Answered: A hardware is required to download the…

A hardware is required to download the data at the rate of 50 pages per second. What is the actual bit rate needed by the channel? Give answer in megabits per second.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 2RP

See similar textbooks

Related questions

Q: A channel has a bit rate of 4 kbps and a propaga- tion delay of 20 msec. For what range of frame…

A: The Answer is

Q: True or false, and please provide a short explanation for your response to the following questions:…

A: We need to find if the given statement is true or false.

Q: Q.1: A binary symmetric channel with error probability of 0.3 and marginal entropy H(y)= 0.97095…

A: For answer (i) Attached image below:

Q: what the total time required to send 5000 bytes across a 3000 kilometers link at 1 Mbps?use a signal…

A: The transmission time (Tt) = L/B = Length of the data / Bandwidth The propagation time (Tp) = d /…

Q: What is the maximum data rate of a channel with a bandwidth of 200KHZ if we use four levels of…

A: This question explains about the maximum data rate of a channel with a bandwidth of 200KHz if we use…

Q: Can I have a detailed, step-by-step explanation for the following question? Thank you very much!…

A: We have 4 channels that are multiplexed using TDM. If each channel sends 100 bytes/second and we…

Q: True or false, and briefly explain your response to the following questions: When both the…

A: False

Q: What will the best latency be for 280 KB to be transmitted with a bandwidth of 12.5 KB per second?

A: The best combination is to have high-speed internet with low latency.

Q: what is the throughput if the system produces the 1000 frames/sec then A pure ALOHA network…

A: throughput of ALOHA network is calculated in step 2.

Q: Television channels are 6 MHz wide. How many bits/sec can be sent if four-level digital signals are…

A: Answer: According to Nyquist theorem, "Max. data rate = 2B log_2V bits/sec", So, one can sample = 2…

Q: Which transmission characteristic is never fully achieved? a. Latency b. Throughput c. Bit rate d.…

A: Answer: The correct option is (d) Bandwidth

Q: Two channels, one with a bit rate of 100 kbps and another with a bit rate of 200 kbps, are to be…

A: The minimum bandwidth rate is 100 kbps.The minimum bandwidth rate is 200 kbps.For the above channels…

Q: What bandwidth is needed to support a maximum theoretical data rate of 15 kb/s with a…

A: Given Data rate=15kb/s SNR=3000 To convert SNR into db: 10*log10(3000) 10*3.477121 34.77121…

Q: In an asenkron transmission a character size is 6 bits. When 1700 characters are transmitted, if…

A: In telecommunications, communication with asynchronous data transfer, usually without the use of an…

Q: 2. Sam wants to send 4000 8-bit characters of data. Find the total number of bits he will transmit…

A: Given: characters = 4000 1 character = 8 bits

Q: We have an available bandwidth of 400 kHz which spans from 500 to 900 kHz. What are the carrier…

A: EXPLANATION: Bandwidth is basically the amount of the maximum transder rate for any given network…

Q: 58. In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock. How…

A: Given: In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock.…

Q: In asynchronous transmission, why does the gap time between bytes differ?

A: Introduction: Because Transmission is asynchronous, the time interval between bytes is "variable."

Q: Is it true that a narrowband channel transfers data at a snail's pace? Why?

A: Introduction: Narrowband communication uses a narrow bandwidth. A narrowband channel is one in which…

Q: Question 56: How many 8-bit characters can be transmitted per second over a 9600 baud serial…

A: Solution.

Q: In a digital transmission, the receiver clock is 0.05 percent faster than the sender clock. How many…

A: Here I written Step by step solution to count extra bits. I hope you like it.

Q: Consider a channel with spectrum from 3 to 7MHHZ and SNR(dB) = 20dB. What is the maximum theoretical…

A: Channel is noisy as SNR( Signal to Noise Ratio ) is given. Maximum theoretical data (C) is given by:…

Q: How many bytes of data can be sent in 10 seconds over a serial link with baud rate of 2800 in…

A: The Answer is in step2

Q: two nodes which are 200 meters apart with m/s. Calculate the the velocity of 2 X 10' minimum size of…

A: The answer is

Q: True or false, and explain your answer to the following questions briefly: The alternating-bit…

A: The Alternating Bit Protocol (ABP) is a dependable stop-and-wait transport protocol, Positive…

Q: A channel has a bit rate of 4 kbps and a propagation delay of 20 msec. For of frame sizes does…

A: The Answer is in below Steps

Q: What is the bit rate for a system in which 25,000 bits are sent in 150 milliseconds? (Write your…

A: Please refer to the following step for the complete solution of the problem above.

