A Glicerina SG 1.26 Agua SG = 1.0 Accite SG = 0.88 60 cm 10 cm 15 cm 20 cm Mercurio SG = 13.5

Q: A cylindrical water tower is filled to a depth of 6.00 m, and has the dimensions shown in the…

A:

Q: Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous…

A: For velocity comparison:A1V1=A2V2contuinity equation:⇒V1V2=A2A1⇒V∝1A∝1r2   -(1)as A=πr2for pressure…

Q: The pressure at the bottom of a cylindrical container with a cross-sectional area of 50.5 cm2 and…

A: (a) The given pressure is 115000 Pa and this pressure is the sum of liquid and  atmospheric…

Q: Question 9 The pressure difference between an oil pipe and water pipe is measured by a double-fluid…

A: Given: Water SGw=1.0 Mercury SGHg=13.5 Glycerin SGgly=1.26 Oil SGoil=0.88 Standard data used:…

Q: In the figure, water flows through a horizontal pipe and then out into the atmosphere at a speed v1…

A:

Q: Scientist found evidence that mars may once have had an ocean that is 0.500 km deep. The…

A: Given The depth of the ocean is h=0.500 km=0.5×1000 m=500 m. The acceleration due to gravity on…

Q: In the diagram below, the vertical heights holl and hwater are 3.00 cm and 3.00 cm. The diameter of…

A:

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A hydraulic press has a small piston of diameter =3.6 cm and the large piston of diameter=24.3 cm.…

A:

Q: A fluid of a constant density flows through a reduction in a pipe. Find an equation for the change…

A: Given a fluid a constant density flows through a reduction in a pipe we have to find the an equation…

Q: A 16.0 kg platinum mass rests on the bottom of a pool. (The density of platinum is 21.4 ✕ 103 kg/m3…

A:

Q: In Fig Q3, a solid cube of sides 0.15 m is suspended vertically by a cable and is fully immersed (c)…

A:

Q: The pressure in the pressurized water tank is measured by a multi-fluid manometer with one end open…

A:

Q: Calculate the fluid force on the side of the "infinite" plate B in the figure. The fluid mass…

A: Draw an elemental strip of thickness dy at a distance y below the x-axis.

Q: A 14.4 kg silver mass rests on the bottom of a pool. (The density of silver is 10.5 ✕ 103 kg/m3 and…

A:

Q: Figure shows the effect of tube radius on the height to which capillary action can raise a fluid.…

A: The height of water in the capillary tube is

Q: A container of cross-sectional area 122 cm2 contains liquid of density 1.75 g/cm3 to a height of…

A:

Q: ottom of a cylindrical container with a cross-sectional area of 45.5 cm2 and holding a fluid of…

A: We  know that We have given that The pressure at the bottom of a cylindrical container is 115 kPa…

Q: What is the mass flow rate of water if its volume flow rate is 520 liters/min

A: 1 Liter= 0.001 m3  1 min =60 s. The  mass flow rate of water  is    m=Vt   =ρVt    =(1000 kg/m3)(520…

Q: An object with mass 1.0 kg when placed in water has an apparent weight of 5.0N. It is then placed…

A: Recall Apparent weight=actual weight-Buoyant force

Q: An oil refinery uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A:

Q: A filling station uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A: ρ = 7.100 ✕ 102 kg/m3 r1 = 2.840 cm = 2.840 x 10-2 m r2 = 1.420 cm = 1.420 x 10-2 m P1 - P2 = 1.20…

Q: A manometer using oil (density 0.900 g/cm^3) as a fluid is connected to an air tank. Suddenly the…

A:

Q: A cylindrical water tower is filled to a depth of 6.00 m, and has the dimensions shown in the…

A:

Q: On a day with atmospheric pressure equal with water (Density= 1000 K9/m3) on one side and with oil…

A:

Q: In your bedroom, what is the maximum mass of an object that can be suspended from a 7.61 cm diameter…

A: diameter of suction cup (d) = 7.61 cm radius of suction cup (r) = 3.805 cmPressure (P) = 1 atm

Q: What is the pressure at the bottom of the tank when it is filled with water as shown, in kPa…

A: Given that, ρ=1000 kg/m3g=10 m/s21 atm =1.00×105 kPa The pressure due to a liquid filled in a…

Q: What is the weight of the oil raised, 5.5 cm height, in the capillary tube, diameter of 0.50 mm. The…

A: Height (h) = 5.5 cm = 0.055 m diameter (d) = 0.5 mm = 0.0005 m Density (ρ) = 920 kgm3

Q: An oil refinery uses a Venturi tube to measure the flow rate of gasoline. The density of the…

A:

Q: A solid cube 25.0 cm on each side is immersed in a fluid. The pressure at the top surface of the box…

A:

Q: What is the inner diameter of the capillary used in an experiment on the surface tension of liquids…

A:

Q: A U-shaped tube holds two liquids in static equilibrium: water kg (Pwater = 1000 -) and oil of…

A:

Q: Two cubic blocks of wood of the same density (590 kg/m³) and dimensions (5.00 cm x 5.00 cm x 5.00…

A: Density of block is p0 = 590 kg/m3 Volume of single block 125 cm3  Density of liquid is 1000kg/m3

Q: A hydraulic press has a small piston of diameter =3.6 cm and the large piston of diameter=24.3 cm.…

A:

Q: Water, with a density of ρ = 1185 kg/m3, flows in a horizontal pipe. In one segment of the pipe the…

A: Given that, the density of water ρ = 1185 kg/m3, v1 = 4.33 m/s, and v2 = 3.77 m/s.

Q: A very simple way of measuring the depth of a fluid in a gas station's underground gasoline tank is…

A: Given that                   The density of the gasoline is (ρ) = 700kg/m3                    The…

Q: Oil having sp gr of 0.9, determine the pressure at (a) the interface of the 2 liquids and (b) at the…

A:

Q: Two hoses are connected to the same outlet using a Y-connector, as the drawing shows. The hoses A…

A:

Q: Referring to Figure 14.20, prove that the buoyant force on the cylinder is equal to the weight of…

A: Weight of the fluid displaced by the cylinder is calculated as, W=mg    =ρVg    =ρAh2-h1g The force…

Q: A fluid of a constant density flows through a reduction in a pipe. Find an equation for the change…

A: According to the Bernoulli's principle . Total energy of a ideal fluid is constant . and given that…

Q: A square metal sheet 2.8 cm on a side and of negligible thickness is attached to a balance and…

A:

Q: An object which would normally float in water is instead attached to the bottom of a contaíner of…

A: Tension in the rope will be -  T=Fb-Fg .....(1) Where,  Fb=Buoyant forceFg=Gravitational force

Q: In the figure below, the velocity and pressure of an ideal fluid are v1 = 2.0 m/s and P1 = 180 kPa…

A:

Q: Water flows through a pipe as shown in the figure. The pressure at points 1 and 2 respectively is…

A:

Q: A container of cross-sectional area 107 cm2 contains liquid of density 1.75 g/cm3 to a height of…

A:

Q: What is the specific gravity of the liquid in the left leg of the U-tube manometer as shown in the…

A: We are going use the pressure difference formula to solve the problem. As, you can see the heights…

Q: he gauge pressure at a location is measured as 903 mmHgmmHg (mm of mercury), what is this pressure…

A: Given: The gauge pressure is 903 mmHg.

Q: A 19.8 kg platinum mass rests on the bottom of a pool. (The density of platinum is 21.4 ✕ 103 kg/m3…

A: (a) The volume of the platinum is