 V 3 A 10 V

A: Given:

Q: Q3. Draw the output waveform for the circuit shown below. 20 V 20 V

Q: Find the indicated currents for each of the circuits: 5V 5V 5V- fo 3K2 1kn

Q: load current is to vary from 12 to 100 mA. Find the value of series resistance R to maintain a volta...

Q: importance of studying basic electrical engineering when it comes to a vessel

Q: Find Norton equivalent circuit: 20 300 2 4 2 42 6 V 40 2V

Q: S, 2-to-4 Z2 G Y YO A 00 0 0 0 0 1 0 0 1 0 1 1 0 0 0 100 10 1 1 1 0 1 1 1 Decoder z, YO 2 Priority B...

A: The solution is given below

Q: I aystem, ir (t) - e[u(t) -u(e - 2)) Ae) = e[u(t) - u(t - 2)) %3! ye) 21) Sketch the system input x(...

Q: Practice Problem 4.12 Find the Norton equivalent circuit of the circuit in Fig. 4.45 at terminals a-...

A: To determine the Norton current short circuit the output terminals. The modified diagram is shown in...

Q: to the primary side. Question # 3 The coils of the magnetic circuit shown in the figure are connecte...

Q: • The message signal m(t) =a cos(2nf t)is used to either FM or PM for the carrier A, cos(27f t). Fin...

Q: A system uses channel bandwidth as 4 MHz and it can support a raw data rate of say 15 Mbps, assuming...

A: Given that New data rate=13Mbps Bandwidth=4MHz

Q: Solve for the value of the voltage on 220 ohms resistor. D1 2200 02 10V

Q: Given the following transfer functions, Draw the complete Root Locus for these systems at {K-0, ...

A: Gs=Ks+1s2+3s+3.25Gs=Kss+2Location of poles s2+3s+3.25=0s=-1.5±j Location of zeros s+1=0s=-1

Q: I 42 J22 42 J252 2 10.8: For the circuit shown, Find the currents w.r.t voltages equations (Y-Parame...

A: Apply KVL in two loops to find two equation in terms of voltage V1 and V2. According to KVL sum of v...

Q: 4.12 Determine v, in the circuit of Fig. 4.80 using the superposition principle. 2 A 5Ω ww + 12 V (+...

Q: A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the ...

Q: I=39 mA E=72 V R=8 kQ R2 R3 =6 kN

Q: 15. For the network of Fig. 11.65: (a) Determine re. (b) Find A, = V,/Vj. (c) Calculate Z,. mid

A: Since you have posted the questions with multiple subpart and we are supposed to answer 3 subpart on...

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v O 1 0.5 0.06 0.3

Q: A transmitter supplies 50 W to a load through a line with an SWR of 2:1. Find the power absorbed by ...

Q: Compute a single equivalent impedance for this circuit for a source frequency of f =50 Hz. Express y...

Q: Q2. Determine whether the transistor is biased in cutoff, saturation or linear region. (a) Rp= 75KN ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

continued

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the inductor, EL, is 104 V, and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. ETITZ20VAPFER78VIRRPEL104VILXLVARsLL
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
The impedance coil absorbs 250 watts when connected across 220 V, 60 Hz mains, it is then connected across 110 V, 25 Hz mains and also absorbs 250 watts. What is the inductance of the coil? Show complete solution.
An inductor coil with an inductance of 0.5 H and negligible resistance is connected across the terminals of a 230 V, 60 Hz supply. Determine the current in amperes taken by the inductor coil. What power in watts is taken by this inductor coil if the current lags the impressed voltage by 90 electrical degrees
A 50 uF capacitor is connected across a 230V, 50Hz supply. Calculate a) the reactance offered by the capacitor, b) the maximum current, and c) the rms value of the current drawn by the capacitor.
The mutual inductnce between two unity coupled coils of 9 H and 4 H will be ?
A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 ohm resistor to a 240V, 50 Hz supply. Calculate the inductive reactance of the coil, the impedance of the circuit, the current in the circuit, the p.d. across each component, and the circuit phase angle.
A coil is in series with a 20 microFarad capacitor across a 230 V, 50 Hz supply. The current takenby the circuit is 8 A and the power consumed is 200 W. Calculate the inductance of the coil if thepower factor is (a) leading and (b) lagging
A coil has an inductance of 478µH.What is its reactance in 1000Hz ac circuit? 3.00ohms if connected in series with a resistor of 4.00ohms. What is the reactance of a 3.00microfaradcapacitor? What is the impedance of thecapacitor in series of 300ohms? What would be the current if the capacitorand resistor are connected in series with1200V line?
Find the equivalent inductive reactance if the frequency is 65 Hz.