A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a voltage = 180 Volt. Its voltage at speed 110 rad/sec and half excitation is: 065.23 V. 070.15 V. 063.02 V. ONone.

A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a voltage = 180 Volt. Its voltage at speed 110 rad/sec and half excitation is: 065.23 V. 070.15 V. 063.02 V. ONone.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.21P: An industrial plant consisting primarily of induction motor loads absorbs 500 kW at 0.6 power factor...

See similar textbooks

Related questions

Q: For the network of Fig. 5.163, Determine Zi? 12 V VH B = 120 To = 40 ΚΩ Z₂ Select one: O a. Zi = 236…

A: It is given that:

Q: potentiometer is R1 E 5 ΚΩ 120 V (0 - 120) V (0-10) V O (0-60) V O (0-20)V (0 - 80)V None of the…

A: This question belongs to electrical instrumentation and measurement . It is based on the concept of…

Q: 66.A capacitor is connected to a 108V supply. If the capacitor is being charged to 0.54W-s. What is…

A: Note: According to the guidelines of the company if the questions are of different then we supposed…

Q: Calculate the the Output Voltage of a non-inverting op-amp with the following parameters Rf =…

A: Features of Op amp High CMRR High gain High input impedence Low output impedence Noise rejection

Q: For the electric two-port circuit shown, write the voltages w.r.t currents equations (Z-Parameters).…

A: given here a two port network and asked to find the z parameter equations.

Q: A 10 mC charge is located 25 cm away from a very long line charge. If it experiences a force of 5 N,…

Q: A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a…

A: We need to find out excitation voltage

Q: If an amplifier has an input voltage of 2 V and an output voltage of 0.2 V, what is its voltage…

A: Given: If an amplifier has Input voltage, Vin=2 V Output voltage, V0=0.2 V

Q: For the following toroid, the flux is 440μWb, r1= 8 cm and r2=12 cm. The flux density is

Q: a-) In the circuit below, the silicon diode needs 1mA as the lowest value of the current in order to…

A: For the above given series connection of voltage source , resistor and diode we need to calculate…

Q: It is required to increase the power factor of a 750 KW three-phase balanced load from 70% lagging…

A: Given The line voltage and two power factors.we need to determine the capacitance required to…

Q: 4. Determine the failure rate of a repairable item if its failure rate to first failure is A=0,002…

A: Given Failure rate and mean time to restore,we need to determine the failure rate of repairable…

Q: In the center tapped full-wave rectifier the PIV is VM in diodes under blocking state O Higher than…

Q: For the oscilloscope trace of a sine wave. Each horizontal division represents 200μs and each…

Q: SHOW YOUR COMPLETE SOLUTION, MAKE SURE YOUR ANSWERS ARE IN 4 DECIMAL PLACES. Three uniform sheets…

Q: 1. Find and sketch the Fourier series corresponding to the square wave in the Figure shown.…

Q: A single phase 200V/1005V, 53Hz transformer has a net core area of 0.050 m2 and the maximum flux…

Q: C) Why is the common collector amplifier called an emitter follower? Why is it often used as a…

A: (C) Common collector amplifiers are those transistor amplifier in which the input and output…

Q: Three resistors R1, R2 and R3 are connected in series. According to the following relations, if RT =…

Q: Qy find the frequency thalasis for the Signal sown A 2

Q: significance of IoT in smart homes.

A: Nowadays are technology driven days, where the use of technology to make our lives relatively easier…

Q: Answer Five Questions Q1) Determine the voltage gain (Av) for the amplifier circuit shown in figure…

A: Given data: The value of the β is 250, Given figure:

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

Q: 3 Find the charge q(t) flowing through a device if the current is: (a) i(t) = 3 A, g(0) = 1 C (b)…

Q: Q6 L(cosh at) is equal to a) b) S c) s²-a d) None A O B O C OD

Q: If the output of a differentiator op-amp is -cos(wt) then the input is a.-sin (wt) b.none of the…

A: In this question we will write about differentiator opamp...

Q: 10. At star connection unbalanced load system the neutral current is. c. less than zero b. greater…

A: According to the ideal transformer model, the primary winding links all the turns on all the other…

Q: Q3/ Find the output Volta V2 R12 www 6.8k. 0.4V VI 0.1 V Hall Rit 6k RIS RM 2012 KO U1 RM1 w 20k R12…

A: For the above given question we need to calculate output voltage for the cascade connection of the…

Q: . An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The combination…

A: 6) Given: An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The…

Q: A uniform line charge ρL = 15 nC/m lies on the line, x = -6, z = 8, in free space. Find E in the…

A: Given : An uniform line charge in the free space along x = -6 and z = 8 To find Electric field E at…

Q: A series LRC circuit has a sinusoidal voltage supplied to it at 158 kHz with a peak voltage of 810…

A: Given data, Series RLC circuit in which f=158 kHzVm=810 VR=28 kΩC=16 μFL=49 H

Q: For the network of Fig. 5.163, Determine Zo? 12 V H B=120 To = 40 ΚΩ If ovo 7₂ ÎN 390 ΚΩ -8 V FIG.…

A: For the given common collector amplifier circuit we need to calculate its output impedance.

