A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is held in place by a pín at A and a rocker at B as shown 2400 kg 1.5 m 2 m- 4 m Ture or False: At point A the contacting body is preventing the Crane truss from moving in both the horizontal and vertical directions. Select one: O True False

A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is held in place by a pín at A and a rocker at B as shown 2400 kg 1.5 m 2 m- 4 m Ture or False: At point A the contacting body is preventing the Crane truss from moving in both the horizontal and vertical directions. Select one: O True False

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.38P: The 40-kghomogeneous disk is placed on a frictionless inclined surface and held in equilibrium by...

See similar textbooks

Similar questions

The 40-kghomogeneous disk is placed on a frictionless inclined surface and held in equilibrium by the horizontal force P and a couple C (C is not shown on the figure). Find P and C.
The homogeneous plate of weight W is supported by a ball-and-socket joint at D and three wires. Draw the FBD of the plate and count the unknowns.
A cylindrical brick chimney of height H weighs w = 825 lb/ft of height (see figure). The inner and outer diameters are d1= 3 ft and d2= 4 ft, respectively. The wind pressure against the side of the chimney is p = 10 lb/ft2 of projected area. Determine the maximum height H if there is to be no tension in the brickwork.
Bar AB of negligible weight is supported by a ball-and-socket joint at B and two cables attached at A. Draw the FBD for the bar, recognizing that it is a two-force body. Determine the number of unknowns.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
In the figure shown, the large piston on the left has a diameter of D1 = 9.00 cm.The small piston on the right has a diameter of D2 = 4.00 cm.A lever arm pivot is located a = 5.00 cm to the left of the small piston.A small cylinder hangs from the end of the lever arm a distance b = 25.0 cm to the right of the small piston.In the absence of friction, determine the weight of the cylinder on top of the large left piston which can be supported in equilibrium with the small mass (m = 0.350 kg)hanging from the far right lever arm.Provide a force vector diagram (free body diagram).
A smooth inclined plane has a gradient of 1 in 6. Calculate the mass of a body that can be held in equilibrium on the plane by a force of 80 N when the force acts: (a) parallel to the plane answer M=49.62kg (b) horizontally answer M=48.94 kg (c) at an angle of the 20° with the plane. answer M=46.62kg
PLEASE ANSWER IN COMPLETE AND CLEAR SOLUTIONS. INCLUDE NECESSARY FREE-BODY DIAGRAMS. A 6-m long ladder has a mass of 16 kg, and its center of gravity is 2.4 m from the bottom along the ladder. The ladder is resting on a 5° upward sloping floor at A and on a wall inclined to the right at 5° from the vertical at B, so that it makes an angle of 60° with the horizontal. How far up along the ladder can a 77-kg man climb before the ladder is on the verge of slipping? The angle of friction at all contact surfaces is 15°. Also determine the total reaction at A and B in Newton. Note: Point A is at the left of point B.
The Cylinder weighs 1000 kg, rest on an plane which is inclined at 34° from the horizontal. The normal force acting on a plane to the cylinder is 10 KN. Assume smooth surface, the cylinder leaned to a vertical rod of 8m long and has a weight of 5 KN which was supported by a cable and a hinged (as shown). Find the tensile force of the cable holding the rod and the reactions of hinged to support the cylinder from sliding.
A 200 kg, 5 m wide rectangular gate is hinged at B and leans against the floor at Amaking an angle of 45 degrees with the horizontal (figure above). Determine theminimum force F, applied at the center of the gate required to open it.
A 25kg wooden plate is held in place by two strings attached to the ceiling and the wall. The string attached to the ceiling makes an angle 40o with the horizontal and the string attached to the wall makes 90o with the wall. Determine the force in each string (DONT ANSWER THIS PROBLEM). ANSWER ONLY THE PROBLEM IN THE ATTCHED IMAGE, COMPLETE SOLUTION PLEASE.
One end of a rod of length L and density ρ is fixed by a frictionless pivot at a depth d under water. Determine the equilibrium positions of the rod in terms of its angle α measured from the vertical, and the investigate whether the equilibrium positions are stable or unstable, given that (a) ρ = 500 kg/m3 ; (b) ρ = 853 kg/m3 (The density of water is ρw = 1000 kg/m3 .)