A cold junction of a themocouple is at room temperature of 83C. A votmeter connected to the themocouple circut indicates 3mv. If the voltmeter is calibrated as 100Cmv, thetemperature of the hot junction i:

Answered: Image /qna-images/answer/a27b878b-dde5-49ad-9c0f-18d1e25b0126.jpg

A cold junction of a themocouple is at room temperature of 83°C. A votmeter connected to the themocouple circuit indicates 35mV. Ifthe voltmeter is calibrated as 10 Cmv, the temperature of the hot junction in

A cold junction of a themocouple is at room temperature of 83°C. A votmeter connected to the themocouple circuit indicates 35mV. Ifthe voltmeter is calibrated as 10 Cmv, the temperature of the hot junction in

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 16RQ: Explain the difference between cumulative- and differential-compounded connections.

See similar textbooks

Related questions

Q: 2. Consider the three phase generator below: Phase A Phase B N Phase C N S a) If the stator rotates…

Q: +24 V 22 kN 2.7 kN Rs Si B = 75 4 kN Vs 50 mV 6.8 kN 1.5 kN RL 2.0 kN In the given circuit above,…

A: Brief description : For the given common emitter amplifier we need to calculate all the DC voltage…

Q: C 2C Node I Node d Node3 R 2R 20 Vin R/2. out

Q: a broadcast radio transmitter radiates 9 kilowatts when the modulation percentage is 75. how much of…

Q: This is 1000 DCV on the selector switch DC-10A PROBE ACV 250 50 1000 1000 250 50 10 (228) 10 DCV OFF…

A: The knob setting value and the multimeter pointer position both are shown in the question. We need…

Q: +24 V 22 kn 2.7 ka R, ww B- 75 S68 kn 15 kn RL 2.0 k 50 mV 1.5 kn

Q: Solve the following circuit using the graph theory approach C2 www R. R L

A: Graph Theory: Simply put, a network graph is referred to as a graph. It is made up of a series of…

Q: An impedance ZL = (11.5 + j10) ohms is connected in parallel with an impedance ZC = (8 – j20) ohms.…

Q: Sketch the transfer curve for an n-channel depletion type MOSFET with IDSS=14 mA and Vp = -5 V

Q: Use the (integral transformation) definition of the Laplace transforms to find the Laplace transform…

A: In this question, Find the Laplace transform of the given signals using the integral property of the…

Q: What is the practical application of a circuit that you can tune such that it reaches some minimum…

A: The Resistance in a circuit can be paired as the series or parallel combination. These combinations…

Q: Vos impact on 2 ampOps For the above circuit, determine the LITERAL equation of the output voltage…

A: The given circuit is as shown below,

Q: 2. Determine C/R, for the system given R2 R G2 Gs H H

A: The solution is given below

Q: The four arms of a bridge supplied from a sinusoidal source are configured as follows: Arm AB: A…

Q: Which of the following can cause corrosion to metal and is used to dissolve unnecessary copper in…

A: Printed circuit board is the full form of PCB. It is used to connect various electrical and…

Q: For the following pairs of sinusoids, determine which one leads and by how much. (a) v(1) = 10…

A: Given, We have a, b and c. We have to solve. Please find the below attachments for the clear…

Q: A charged particle of mass m 7.6X10-8 kg, moving with constant velocity in the y-direction enters a…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: D6.3. A conducting cylinder with a radius of 1 cm and at a potential of 20 V is parallel to a…

A: It is given that:r=1cm=0.01m V=20V h=5cm=0.05mεr=4.5

Q: 20s f (t) =t sin(@t) Ans. F(s)= (s² + w*}

Q: PROBLEM ES1-5-2 Directions: Solve the following combination circuit. Redraw the circuit listing the…

Q: b Wite the differential equation that is mathematically equivalent to the block diagram shown in…

Q: 10. A circuit has a real power of 230 W and a reactive power of -250 VARS. Find the Apparent power…

A: Given, P = 230 W Q = -250 VAR

Q: Q1: Draw the block diagram for AM/DSB-SD system uses a carrier frequency 1MHZ and pilot carrier of…

Q: Which sub-atomic part of an atom is used as a fundamental unit of electricity par'icularly when it…

A: 1.answer: C electron Electron is the fundamental particle which causes current. While remaining…

Q: B. Three capacitors 15 pF, 10µF, and 5µF are connected in parallel with a 10 v battery. Determine:…

A: In this question we have given 3 capacitors which connected in parallel....

Q: Part II. In the given circuit below, determine the current flowing through each resistors using; Es…

A: The solution is given below

Q: Implement f(a,b,c,d) = Σ m (1,2,3,5,9,10,11,15) using minimal gates and appropriate: (a) Decoders…

A: Brief description : In digital circuits we have different type of elements which are helpful in the…

Q: Diecions:Using the schematic below and the test results listed, which load contains an open?…

A: Fig: Given circuit it is given that when all load is connected in the…

Q: Which of the following range is best to set an Ohmmeter if you are going to check a 10k ohm…

A: The solution is given below

Q: A 22 mHmH coil whose resistance is 0.80 Ω is connected to a capacitor C and a 480 Hz source voltage.…

Q: Find expressions for the magnitude |G(jw)| for function G(s) below: s+5 G(s) = s(s + 1)(s + 2)

A: A transfer function is the ratio of output to input with zero initial conditions. The numerator…

Q: If we have a voltmeter, during the measurement do we need a voltmeter with high or low input…

A: Voltmeter is used to measure voltage not the current There is also used to measure the voltage drop…

Q: calculate the noise voltage at the input of a television RF amplifier, using a device which has a…

A: The solution is given below

Q: 3. For 6 = 100, VBE = 0.7 V and VE = 4 V, determine %3D а. Ic b. VB с. VCE d. R2 VCC 18V vc R1 R3…

Q: How does a 1-∅ system differ from a 3-∅ system?

