A deposit of cohesionless soil with a permeability of 0.3 mm/s has a depth of 12 m with impervious ledge below. A sheet pile wall is driven into this deposit to a depth of 8 m. The wall extendsabove the surface of the soil, and a 3 m depth of water acts on one side. Sketch the flow net and determine the seepage quantity. a. 600 ml/s/meter length b. 300 ml/s/meter length c. 1200 ml/s/meter length d. 900 ml/s/meter length

A deposit of cohesionless soil with a permeability of 0.3 mm/s has a depth of 12 m with impervious ledge below. A sheet pile wall is driven into this deposit to a depth of 8 m. The wall extendsabove the surface of the soil, and a 3 m depth of water acts on one side. Sketch the flow net and determine the seepage quantity. a. 600 ml/s/meter length b. 300 ml/s/meter length c. 1200 ml/s/meter length d. 900 ml/s/meter length

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter7: Seepage

Section: Chapter Questions

Problem 7.7CTP

See similar textbooks

Similar questions

A deposit of cohesionless soil with a permeability of 0.3 mm/s has a depth of 12 m with impervious ledge below. A sheet pile wall is driven into this deposit to a depth of 8 m. The wall extendsabove the surface of the soil, and a 3 m depth of water acts on one side. Sketch the flow net and determine the seepage quantity. Provide a diagram a.600 ml/s/meter length b.300 ml/s/meter length c.900 ml/s/meter length d.1200 ml/s/meter length
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in the Figure below. Given that kx= kz = k= 5.5 x 10-3 cm/sec, H1 = 6.5 m and H2 = 2.3 m determine: i. How high (above the ground surface) the water will rise if piezometers are placed at points a and b ii. The total rate of seepage through the permeable layer per unit length iii. The approximate average hydraulic gradient at c
The figure shows a weir, the base of which is 6m below the ground. The necessary flow net has also been drawn assuming Kx = Kv = K. K = 0.005 m⁄sec. Compute the following: rate of seepage through the foundation in liters/sec. uplift pressure at“f”. uplift force per unit length measured along the axis of the
Use 10 kN/m3 for unit weight of water. For a concrete structure that retains water, a flow net is sketched as shown in Figure H8-3. Noting the marked location of the Datum, answer the following: Mark on the figure all boundary Also mark the type of each boundary. Calculate the uplift pressures at points A, B, C, D, E, and F. Calculate the factor of safety against The seepage loss (q) per day per meter length of the (i.e. q in m3/day/m) if the permeability of the soil is k = 10-4 m/sec.
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in Figure below with a scale as shown. Given that kx = kz=k = 4 x 10-3 cm/sec, determine How high (above the ground surface) the water will rise if piezometers are placed at points a and b The total rate of seepage through the permeable layer per unit length The approximate average hydraulic gradient at c factor of safety against piping x=1.6 y=2.8
The figure shows a weir, the base of which is 6m below the ground. The necessary flow net has also been drawn, assuming Kx = Kv = K. K = 0.005 m⁄sec. Compute the following: a. rate of seepage through the foundation in liters/sec. b. uplift pressure at“f”. c. uplift force per unit length measured along the axis of the
Consider a farm irrigation ditch in a loam soil having the following dimensions: bottom width= 0.6 m, total depth, 0.5 m, side slopes= 1.5 horizontal to 1 vertical, and depth of water= 0.4 m. If the bottom of the ditch has a uniform slope of 2 m/km, and if the bottom & sides are kept smooth and free from weeds, what will be the mean velocity(m/s) of flow and discharge in m^3/s? Use n = 0.02. Find the shear stress at the watersurface, at half flow depth, and the canal bottom in N/m2 (or Pa). What is the shear velocity in m/sec?
For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements
Determine the rate of seepage (in cubic feet/min) under the dam by drawing flow net to scale, and also determine the total uplift force (in psf) acting at the bottom of the dam at Points B and D per unit length of dam. The permeability of the silty sand is 0.2 ft/min. The drawing is to scale. Use scaled drawing (next page) for your flow net sketching and pressure calculations/evaluations. Upstream water level is at El. 94 ft. Downstream water level is at El 68 ft. Dam is 85 ft long and bottom is at el 60 ft. Ground surfaces on both upstream and downstream sides are at El 64 ft.
A sheet pile wall is driven to a depth of 6 m into a permeable sand layer (k = 6X10-3 mm/s) of 13.5 m thickness lying on an impermeable layer. The water on one side of the wall is at a height of 4.5 m, while on the other side, pumps maintain the water level at ground level. Estimate the number of flow lines
The sheet pile is driven in the Cebu South reclamation area and the area to one side is pumped down as shown in the flow net. The permeability of the sand is 0.001 m/s. below the elevation of 20 m us an impermeable rock layer. Determine the flow per unit length.How high (above the ground surface) the water will rise if a piezometer will be placed at A?
Q#4 : For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements. Use MSpaint or graph paper