A control valve for a fuel supply  system  has an average failure rate of  one failure  per four years. Suppose that the fuel supply  system is to be used  on an upcoming  space mission  that will last three weeks .Assume a target Reliability of .999.Is this part of the vehicle safe enough ? What might be done  to improve reliability  for this component ? What is the Availability  if it takes three weeks to repair ?

Q: The Capacity Planner of Primal Waters is tasked to ensure the maximum amount of water flows from…

A: When the pump is not in operation, From the diagram, f=0.02  LAB (Length of pipe AB)= 1000m LBC…

Q: How system reliability is difference from individual component reliability

A:

Q: Brinell harness experiment is a type of NDT test. Select one: True False

A:

Q: 1) A compressor is delivering air at a pressure of 8 bar gauge at the rate of 10 m3/min f.a.d.…

A: A compressor is a mechanical device that reduces the volume of gas in order to increase its…

Q: Which of the following is the best action to control hazards in workplace by referring to the…

A:

Q: . Determine how TCAS have played a role in a flight safety without any support from Air Traffic…

A: TCAS I frameworks are able to screen the activity circumstance around a plane (to a run of…

Q: A family wishes to buy a 2020 Toyota Camry. The two options the consider are (a) a standard…

A: (1) To find :  The amount of gasoline each vehicle would each year  Given : The speed of S.I engine…

Q: Attitude, environment, and system are a factor in the workplace that influence by a safety culture.…

A: For the safety culture model:- An Organizational atm. where S & H are understood and is…

Q: Discuss Figure 3 in details, including: a) Basic components required to have such those system b)…

A: The given figure shows the Flexible Manufacturing System (FMS)  in flexible manufacturing system…

Q: Please explain in plain English how some designers have compromised efficiency for safety.

A: Introduction to the factor of safety: Whenever any system works beyond a limit under which the…

Q: Design a complete and safe experiment to find out how increasing the distance of air that alpha…

A: A stable arrangement of particles is an alpha particle, which has two protons and two neutrons.…

Q: As a reliability engineer, your job is to help the plant to achieve its goals. Improving…

A: Maintenance of reliability allows a person, specifically a reliability engineer, to profit from…

Q: This maintenance practice is based on the idea of "run till it breaks". That means corrective…

A: Corrective maintenance is generally reactive in nature. Every time product or system fails , repair…

Q: design analysis techniques

A: The below  analysis techniques are followed for mechanical component design

Q: Which of the following is/are true? O Ceramics, plastics, and composites are examples of…

A: Casting is a manufacturing process in which a liquid material is poured into a mold having a hollow…

Q: Q1/ what is IRIS (Integrated Risk Information System)? Q2/ what IRIS (Integrated Risk Information…

A: 1. Integrated risk information system. IRIS is a environmental assessment program operated by the US…

Q: Shown in the table are the cash flows for 4 wate treatment systems that are to be compared at a MARR…

A:

Q: The Diagram below summerize what is a manufacturin system, can you explain it? Inputs Disturbances…

A: The manufacturing system is a set of interconnected equipment and human capital, the purpose of…

Q: Design failures occurs due to many factors. Discuss FIVE (5) possible causes of design failures,…

A: Solution:        Engineers are also human being so there will be a chances of human error which may…

Q: A space vehicle requires three out of its four main engines to operate in  order to achieve orbit.…

A:

Q: pneumatic leverage refers to the ability of a pneumatic system to

A: Given Data⇒Pneumatic leverageProblem definition⇒Problem says pneumatic leverage refers to the…

Q: Distinguish between diesel and lubricating oil in terms of Aromatic content ,Wax content ,Flow…

A: Lubricating oil A high bubbling point and low solidifying point (in arrange to remain fluid inside…

Q: Knowledge and analysis

A: SWOT analysis is shown below.

Q: What is a control system? * A technical or physical device, process or system, in which cause-effect…

A: Given Data⇒ Control system

Q: ri-County Utilities, Inc., supplies natural gas to customers in a three-county area. The company…

A:

Q: Natural gas pipeline must offer greater flexibility, increased operating safety, fewer accidents and…

A: Natural gas pipeline must offer greater flexibility, increased operating safety, fewer accidents and…

Q: Administrative controls are one of six elements in hierarchy of control. Which of the following…

A: Job Rotation and forming a safety committee represent the improvement of OSH categorized under…

Q: outlne with examples the general hierarchy that should be applied in order to control health and…

A: Controlling exposures to occupational hazards is the primary method of protecting workers.…

Q: a. Investigate the energy resources that are cyclic/variable/unpredictable nature? b. Can renewable…

A: Variable renewable vitality (VRE) (too called discontinuous renewable vitality sources) may be a…

Q: Automobile repair shops typically recommend that their customers change their oil and oil filter…

A: find out the cost of oil changing 3000 miles Cost=(15000/3000)*$30=$150 per year

Q: How can you prevent the outbreak of fire?

A: Given question: How can you prevent the outbreak of fire?  The given question is related…

Q: Use the internet and other reference materials to learn about the internal combustion engines valve…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: ontrols and give examples.

A: 1)Sequential---->.Instruction are executed linearly. Following some kind of guidelines to make…

Q: What does SAP Supply Chain Coordination entail?

A: SAP supply chain management application enables the customer-centric business process automatic…

Q: Consider palletizer at a bottling plant that has a first cost of $140,207, has operating and…

A: resent worth = $140,207 Annual maintenance cost = $18,691 per year Net salvage cost = $33,975 at the…

Q: The following table shows the performance criteria, weights, and scores (1 = worst, 10 = best) for a…

A: Performance Criterion Weight (A) Score(B) Weighted Score(A × B) Market potential 30 8 240 Unit…

Q: The following table shows the measurements made at 9 points in the occupied zone of an air…

A: The different measured values of EDT and air velocities inside the occupied zone of an…

Q: how standpipes and automatic sprinkler differ from each other as systems for fire protection?

A: The installation and deployment of structural and operational devices to reduce the impact of fire…

Q: Volatile liquid fuels behave differently from gaseous fuels

A: Fuel is a substance which dense repositories of energy or changed to produce heat, or also used for…