A copper wire has a diameter of 0.5 mm and a resistivity of 1.68 x 10^-8 Ω-m. What will be the length of this wire be to make its resistance 2 ohm?

Q: = Two 1-ph transformers 6000/400V, the first 200kVA and the other is 350kVA when performing the…

A: TRANSFORMER : A transformer is a passive electrical device that transmits electrical energy from…

Q: Q4/ The power radiated by a lossless antenna is 10 watts. The directional characteristics of the…

A: “Since you have asked multiple questions with multiple sub-parts, we will solve the first question…

Q: Two transformers are required for a Scott connection operating from a 440-V, 3-phase supply for…

A: Given: The primary voltage is 440 V The secondary voltage is 200 V The output is 150 kVA

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: In this question we need to find a output of the given system when step input is applied.

Q: a. For the circuit in Figure, what is the value of is? Answer format: a complex number in polar form…

A:

Q: For the ideal op-amp shown, what should be the value of resistor Rf (in kilo Ohms) to obtain a gain…

A:

Q: 2.18 Consider the transmission line circuit shown in the accompanying figure. Compute the incident…

A: Transmission line :-  It carries electrical energy and transmits it from one end to another end.…

Q: QI Calculate ich in the Circuit of Figure below 652 A SA SH +=0

A:

Q: EXAMPLE 2.4.7 Determine the particular solution of the difference equation y(n) = y(n − 1) = y(n −…

A:

Q: [20] Using nodal analysis, find Va, V6, and ly. LOV 5 кл хкл m укл H aplov ww 2mA x=14kΩ y=15kΩ

A:

Q: The voltage across a 1.1-kW toaster that produces a current of 10 A is: (a) 11 kV (b) 1100 V (c) 110…

A: From the question, it is given that  POWER=1.1 kW Current (I)=10 A We have to find voltage

Q: The starting torque of a 25-hp 720-rpm synchronous motor is 150 per cent of its rated torque.…

A: Rated torque is the ratio of output power to synchronous speed in rad/s Unit of Torque is Nm 1 Nm  =…

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A:

Q: What is the per unit impedance of a 50 MVA, 2% impedance transformer if the base is changed to 100…

A:

Q: Determine the zero-input response of the system described by the homogeneous second-orde difference…

A: Zero input response of system the initial condition of input response is zero. Due to initial…

Q: Reduce the block diagram shown below to find the transfer function C(s) / R(s). R(s) C(s) G₁(s)…

A:

Q: Determine the nodal voltages for the networks in Figure? ane 1₁ = 3A 40° 000 501 40 20 1₂ = 5A230

A:

Q: 3. Draw and explain the R-2R ladder type Digital to Analog Converter.

A: R-2R ladder type DAC: This is used to convert the digital signa into the analog signal. In the…

Q: Vp alldQ. m 20hm 80hm

A: Given circuit is shown below. From above figure, apply KVL at p node…

Q: The following are the different types of damping response of a second - degree ordersystem.…

A: Here we discuss about damping response of a second order system.

Q: Two 220-V, 1-phase electrical furnaces take loads of 350 kW and 500 kW respectively at a power…

A: It is Given that:V=220-V P1=350 kW P2=500 kWcosϕ=0.8 lagging. VL=11kV f = 50 Hz

Q: 2.1. An antenna has a beam solid angle that is equivalent to a trapezoidal patch (patch with 4…

A: Solution-Given,The antenna's beam solid angle is equivalent to trapezoidal patch.Thea ngular space…

Q: 2. Determine the following for the network shown below: a. b. ZiAMP C. Z.AMP d. ) ATAMP Given…

A:

Q: An extremely fast photodiode can be designed to achieve bandwidth of 158 GHz. Assuming that the…

A:

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A:

Q: 1. Calculate the lc in figure below with beta = 80 Vcc= 12 V ३1. 550k Select one: O a. 0.174mA O b.…

A: In this question,  We need to determine the collector current as shown the circuit.  We know…

Q: Answer the following questions true or false 1. In a positive clipper, the diode conducts when Vin >…

A:

Q: Determine the amplitude of the line current in a three-phase system with a line voltage of 300 V…

A: In a three-phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: 3: If the transistor is ON state, Vps sat = 0.2 V, K = 300 μA/V², find Vps?

A: FET ( field-effect transistor)- This has three terminals source gate and drain. It is a current…

Q: duce the block diagram and obtain its closed-loop transfer function R(s) G₁ H₂ G₂ G3 G4 H₂ C(s)

A:

Q: A three-phase, four wire, 208 volt, CBA system serves a balanced wye- connected load with impedances…

A:

Q: Q15: A given voltage signal f(t) = 4cos²20rt+2cos30nt across 102. (a) Determine PSD of f(t). (b)…

A: We need to find out the power and power spectral density of given signal

Q: 9. At 2:00 PM, a thermometer reading 80°F is taken outside where the air temperature is 20°F. At…

A: Data for outside- Specific time t T Ts 2:00PM 0 800F 200F 2:03PM 3 420F 200F ? t T 200F…

Q: H.W. Find the admittance of each set of series elements in Fig. 7. R 100) Y X₁S R≤60 Xc8N (a) Fig. 7…

A: We need to find out admittance of signal circuit

Q: Q3 The approximate far zone normalized electric field radiated by a resonant linear dipole antenna…

A: Given,The normalized electric field is,Ea≃a^θEasin1.5θe-jkrr,0°≤ θ≤180°&360°

Q: Vi = SV m 10kr joke in // skr 10k un loker m Eskr ↑ Vo ↓ Find Vout

A:

Q: Choose the values of RD, Rs, and R, for the JFET amplifier circuit of Fig. 3-11 that will result in…

A:

Q: Write the appropriate term for the following questions A clipper or limiter circuit consists of a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Let F(x,y,z)=(x | y) + (xz) be a Boolean function. Find a) the sum-of-products expression for F, and…

A:

Q: Subject Digital Logic Design(DLD) Design the truth table for Full Subtractor Circuit. Write the…

A: We need to design the Full substractor .

Q: PROBLEM: Find the state-space representation of the electrical network shown in Figure 3.8. The…

A:

Q: An impedance coil having a 0.2 lagging pf is connected in series with a 300 W lamp in order to…

A:

Q: Briefly explain the working of following power plants a) Thermal Power plant b) Hydel power plant

A: thermal power Plant coverts heat energy to electric power / Energy. The basic principle of these…

Q: The efficiency of a 20 kVA 15.4/0.4 kV three-phase power transformer is 76.4% for a unit power…

A: Iron loss: It is a core loss in the transformer. Iron loss includes the hysteresis loss and the eddy…

Q: 6. The power input to the d-e field of a 15-kva (input) synchronous motor is 6 per cent of the rated…

A:

Q: Determine R₁, R., Rc of the following for the given networks Vcc 9V Re R R₂-20KQ L-101 4₁ a=0.98…

A:

Q: 15 The voltage 2,000,000 V can be expressed in powers of 10 as: (a) 2 mV (b) 2 kV (c) 2 MV (d) 2 GV

A:

Q: A circuit consists of five elements. How much power is dissipated or delivered by element 5 if…

A:

Q: A two-winding transformer rated at 100 kVA, is connected as an autotransformer to provide 10kV from…

A:

Q: • Determine the output voltage for the regulator below. (Solution: 10.2 V) +15 V0- VOUT R₁ 1.0 ΚΩ D₁…

A:

Type of Magnetic Material

Every material has a unique composition that defines its magnetic behavior. Some materials get attracted towards a magnet and are called magnetic materials. Based on the magnetic properties held by each material, they are classified into different types.