A conductor of length 0.5 m is moving with the speed of 8 m/s in a perpendicular magnetic flux density of 0.8 T. If the conductor has an angle of 45" with respect to the speed's vector, find the voltage induced in the conductor in V.

A conductor of length 0.5 m is moving with the speed of 8 m/s in a perpendicular magnetic flux density of 0.8 T. If the conductor has an angle of 45" with respect to the speed's vector, find the voltage induced in the conductor in V.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12MCQ

See similar textbooks

Related questions

Q: Problem 7 Determine if any of the following transfer functions represent a realizable filter: 1 a)…

A: According to the question, for the given transfer function as shown below We need to determine if…

Q: Question 2 i-2A What is v1? 100 Σα 30 Ω Μ ΤΕ W 10 Ω 127 6Ω Μ U₂

A: Given data, Circuit is, Current, i=2 A.

Q: 5.) In the network shown, determine the resonant frequency in Hertz. V 15230 V ՏՈ mmmm 3mH M 100…

Q: A generator is connected to a transmission line as shown below. Calculate; a) VSWR b) The…

A: As per Bartleby's guidelines, only 3 subparts can be solved. Please send other subparts separately.…

Q: A sinusoidal 100V source (w=100 r/s) has an series resistor and capacitor as shown. This source…

Q: A) Given For the electrical system: E(t) B) Determine + + Vc(t) - R R=50, L=0.5H, C=0.01F IL (t)…

Q: Solve for the rms output voltage of figure b when Vin = -50V. Use ideal diode condition.

Q: Calculate the active power P, reactive power Q, apparent power S and it's phase-shift angle o…

A: Given: I=17.3-28.1j Ain polar form,I=32.998∠-58.831° AU=120.7+23.1j Vin polar form,U=122.891∠10.834°…

Q: A football pitch 120m x 40 m is to be illuminated for night play by similar banks of equal 1500W…

Q: In the following network Host 1 is connected through a wireless link to a 802.11 access point and…

A: To determine the frame addresses and To-DS/From-DS flag bits in the following data frames, we need…

Q: using Thevening theorem reduce the circuit below to an equivalent circuit and calculate the power…

Q: Question-1 Consider the following circuit, assuming Vin(t) = 2e-"r(t) + 4 sin(5(t-2)) ult-2) 35²-5…

A: here we have to find the laplace transform of Vin(t).

Q: Drive the following (write all the solution steps): 1. VxVU, where U = F (x, y, z) 2. V-VXA, where A…

Q: Question-1 Consider the following circuit, and given: Tout (s) = = Vin(t) Vin(t) = (-2e-t cos(5t) +…

A: The problem has been solved below

Q: Problem 5: The asymptotic Bodé plots of dB magnitude and phase are given. a) What are the DC gains |…

A: Given, Bode magnitude and phase plots are

Q: For R1=70, R2=95, R3=60 and R4-30 Calculate the equivalent resistance at terminals a-b for the shown…

Q: 1. Two single-phase transformers A and B of equal voltage ratio are running in parallel and…

Q: 5. Using Boolean algebra, simplify each of the following expressions. Show all your work for full…

A: Answer: given that f (A, B,C) = AB +ACA+B f (X, Y, Z) = XY +XZX + Y standard notations of logic…

Q: Construct the circuit in the schematic SV 1K 5V w 1K What logic function is performed by this…

Q: u [V]A 110+ 55 0 3 6 u(t) u [V] 110. MADUR 55 0 9 12 t[ms] Figure 2 a) i(t) Figure 1 R=202 3 b) 12…

A: In this given question , we need to find out average and RMS value of current (2 decimal place)…

Q: Consider a silicon p-n junction with an n-type doping concentration of 1016 cm-3 and forward biased…

Q: What does lossy of diaelectric material mean?

Q: Question No. 25 A three-phase, three-stack, variable reluctance step motor has 20 poles on each…

A: here we have to find the step angle of the step motor .

Q: What is matched termination?

A: In this question we discuss what is matched termination.

Q: Problem 2 A] Find the unit impulse response of a system specified by the equation (do not use…

A: It is given that: D2+5D+6yt=D2+7D+11xt

Q: Refer to the circuit below for the next three questions. The circuit below is at steady-state for…

Q: R Active power: 100 Calculate the circuit's active, reactive and apparent powers and it's power…

Q: explain what you would observe from coupled waveforms if resistive coupling will give both…

A: We need to explain about the observation obtained from coupled waveforms if resistive coupling will…

Q: Significance of Tracking in control systems. Could an example with temperature control for a human…

A: It is asked to tell the significance of tracking in control systems. It is specified to show an…

Q: Find the average value of each voltage in Figure hr mm. SV (a) ov+ 100 V 20 V +25 V I'm pro 10 V -15…

A: Given data Four waveforms are given in the problem with different shapes and different peak Values.…

Q: The boolean expression of the given circuit is A'C+A'B+A'B'C' A'C+A'B+AB'C' A'C+A'B'+AB'C'…

Q: QUESTION 1 Use the superposition theorem in the circuit at Figure below to find vo 6A For the…

Q: Question 2: Determine V and Z₂, across the terminal A and B for the circuit given below. Draw the…

A: In this question We need to determine the Thevenin equivalent across the terminal A and B. We are…

Q: QUESTION 10 What is the PIV thru each diode? Use approximate diode model. 110Vrms O 31.11V O 30.41V…

Q: Problem 5. Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length and…

Q: In IoT systems, actuators are responsible for transforming electrical inputs into actionable…

A: "Internet of Things" The term "IoT" refers to the "Internet of Things," which is a system of…

Q: L = ?

