can you answer these qustions using, true, false, greater than, less than or equal to Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous|V4 is .... V5.incompressible fluid at locations i = 1,2,3,4,5.(For each statement select correctly)D-1mmD-2mm|-P4 is .... P5.P3 is .... P4.V P1 is .... P4.V4 isP1 isGreater thanTrueFalseFalse....P2.2V3.True....FalseV1 is....V1is.... V2.True

For velocity comparison:A1V1=A2V2contuinity equation:⇒V1V2=A2A1⇒V∝1A∝1r2 -(1)as A=πr2for pressure…

Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous incompressible fluid at locations i = 1,2,3,4,5.(For each statement select correctly) Delmm D-2mm P4 is P3 is P1 is V V4 is P1 is V1 is P5. P4. P4. Greater than v .... True .... False False V5. P2. 2v3. .... True .... False .... E> || >|| > || >

Use the picture as a guide. P is the pressure in the pipe, and v¡ is the speed of a non-viscous incompressible fluid at locations i = 1,2,3,4,5.(For each statement select correctly) Delmm D-2mm P4 is P3 is P1 is V V4 is P1 is V1 is P5. P4. P4. Greater than v .... True .... False False V5. P2. 2v3. .... True .... False .... E> || >|| > || >

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 22CQ: Does atmospheric pressure add to the gas pressure in a rigid tank? In a toy balloon? When, in...

See similar textbooks

Similar questions

Assuming that blood is an ideal fluid, calculate the critical flow rate at which turbulence is a certainty in the aorta. Take the diameter of the aorta to be 2.50 cm. (Turbulence will actually occur at lower average flow rates, because blood is not an ideal fluid. Furthermore, since blood flow pulses, turbulence may occur during only the high-velocity part of each heartbeat.)
Explain why the fluid reaches equal levels on either side of a manometer if both sides are open to the atmosphere, even if the tubes are of different diameters.
An oil gusher shoots crude oil 25.0 m into the air through a pipe with a 0.100-m diameter. Neglecting air resistance but not the resistance of the pipe, and assuming laminar flow, calculate the gauge pressure at the entrance of the 50.0-m-long vertical pipe. Take the density of the oil to be 900 kg/m3 and its viscosity to be 1.00 (N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to the 50.0-m column of oil in the pipe.
Unreasonable Results A fairly large garden hose has an internal radius of 0.600 cm and a length of 23.0 m. The nozzle-less horizontal hose is attached to a faucet, and it delivers 50.0 L/S. (a) What water pressure is supplied by the faucet? (b) What is unreasonable about this pressure? (c) What is unreasonable about the premise? (d) What is the Reynolds number for the given flow? (Take the viscosity of water as 1.005103(N/m2)s .)
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
Gasoline is piped underground from refineries to major users. The flow rate is 3.00102 m3/s (about 500 gal/ min), the viscosity of gasoline is 1.00103 (N/m2) s, and its density is 680 kg/m3. (a) What minimum diameter must the pipe have if the Reynolds number is to be less than 2000? (b) What pressure difference must be maintained along each kilometer of the pipe to maintain this flow rate?
What is the difference between flow rate and fluid velocity? How are they related?
If the gauge pressure inside a rubber balloon with a 10.0-cm radius is 1.50 cm of water, what is the effective surface tension of the balloon?
Many figures in the text show streamlines. Explain why fluid velocity is greatest where streamlines are closest together. (Hint: Consider the relationship between fluid velocity and the cross-sectional area through which it flows.)
Because atmospheric pressure is about 105 N/m2 and the area of a persons chest is about 0.13 m2, the force of the atmosphere on ones chest is around 13 000 N. In view this enormous force, why dont our bodies collapse?
What is the greatest average speed of blood flow at 37° C in an artery of radius 2.00 mm if the flow is to remain laminar? What is the corresponding flow rate? Take the density of blood to be 1025 kg/m3.