Answered: A diesel engine required 9,800 kJ of…

Engineering

Civil Engineering

A diesel engine required 9,800 kJ of heat to produce 1,800 kJ of power. What is its efficiency?

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter1: Energy Basics

Section: Chapter Questions

Problem 13P

See similar textbooks

Related questions

Q: H.W1: The temperature of a system rises by 15° C during a heating process. Express this rise in…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: A 2.0-kg aluminum block is originally at 10 degrees celcius. If 36 kJ of energy are added to the…

A: Given data :- *the mass of aluminium block (m)=2 Kg *the energy added to the block (Q) = 36KJ Q=…

Q: The change in internal energy for the combustion of 1.0 mol of octane at a pressure of 1.0 atm is…

Q: What is the energy collected from the sun in watts /area as measured in the pyranometer. O a. solar…

A: What is the energy collected from the sun in watts /area as measured in the pyranometer? The…

Q: 6. Maria is holding a ball from a height of 2 m that has the potential energy of 10 J, calculate the…

Q: Find the energy required to increase the room temperature of a coffee in a cup to a temperature of…

A: A type of elastic collision in which two objects of equal mass initially move in the same direction…

Q: 15.) Conduct research to find the specific heat capacity of water ___________________ and iron…

A: Specific heat capacity- It is defined as the quantity of heat (J) absorbed per unit mass (kg) of the…

Q: Civil Engineering An office building with a lower energy consumption should get a better energy…

A: Energy Efficient building Buildings that are built to give a considerable reduction in the energy…

Q: 2. The combined mass of a car and its passengers travelling at 72 km/hr is 3000 lbm- Find the…

Q: Five years ago, when the relevant cost index was 120, a nuclear centrifuge cost $40,000. The…

Q: The amount of CO₂ generated (in kg)

A: Given data, Compeletly oxidizing of one kg of CH4 to the end products. Find the amount of CO2…

Q: A 1000 MW coal fired power plant (30% efficiency). The coal is 75% carbon and has a heat content of…

A: 1. Coal fired power plant Given data, Amount of electricity produced = 1000 MWh Efficiency = 30%…

Q: A domestic refrigerator is loaded with food and the door closed. During a certain period the machine…

A: The first law of thermodynamics explains that energy can neither be created nor destroyed. heat is…

Q: A certain brand of hotdog cooker works by applying a potential difference of 146 V across opposite…

A: Given data; Potential difference, V=146 V Current, i=12.8 A H=60.8 KJ

Q: The Energy Efficiency Rating (EER) of an air-conditioning unit is defined asthe ratio of the heat…

A: Given data, Heat removed by one ton of A.C = 12,000 Btu/h Energy used = 2410 Watts. Capacity of A.C…

Q: A 25 gram metal ball heated 200 celcious with 2330 joulse of energy what is the specific heat of the…

A: Given: Weight of metal ball = 25 gm Temperature = 200°C Energy given to metal ball = 2330 J

Q: In a refrigeration cycle that is used to cool products of a grocery store has an efficiency of 46 %.…

Q: A 60 MW steam power station has a thermal efficiency of 30%. If the coal burnt has a calorific value…

A: Given: The steam power is 60 MW. The thermal efficiency is 30%. The calorific value of the coal is…

Q: When 6.3x10'J of heat energy is added to a statue in a heated oven, the statue's temperature rises…

A: Given: The heat energy is 6.3 x 105 J. The initial temperature is 16oC. The final temperature is…

Q: Which emits more SOx per unit amount of electricity produced; a coal-fired plant with a 90%…

A: Given data Efficiency, η=0.9 heating value of coal=13,000 Btu/lb heating value of oil=6×106…

Q: QUESTION 2 Which of the following best describes or defines Geothermal? O Heat energy from volcanic…

A: Geothermal energy is a type of energy taken from core of earth.It is a renewable source of energy.…

Q: An engine absorbs 100 J and rejects 60 J in each cycle. (a) What is its efficiency? (b) If each…

A: Given: The energy absorbs by the engine is 100 J. The energy released by the engine is 60 J. The…

Q: The combined mass of a car and its passengers travelling at 72 km/hr is 1500 kg. Find the kinetic…

Q: Problem 3. A nuclear-power station produces 750 MW per year as useful energy. The energy costs…

Q: Why is it not economical to try to transport gaseous CO2 ?

