A damped free vibration system shown in the figure below. To ensure that the system oscillates with a natural frequency without damping wn = 7 rad /s and the positioned of the spring found that after three full swing amplitude is 1/5 of the original. Obtain i. the damping ratio ii. damped natural frequency iii. damping coefficient the critical damping coefficient k= 5kN/m m,= 5kg 100 cm www

A damped free vibration system shown in the figure below. To ensure that the system oscillates with a natural frequency without damping wn = 7 rad /s and the positioned of the spring found that after three full swing amplitude is 1/5 of the original. Obtain i. the damping ratio ii. damped natural frequency iii. damping coefficient the critical damping coefficient k= 5kN/m m,= 5kg 100 cm www

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A machine is represented as a single degree of freedom spring-mass-damper system. The machine has a total mass of (109)kg, an out-of-balance mass 0.125 kg, eccentricity of 0.01 m, coefficient of damping (109)N/ (m/sec), and spring stiffness (1009) N/m. The rotational speed of the machine is 3000 rpm. Determine the maximum amplitude of vibration due to out-of-balance. Suggest a method for the control of vibration caused due to out-of-balance.
A machine weighing 300lb is mounted on a supporting system consisting of four springs and four dampers. The vertical deflection of the supporting system under the weight of the machine is measured as 0.75in. The dampers are designed to reduce the amplitudeof vertical vibration to one-sixthof the initial amplitude after two complete cycles of free vibration. Find the following undamped natural frequency,damping ratio, and damped natural frequencyofthesystem.
The spring constant of the spring-mass-damper system is k = 5 kN/m, the damping constantcritical value ckr = 200 Ns/m and logarithmic decrement δ = 2. System initial conditionsare x0 = 0 m and v0 = 1 m/s. Determine the damping due to the initial conditionsthe maximum value xmax of the displacement of the characteristic vibration and its moment of occurrence tmax. Specifyresponse, i.e. in this case the values of the variables needed by the station x(t).
Critical damping means a situation in which the vibrator returns from the extreme position to the equilibrium position as quickly as possible so that the body does not pass over the equilibrium position. If the characteristic frequency of the body is 1.85 Hz and the mass is 590 kg, what is the damping coefficient of the suspension in the case of critical damping? Enter the answer in whole numbers.
Consider a SDOF system having a mass m = 30 kN s2 /m, damping c = 50 kNs/m and stiffness k = 4000 kN/m. Determine natural frequency, damping ratio and critical damping. For x(0) = 0.02 m, and x . (0) = 0.1 m/s. Find the solution of the equation of motion. Hence, plot inertia, damping and spring force vs time for free vibration.
*An air compressor of 450 kg operates at a constant speed of 1750 rpm. Rotating parts are well balanced, except for the reciprocating part (mass is 10kg and crank radius is 100mm). The mounting introduces a viscous damping of damping factor 0.15. a) What would be the frequency ratio only 20% of the unbalanced force is transmitted to the foundation? b) Find the natural frequency of the system. c) Find the stiffness of the spring for the mounting. d) Find the amplitude of the Unbalance force. e) Find the amplitude of force transmitted to the foundation
An underdamped shock absorber is to be designed for a motor cycle of mass 200 kg(m). When the shock absorber is subjected to an initial vertical velocity due to a road bump, the resulting displacement-time curve is to be as indicated below. Find the necessary stiffness and damping constants of the shock absorber if the damped period of vibration is to be 10 sec(τd) and the amplitude x1is to be reduced to one-eighth in one half cycle. Example is attached
An underdamped shock absorber is to be designed for a motor cycle of mass 200 kg(m). When the shock absorber is subjected to an initial vertical velocity due to a road bump, the resulting displacement-time curve is to be as indicated below. Find the necessary stiffness and damping constants of the shock absorber if the damped period of vibration is to be 10 sec(τd) and the amplitude x1is to be reduced to one-tenth in one half cycle. Example is attached
1. A system is needed to be designed as damped spring mass system. Calculate the amplitude of vibration. Stiffness=10 kN/m; mass 2Mg; and dashpot coefficient 2 kNs/m. It is subjected to a harmonic force = 500N @ frequency 0.5Hz
sum - 1 : determine magnification factor of forced vibration produced by oscillator fixed at middle of the beam at a speed of 600 rpm. The weight concentrated at the middle of the beam is 5000 N and produces statically deflection of the beam equal to 0.025 cm. Neglect the weight of the beam and damping is proportional to velocity of 2.5 cm/sec and force = 500 N sum - 2 : An automobile whose weight is 150 N and it is mounted on 4 identical springs due to its weight it sags by 250 mm . each shock absorber has damping coefficient of 0.4 N for a velocity oof 30 mm/sec. The car is placed on a platform which moves vertically at resonance speed having an amplitude of 10mm. Find the amplitude of the car Sum - 3: A SDOF has undamped natural frequency of 7 rad/sec. and a damping factor of 10%. The initial conditions are x0 = 0 and V0 = 0.5 m/sec. Find damped frequency and equation of motion of the system Sum- 4; A SDOF system with a mass 25 kg and stiffness 10 N/mm with damping 0.15 Ns/m…
Consider the mass-spring and damping system as shown in the figure. A harmonic force F = F0sin ωt acts upon the 11-kg mass. The spring constant is 7093 N/m and the damping coefficient is 252 N.s/m. There is no friction between the small rollers and the horizontal surface. Let F0 =923 N and ω = 117 rad/s. Calculate the period (in seconds) of the steady state vibrations. a) There is no frequency of free vibration, because there is damping. b) 0.2772 c) 0.1301 d) 0.2474 e) 0.0537
What is the deformation response factor for a damped system with stiffness of 800N/m, and a mass of 18kg? The system is being forced by an oscillating load of 6sin(2πt)kN and has a damping ratio of 0.33. Give the solution to 3dp.