A: Single phase system has only one sine wave voltage where as 3 phase system has 3 sine waves with a…

Q: An FM modulator has kf=30kHz/V and operates at a carrier frequency of 180 MHz a. Find the output…

A: In this question we will find output frequency for FM modulator....And also find peak frequency…

Q: A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must…

A: Given, a boost converter Vin=5v, Vo= 15v, P=20w

Q: 1. When is the counter EMF at a minimum?

Q: Which of the following provides the process transconductance parameter? a. W/Lµ„Cox b. none of the…

A: Transconductance is also known as mutual conductance or figure of merit. It gives how effectively…

Q: Directions: Using the schematic below and the test results listed, which resist. Shorted resistor =…

Q: Describe and compare the characteristics of TTL and CMOS Logic families. Please don't write on paper

A: FIND: Compare characteristics of TTL and CMOS logic families

Q: a 300 watt carrier is simultaneously modulated by 3 sine waves with modulated percentages of 20, 29…

A: The solution is given below This problem is from basic of amplitude communication. The power can…

Q: *46. Perform the following operations (express your answers in rectangular form): (4 +j 3) + (6 – j…

Q: Consider the circuit below and answer the following questions: Vs 5k 5.5k 150k Vi V3 15k Vo V. 15k…

Q: Sketch the transfer curve for an n-channel depletion type MOSFET with IDSS=14 mA and Vp = -5 V

Q: The network shown in Figure 2 contains two voltage sources, V, = 3020° and V, = 2020°. Using mesh…

Q: Why electrons are much more mobile than the holes?

A: The electron is the particle that is located inside the atom. The electrons have negative charge on…

Q: Sketch the transfer curve for p-channel IFET with IDSS = 18 mA and Vp = -9 V %3D %3D

A: In this question , we will draw transfer curve for p- channel JFET...

Q: VACA 10 0 30 0 20 1 40 2 15 0 15 0 10 0: 100 2 50 0 15 0 (1) (2) (3) (4) (a)

Q: Determine C/R, for the system given H3 R2 R G2 G, H

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

A cold junction of a themocouple is at room temperature of 83C. A votmeter connected to the themocouple circut indicates 3mv. If the voltmeter is calibrated as 100Cmv, the
temperature of the hot junction i:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q 3 Bring out the advantages and disadvantages of microwave tube devices andsemiconductor devices.What are the most common types of microwave diodes and transistors in use give theirbasic features features and applications?What are the most common types of microwave ICs? Give details of the circuit elementsand applications
A junction employs ND = 5 × 1017 cm−3and NA = 4 × 1016 cm−3.(a) Determine the majority and minoritycarrier concentrations on both sides.(b) Calculate the built-in potential atT = 250 K, 300 K, and 350 K. Explainthe trend.
Subject : ELECTRONIC CIRCUIT ANALYSIS AND DEVICES Please give the DC ANALYSIS circuit and AC EQUIVALENT CIRCUIT of this problem before proceeding to find letters a, and b. (Note : Neglect Vbe)
1) In a RC charging circuit, given R = 100 Kohm, Supply voltage = 12 V and voltage across thecapacitor is 5.8 V after time t = 15 ms. Find the value of the capacitor used. 2) If R = 10 Kohm and C = 10 µF, find the frequency of the astable multivibrator? Draw itsoutput waveform for Vcc = + 5 V.
The modified work function of an n-channel MOSFET is -0.85 V. If the interface change is 3*10-4 C/m2 and the oxide capacitance is 300 microF/m2, the flat band voltage is ?
Subject : ELECTRONIC CIRCUIT ANALYSIS AND DEVICES Please give the DC ANALYSIS CIRCUIT and AC EQUIVALENT CIRCUIT of this problem before proceeding to find letter c. (Note : Neglect Vbe)
a) Keeping in mind the Electrical-Mechanical analogy, write down the angular frequency relation (formula) for an ideal LC oscillator. b) If a Resistance R is added in the LC circuit, Energy is dissipated and it becomes a damped RLC oscillator. Considering the fact that the resistor acts as a damping factor, write down the frequency for the damped harmonic oscillator. c) Under what condition are the two frequencies (in a) and b)) equal?
Create a circuit of the Combinational Networks of the combination of BJT and FET with AC and DC supply. Solve it and show complete solution.
Draw the Nyquist plot for the system in the figure below. Using the Nyquist stability criterion, determine the range of K for which the system is stable. Consider both positive and negative values of K.( Need only handwritten solution please otherwise downvote)
Determine the transfer function for a tubular heat exchanger similar to the one shown in Figure 2.3 and described by the following differential equation: ** Please see attachment
10. This problem is all about Second-Order Circuits. Please provide an ANSWER and FREE BODY DIAGRAM. Thanks!
The topic here is about FET DC Analysis. Please show your correct and complete solution to the problem. Thank you!