A: Given- Source voltage- vt=212.2sin500t VVR=120 V To Find- The value of inductor L.

Q: Q1) (a) For the following circuit, find the current i using Mesh analysis. 4Ω 2Ω www 12 10 Ω h (+1)…

A: In this question We need to determine the current I as shown the circuit. We are solving this…

Q: Determine Q-point for the diodes in the circuit given below using the ideal diode model where, R₁ =…

Q: For this next circuit, solve for the current io(t) as a function of time. Hint - a single node will…

Q: three-phase squirrel cage induction motor has a starting torque of 150% and a maximum torque of 00%…

Q: What is a good characteristic impedance for microstrip transmission line?

A: We need to explain characteristic impedance for microstrip transmission line.

Q: What is the average value of the output of the half-wave rectified waveform shown? ^^^ s 100 V-

A: Calculation of average value of the output of the half wave rectifier waveform given: From the…

Q: Consider the following circuit, and given: Tout (S) = Vin(t) Vin(t)= (-2e-t cos(5t) + 5e-3t…

A: In this question We need to determine the current iout (t) of the given circuit. We know Inverse…

Q: a b 8 ohm ix 3ix 2 ohm m In relation to terminals a and b, Determine the value of RTH

Q: [PI.la & Pl.1c] Find V (t), if the voltage V (s) : = 3s+10 (s+4)(s+5)

A: The output voltage is given in s domain and the same can be converted into time domain by using the…

Q: Consider a lossless parallel-plate transmission line. The width of the perfectly conducting parallel…

Q: How can wireless Internet contribute to the development of cyber police?

A: Solution: Wireless internet can greatly contribute to the development of cyber police by providing…

Q: Assuming the batteries supply a potential difference of DeltaV = 3.0 V, and use Ohm's Law along with…

A: Given: DeltaV = 3V The total current in circuit 4a = 0.018A The total current in circuit 4b = 0.027A…

Q: A three-phase squirrel cage induction motor has a starting torque of 150% and a maximum torque of…

A: Given: A three phase squirrel cage induction motor has, Starting torque of 150 % of rated torque…

Question

Problem 1
A conductor of length 0.5 m is moving with the speed of 8 m/s in a perpendicular magnetic flux density
of 0.8 T. If the conductor has an angle of 45" with respect to the speed's vector, find the voltage induced in
the conductor in V.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

With respect to the diagram shown below develop an equation for magnetic field intensity of a currect carrying straight conductor extending from point A to point B, consider dl=dzaz in this case
The magnetic field intensities inside and outside of a long and smooth conductor with a cross section radius are as follows. Accordingly, find the current densities J inside and outside the conductor. (Hint: Use cylindrical coordinates)
A cylindrical conductor of radius 1 cm has an internal magnetic field ? = ?0 (?2−?20.03) ?Φ ?/?Find the total current carried by the cylindrical conductor.
Derive the flux density, D, by applying Gauss's Law:1. Uniformly charged sphere
For the following configuration, both line and cylinder are infinite in extent with z-axis find 1-The value of electric field density at r= 3 m 2-The value of electric field density at r= 1 m
For a solid cylindrical conductor centered at the origin of radius “4cm” and carrying a uniform current of 3 A in the “z” direction. Find B at the following points: a) (2,6,0) b) (6,2,0)
A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A and B are 15 cm and 5 cm from the center of the conductor, respectively. If a test charge, q = 25mC, is to be moved from A to B, determine the following: a. what is the work done in moving the test charge? b. what is the rate of change of the potential with respect to length or displacement in the conductor?
PLEASE HELP The electromagnet device with the above geometric and electromagnetic parameters is placed in the x-y plane at the coordinates shown on the page plane. Please answer the following questions for this system. 1 How much magnetic field intensity has occurred in the core? 2. How much magnetic flux density (B) has been formed in the air? 3. How much magnetic flux density has been formed in the core? 4. When a conductor of 1 = 10A is placed in the 2-direction so that it passes through the middle of the air gap, how much magnetic force will affect this conductor?
Q1) Evaluate both sides of stoke's theorem if the magnetic flux density is given by 37.7r aphi(vector) uWb/m^2 in a free space area defined byr = 3; 0
A coaxial cable of consists of two concentric cylindrical conductors. The region between the conductors is completely filled with polyethylene plastic. The radius of the inner conductor is 0.50 cm, the radius of the outer conductor is 1.75 cm, and the length of the cable is 15 cm. The resistivity of the plastic is 1013 Ω • m. Calculate the resistance of the plastic if the electric field is applied across the ends of the conductor.
A 2a-part piece of wire was removed from the middle area of my upper edge, consisting of rectangular conductive wires with a long edge of 10a and a short edge of 4a, and replaced with a semicircular conductive wire with a radius. A constant I current passes through the closed ring in the way. What's the magnetic field vector at that point? (Get T=3).
The resistance of a cylindrical brass conductor, 0,5 cm diameter and 3 m long, is 0.0108 ohm. Determine resistance of a cylindrical conductor of the same material at the same temperature, and having a diameter of 0.25 cm and a length of 8 m.