A fluid flows through the pipe below from left to right. The speed at point P is V1. If the speed at point Q is V2, which of the answers below is correct? •P radius R radius 2R Ov2 =V1 Ov2 = V1 OV2 = 2 V1 OV2 = 8 V1 O V2 = 4 V1

A fluid flows through the pipe below from left to right. The speed at point P is V1. If the speed at point Q is V2, which of the answers below is correct? •P radius R radius 2R Ov2 =V1 Ov2 = V1 OV2 = 2 V1 OV2 = 8 V1 O V2 = 4 V1

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A venturi tube is used to determine the airspeed at the throat/test section. During the test, a…

Q: State if the flow represented by u = 3x + 4y and v= 2x – 3y is rotational or irrotational. [Ans.…

Q: he open tank contains water. For incompressible flow, determine V2 for the given data if V1 = 3 m/s…

A: Given:D1=5 cmQ3=0.01 m3/sV1=3 m/sD2=7 cm

Q: When a pipe flow suddenly expands from Aj to A2, low-speed, low-friction eddies appear in the…

Q: diameter of cylindrical tank = 2 meters depth of cylindrical tank = 8 meters diameter of…

Q: Gasoline is flowing through this 180° pipe bend. The pipe cross-sectional area is 18 in?. Take the…

A: The density of the gasoline in general is assumed as ρ=680 kg/m3=42.41 lbm/ft3. The pipe has a…

Q: jet of water of 50 mm diameter moving with a velocity of 10 m/s strikes a flat fixed plate.…

A: Diameter, d = 50 mm Velocity, v = 10 m/s Find Force exerted by the jet Introduction: When…

Q: Problem 2. A flow is described by the stream function y = (2x - 4y) m²/s, where x and y are in…

A: The given stream function is The velocity in the x direction can be determined as, The velocity in…

Q: Please find the question attached.

A: Given data for incompressible flow through the device is –

Q: r the system determine a) the flow rate in m°/s b) The pressure at point A, B, c) the speed at the…

A: Given:ZA=10 mZB=13 mZc=10 mZD=0dn=25 mmdp=50 mms=0.86 NOTE: According to Bartleyby's guidelines we…

Q: If the speed component in the fluid is u=x?+2y, v=+) -+3y W= 2z V =-+y all wrongs -. in(x) Int2) c =…

A: Solution:

Q: (d) Calculate the amount of a fluid per unit of time that crosses the paraboloid cylindrical S:…

Q: Using the following streamline pattern, draw an appropriate control…

Q: A fluid flows through pipe shown below of uniform diameter 15 cm. The velocity of the fluid…

Q: The velocity vector in a flow is given by: V = 3xi + 4yj – (7z-1)k Determine the equation passing…

A: Given Data Velocity field is : V=3xi+4yj-7z-1k Points is : L(2,1,3) From above data…

Q: Engineering analysis Applications on first order ODE Flow through orifices 1- determine the equation…

A: Given: To find: equation of motion in terms of h

Q: Water flows from the tee attached to the pipe as shown in Fig. Q2. The water exits as a free jet at…

Q: oose the correct answer 3- when the flow is happened without change in its quantity or velocity…

A: Given Data⇒ Flow velocity time

Q: In order to measure the air speed in a pipe of radius R, you construct a device which tapers the…

Q: Determine whether of the following flows are irrotational, and find the velocity potential function,…

Q: A circular jet of water at 20°C impinges on the vane shown in figure. The incident jet has a…

Q: a) Water flows through a horizontal pipe with a cross-sectional area of 4 m at a speed of 5 m/s with…

A: Note- As per our company guidelines we are allowed to answer only the first question. Kindly repost…

Q: Q2/A circular jet of water at 200C impinges on the vane shown in figure. The incident jet has a…

A: To solve the question, we need to impulse momentum equation in the given figure. The force exerted…

Q: An open rectangular tank 1 m wide and 2 m long contains gasoline to a depth of 1 m. If the height of…

Q: The velocity field is given as u=y-1 and v=y-2. The units of u and v are m/s and the units of x and…

A: a).

Q: (3) The cart shown below is restrained from moving by a cable connected to a fixed wall. The tank…

Q: Consider the sprinkler which rotates at A when water flows out at B. At this instant, the sprinkler…

Q: Air flows from a pipe into a region between a circular disk and a cone as shown below. The fluid…

Q: According to the potential equation of a two-dimensional flow in the horizontal plane defined as;…

Q: If a turbulent water flows inside the piping system, the vertical distance h=30 mm, what is the…

Q: A lubricating oil of viscosity u undergoes a steady sheer between a fixed lower plate and an upper…

Q: The velocity vector in a flow is given by :V=-3xi-4yj-7zk Determine the stream equation passing…

A: The velocity vector in a flow is, V = -3x i - 4y j - 7z k The velocity components of equation are,…

