A current changing at a rate of 5 A/s in a coil of inductance 5 H induces an EMF of: O a. 1 V in the opposite direction to the applied voltage b. 25 V in the same direction as the applied voltage O c. 25 V in the opposite direction to the applied voltage d. 1 V in the same direction as the applied voltage

A current changing at a rate of 5 A/s in a coil of inductance 5 H induces an EMF of: O a. 1 V in the opposite direction to the applied voltage b. 25 V in the same direction as the applied voltage O c. 25 V in the opposite direction to the applied voltage d. 1 V in the same direction as the applied voltage

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 31PQ

See similar textbooks

Similar questions

The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
Check Your Understanding. A changing current induces an emf of 10 V across a 0.25-H inductor. What is the rate at which the current is changing?
Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of its final value after 5.0 s, what is the inductive time constant? (b) If R=20 , what is the value of the self-inductance? (c) If the 20 resistor is replaced with a 100 resister, what is the time taken for the current to reach 90% of its final value?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
A step-up transformer is designed so that the output of its secondary winding is 2000 V(rms) when the primary winding is connected to a 110-V (rms) line voltage, (a) If there are 100 turns in the primary winding, how many turns are there in the secondary winding? (b) If a resistor connected across the secondary winding draws an rms current of 0.75 A. what is the current in die primary winding?
A 120-V, series-wound motor has a field resistance of 80 and an armature resistance of 10. When it is operating at full speed, a back emf of 75 V is generated, (a) What is the initial current drawn by the motor? When the motor is operating at full speed, where are (b) the current drawn by the motor, (c) the power output of the source, [ d) the power output of the motor, and (e) the power dissipated in the two resistances?
Check Your Understanding In an RLC circuit, L = 5.0 mH, C=60F , and R=200 . (a) Is the circuit under damped, critically damped, or overdamped? (b) If the circuit starts oscillating with a charge of 3.0103C on the capacitor, how much energy has been dissipated in the resistor by the time the oscillations cease?
In an LC circuit, what determines the frequency and the amplitude of the energy oscillations in either the inductor or capacitor?
Check Your Understanding What happens to the resonant frequency of an RLC series circuit when the following quantities are increased by a factor of 4: (a) the capacitance, (b) the self-inductance, and (c) the resistance?
At what time is the voltage across the inductor of the RL circuit of Figure 14.12(b) a maximum?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?