A: Answer IntroductionGreenhouse gases are mainly responsible for gradually increasing the atmospheric…

Q: Discuss the implications of difference in the EROI or efficiency for electric and hydrogen car

A: this question is asking about comparison of efficiency for electric cars and hydrogen cars :

Q: How long would it take a current of 100 A to deposit 10.0 g of Fe from FeCl 2

Q: O a. Solar energy O b. Wind energy O c. Mechanical energy O d. Kinetic energy

A: On roof mounting systems are related to solar energy

Q: What is the steam temperature of ultra-supercritical coal fired plant?

A: A supercritical coal-fired plant is a kind of coal-fired power plant in that modern technologies and…

Q: A domestic refrigerator is loaded with food and the door closed. During a certain period the machine…

A: Given:- The energy consumed by the machine for a certain period = 5 kWh The internal energy of the…

Q: A new coal-fired power plant has been built using a sulfur emission control system that is 70…

A: Given data: Efficiency of the power plant (η)=70%=0.70Amount of coal burned (C) =15000…

Q: power (in kW) recovered in the turbine

A: Given:' Density of water= 9810 N/m3 = 1000.34 kg/m3 g = 10 m/s2 Efficiency of turbine and pump = 70%…

Q: An automobile has an average power of 22 kW/hour for a trip. By a thermal efficiency of 30% how much…

A: The given data is: P=22 Kw/h n=30 % Assuming one hour ,P=22 Kw n=P/QT QT=22/0.8 QT=73.83 Kw

Q: 2. Which among the following is the formula for Helmholtz free energy?

A: To find : Formula for Helmholtz free energy.

Q: Assume that gasoline is burned with 99% efficiency in a car engine, with 1% remaining unbumed in the…

A: Given:- efficiency=99% remaining =1% engine =16 kg MW=30 MW=100 To find:- fraction of VOCs

Q: A motor pumps 1000 kg water 10 m vertically upwards in 1 minute. Calculate its power.

Q: Work done by an engine in 6 sec is 1000 joules. What is the power generated by the engine in watt?…

Q: Qs 23). Decane is a liquid with density of 730 kg/m3 and a lower heating value of 44.24 MJ/kg. If…

A: Answer 23. Given data: The decay density is 730 kg/m3. The lower heating value is 44.24 MJ/kg. The…

Q: A heat source of unknown temperature supplies energy of (R+650)kJ to a carnot heat engine. If this…

A: Consider the free body diagram;

Q: Which end use is largest consumer of energy in Canadian commercial buildings? Water heating Space…

A: The end use electricity usage is highest water heating and space heating. But largest among these 2…

Q: The data is related to a pelton wheel as follows: Head at the base of the nozzle: 80 m Diameter of…

Q: List down three to five situations in which buildings, roads or other structures has been built to…

A: Any substance that may be utilised for construction is referred to as a building material. Wood,…

Question

A diesel engine required 9,800 kJ of heat to produce 1,800 kJ of power. What is its efficiency?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 25 gram metal ball heated 200 celcious with 2330 joulse of energy what is the specific heat of the metal?
An automobile has an average power of 22 kW/hour for a trip. By a thermal efficiency of 30% how much fuel energy was used? What happened to all the energy? What change in entropy occurs when assuming ambient at 2000 C?
An engine absorbs 100 J and rejects 60 J in each cycle. (a) What is its efficiency? (b) If each cycle takes 0.5 s, find the power output of this engine in watts.
List down three to five situations in which buildings, roads or other structures has been built to make room for thermal expansion of different materials.
When 1 cu ft of natural gas is burned, 1,050 Btu of heat are produced. In oneday, a building uses 761,250 Btu of heat. How many cubic feet of gas areburned?
How long would it take a current of 100 A to deposit 10.0 g of Fe from FeCl 2
Answers are given! please explain the steps of the full solution! ASAP Energy density of hydrogen in a 700bar tank is 5MJ/KG.
A refrigerator absorbs 5 kJ of energy from a cold reservoir and rejects 8 kJ to a hot reservoir. (a) Find the coefficient of performance of the refrigerator. (b) The refrigerator is reversible and is run backward as a heat engine between the same two reservoirs. What is its efficiency?
A 60 MW steam power station has a thermal efficiency of 30%. If the coal burnt has a calorific value of6950 kcal/kg, calculate :(i) the coal consumption per kWh,(ii)the coal consumption per day.
Liquid weighing 0.98 gram and containing 90% of carbon and 8% of hydrogen give the following result in the bomb calorimeter experiment amount of water taken in the calorimeter equal to 450 gram water equivalent of the calorimeter equal to 450 gram rise in temperature of water equal to 1.8 degree centigrade if the latent heat of steam is 587 calorie per gram calculate the cross and net calorific value of the fuel