Q: 7. For the flow of a thin layer of liquid down an inclined plane shown: a. Using the cross-hatched…

A: dear student as per the policy i can solve only three subparts for yoy request you to please post…

Q: the diameters of a tapering pipe at the sections 1-1 and 2-2 are 100 mm and 150 mm respectively. if…

A: flow rate is same at 1-1 & 2-2 sections Q=A1V1 = A2V2 d1= 100mm = 0.1m Q= A1V1 = 3.14/4 *(0.1)2…

Q: 2. The diameter of a 3 meter pipe decreases from 450 mm to 150 mm. If the velocity is to decrease…

A: Diameter at the bigger end =450 mmDiameter at the smaller end =150 mmLength of the pipe, L=3 m =3000…

Q: 2. Water flows in a two-dimensional channel of width W and depth D as shown in the diagram. The…

Q: Water flows steadily through the funnel shown in the following figure. Throughout most of the…

Q: If a turbulent water flows inside the piping system, the vertical distance h=30 mm, what is the…

Q: : Two water jets in a horizontal plane collide and form 0.15 m one homogeneous jet as shown in the…

Q: A conical pipe diverges uniformly from 100 mm to 200 mm diameter over a length of 1 m. Determine the…

A: At any distance x, the diameter is Dx=0.1+0.2-0.11x=0.1(1+x)

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

A fluid flows through the pipe below from left to right. The speed at point P is V1. If
the speed at point Q is V2, which of the answers below is correct?
• P
radius R
radius 2R
Ov2 = V1
OV2 = 2 V1
OV2 = 8 V1
OV2 = 4 V1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The figure represents a stream of water in a pipe. If the distribution of velocities in a section is given by v (see picture) where beta is a constant, r is the radial distance to the axis, and v is the velocity a at distance r from the axis, determine the flow rate Q.S
Water flows from a main line to a lateral as shown. The flow in the mainline is 1.63 ft3/s. Measurements show that the pressure at point 1 is 34 psi and at point 3 is 33.5 psi. Determine the velocities at 2 and 3. Assume the distance between the centerline of the main line and point 3 is 5 inches.
Water flows at a constant rate through a straight OB tube that rotates in the anti- clockwise with an angular speed of 150 rpm (Figure 7b_20). If the water speed is 6 m / s relative to the tube, determine the total acceleration (a) of the water at point P1 and (b) at point P2.
For the system of pipes shown, the flow of water in pipe (3) is 25 L/s. Find: The flow in pipes (1) and (2): Q1 =……………….., Q2 =…………………. The difference in head between the two tanks is H =………………… f1:0.016 f2:0.028 f3:0.018
Two rivers merge to form a larger river as shown in the figure. At a location downstream from the junction (before the two streams completely merge), the non-uniform velocity profile is shown and the depth is 6 ft. Determine the value of V.
A fluid flows through pipe shown below of uniform diameter 15 cm. The velocity of the fluid particles on the streamline along the center line of the pipe defined by V = 3t m/sec . find the the normal acceleration and the streamline acceleration when t = 10 sec. 0.5 m
Two geometrically similar pumps are running at the speed of 1500rpm and 3000rpm. One pump has an impeller diameter of 0.40 m and lifts water at the rate of 0.03 liters/sec against a head of 20 meters. Determine the head, discharge and ratio of powers of said pump of diameter 0.25m.
A horizontal jet of water 1 in. in diameter and having a velocity of 25 ft per second strikes against a vertical plate. (a) Determine the force (lb) on the plate if the plate is fixed.If the plate is moving in the same direction as the jet with a uniform velocity of 10 ft per second;(b) What is the relative velocity (ft/s), and(c) Determine the force (lb) on the plate.If the plate is moving in the opposite direction as the jet with a uniform velocity of 10 ft per second. (d) What is the relative velocity (ft/s), and(e) Determine the force(lb)on the plate.
In the flow illustrated in the figure below, the speed at point A is equal to 20 m/s. Neglecting energy losses and assuming uniform flow, determine the pressure PC.
The flow rate is flowing Q=10+5t into the pipe whose cross-sectional area increases to A(x) = 1+x . Assuming that the pipe flow is one-dimensional, what is the acceleration when time t=1 at the pipe inlet(x=0)?
A venturi tube is used to determine the airspeed at the throat/test section. During the test, a raise of 4.8 inches of water was recorded in the instrument. Determine the velocity of the at the (a) smallest and (b) largest section, when the ratio of the area between the largest and smallest section is 75:30. Assume incompressible flow and standard sea-level conditions.the answer should be v1 = 63.1962 ft/s and v2 = 157.9905 ft/s
Show that the force exerted by a liquid jet on a stationary nozzle as it leaves with a velocity V is proportional to V2 or, alternatively, to m.2. Assume the jet stream is perpendicular to the incoming liquid flow line.