Q: ΘΑ ΤΩ ΤΟΥ 34 40Ω 40 Ω ΣΑ

A: given here a electrical circuit and asked to find the currents from i1 to i4 .

Q: A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a…

Q: 31. The following decimal numbers are shown in sign-magnitude form: +9,286 and +801. Convert them to…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: 6. Determine the transfer function V.(s)/Vi(s). R₂ www moo +₂ Vi(s)-ME R₂ C₁ 6₂ HE + Vo (s)

Q: . Determine the transfer function I.(s)/IT(S) R₂ WW R₁ www 6₂ (E) G₁ = 6₂ R3 MM i₂ (t)

Q: After plotting the Boolean function A(w,x,y,z)=∑ m (0,2,3,5,7,8,9,10,12,13,15) using Karnaugh map…

A: Boolean expression is given as. A(w,x,y,z)=∑ m (0,2,3,5,7,8,9,10,12,13,15) We need to simplify the…

Q: A 6-pole, 3 phase, 50 Hz induction motor runs at 750 rev/min at full load. Calculate i. the…

A: In this question we will find synchronous speed , slip and frequency ...

Q: Qle) Find, and in the circuit given. Use KVL and ohms law only to solve. 12 V 40 60 4V

Q: For the network of Fig. 5.172: Determine AVNL?

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: : Answer All points: In any network of wires carrying currents, the algebraic sum of all currents…

Q: A 100 W electric light bulb is connected to a 250 V supply. Determine: The current flowing in the…

A: In this question, We need to determine the current flowing in the bulb and resistance R of the…

Q: Explain in clearly the difference between Intensive and Extensive readings.

A: Given Enumerate the differences between intensive and extensive reading. Please find the below…

Q: at is the total reactance

A: For the given series connection of inductor and capacitors we need to calculate total reactance of…

Q: 025 4- The no- - lood primary current of a certain transformer is 1A at a lagging power factor of…

A: First refere the secondary current to primary side and then add the no load current and referred…

Q: Find the sum-of-products expansions of these Boolean functions. F(x,y,z) = x

A: Sum of product for of given bolean funtion is given as

Q: the input is a.-sin (wt) b.none of the above c.sin

Q: Based on the output characteristics of the Common-Base configuration, determine the resulting…

A: Answer: a. 6mA Explanation: a. It is a valid option. The value of the Emitter current is…

Q: QUESTION 4 b) The magnitude plot of a transfer function G(s) = (1+s/8X1+bsX1+ s/36) K(1+0.55X1+as)…

A: For the given bode plot we need to calculate the values of all the unknowns from the given transfer…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

A dc separate excited generator operate
at speed = 1500 R.P.M at a certain
excitation gives a voltage = 180 Volt. Its
voltage at speed 110 rad/sec and half
excitation is:
065.23 V.
070.15 V.
063.02 V.
ONone.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

please answer this question within 30 minutes. i will upvote. In a series RLC circuit with resistance ? and impedance ? , the rms value of the generator emf is ?rms and the rms value of the current is ?rms . The current lags the emf by ? . The average power supplied by the generator is given by which formula ? Show Mathematically.
Discuss about Generator modeling and derive the formula for the real and reactive power supplied by it ?
A lap wound dc generator having 50slots with 15conductors per slot generated at no led emf of 400v when running at 1000 rpm suppose if the same generator is desired to genate 220v on open circuit. Suggest the speed at which it has to be rotated
A dc shunt generator 50 V at the load 6A, rotating 700 r.p.m at the torque 4 N.m. Find the efficiency of generator?
What is the physical meaning of the reactive power and the power triangle? Explain howcan this triangle achieved?
Q2: A500 kW , 500 V, 10 poles d.c generator has lap wound armature Find the electrical angle shift of brushes when ATd / pole = 208 AT . If the ATC for same generator when connected as wave wound is 2600 AT when the brushes on G.N.A .
Show that an alternator running in parallel on constant-voltage and frequency bus-bars has a natural time period of oscillation. Deduce a formula for the time of one complete oscillation and calculate its value for a 5000-kVA, 3-phase, 10,000-V machine running at 1500 r.p.m. on constant 50-Hz bus-bars. The moment of inertia of the whole moving system is 14,112 kg-m2 and the steady short-circuit is five times the normal full-load value. ANSWER IS [1.33 second]
6. A separately-excited dc generator has no load output voltage of 120 V. its equivalent armature resistance is 0.95 Ω. If a load rated 2000 W at 115 V is connected across its terminals, what power is delivered to the load?
The synchronous reactance of the direct-axis and quadrature-axis of a three-phase,40-pole, 50 Hz, 13,8 kV, salient-pole synchronous generator is 2,38 Ω and 1,33 Ωrespectively. The resistance of the star-connected stator is negligible. The load angle ofthe machine is 30°e and the excitation is set to induce an emf of 167%. Sketch the phasordiagram and calculate:(a) current(b) power(c) reluctance torque(d) the maximum load angle(e) the maximum power developed
How many different load groups are there in power plants? Explain by drawing on a power-time curve.
no more than 50 words. Between a separately-excited and a self-excited DC generator, which is simpler to construct and why?
A seperately excited DC generator has a no load voltage of 127 V, Ra= 0.02 ohm and Rsh=15 ohm. Find the armature current when the generator terminal voltage is 120 V on load.