Q: Computer Science Suppose that you had more than 4GByte of data to send and could only afford one…

A: In data transmission, network throughput is the amount of data moved successfully from one place to…

Q: A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the…

A: Actually, Network is consists of two or more computers that are linked in order to share resources…

Q: A link has a signal-to-noise ratio of 2000 and a bandwidth of 12000 KHz. What is the maximum data…

A: Here in this question we have given signal to noise ratio =2000 Bandwidth= 12000khz Find - maximum…

Q: A.9. We need to send 256 kbps over a noiseless channel with a bandwidth of 16 kHz. How many signal…

A: Rate given =256 kbps Bandwidth =16khz signal levels have to find We can use formula to find this…

Q: 1. In a parallel communication, each bit requires a transmitter and receiver. a) True b) False 2.…

A: Note : As per bartleby guidelines we are allowed to solve first question only.

Q: Four channels, two with a bit rate of 200 kbps and two with a bit rate of 150 kbps, are to be…

Q: What is the reason why the time gap between bytes in asynchronous transmission varies?

A: Asynchronous Transmission : Asynchronous Transmission necessitates the inclusion of extra bits known…

Q: In digital communications, what term is used to descirbed the relationship of the message bits and…

A: Digital communication-The physical movement of data through a point-to-point/ point-to-multipoint…

Q: Assume having a low-pass noiseless channel that spans from a Frequency of OHz to 180HZ, to send at a…

A: please do upvote for my efforts ! answer: bit rate = 2* bandwidth * log2(number of levels)

Q: Four channels, two with a bit rate of 200 kbps and two with a bit rate of 150 kbps, are to be…

A: Firstly here giving four channels Two with a bit rate of 200 kbps Two with a bit rate of 150 kbps…

Q: . How many check bits? Suppose you want to send 3500 characters of data. a) How many check bits…

A: we will solve this question in step No. 2

Q: A common measure of transmission for digital data is the baud rate, defined as the number of bits…

Q: eiver receive if th

A: given - In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock.…

Q: 2. (b) Suppose we have a 9 GHz bandwidth channel. If the upper limit of the bit rate is about 20…

A: In this question, we are given Channel Bandwidth, capacity and asked signal to noise ratio in…

Q: In digital transmission, the receiver clock is 0.2 percent slower than the sender clock. Answer the…

Q: In a digital transmission, the sender clock is 0.3 percent faster than the receiver clock. How many…

A: Please find the answer and explanation in the following steps.

Q: True or false, and briefly explain your response to the following questions. The alternating-bit…

A: SR: It is a selective repeat protocol utilized in the data link layer of the OSI model to achieve…

Q: Four channels, two with a bit rate of 120kbps and two with a bit rate of 880kbps, are to be…

A: Required: Four channels, two with a bit rate of 120kbps and two with a bit rate of 880kbps, are to…

Q: Assume that the data is transferred using a 4B5B bit synchronization and error detection code (4 net…

A: Block: Block secret writing helps in error detection and re-transmission of the signal. it's…

Concept explainers

Transmission media

A communication channel that transmits data from a source to a recipient is referred to as "transmission media." Electromagnetic impulses are used to transmit data. Transmission media's primary purpose is to transmit data in the form of bits via a local area network (LAN). In data transport, it is the physical link that connects the transmitter and receiver. Transmission medium is part of layer 1 or physical layer of the ISO/OSI (Open System Interconnection) model.

Question

A hardware is required to download the data at the rate of 50 pages per second. What is the actual bit rate needed by the channel? Give answer in megabits per second.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Solution :-

VIEW

Explanation :-

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

In a digital transmission, the receiver clock is 0.1percent faster than the sender clock. How manyextra bits per second does the receiver receive ifthe data rate is 1 kbps? How many if the datarate is 1 Mbps?
In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock. How many extra bits per second does the receiver receive if the data rate is 2 kbps? How many if the data rate is 2 Mbps?
In a digital transmission, the sender clock is 0.2 percent faster than the receiver clock.How many extra bits per second does the sender send if the data rate is 1 Mbps?
A line has a signal-to-noise ratio of 1000 and a bandwidth of 4000 kHz. What is the maximum data rate supported by this line? If the bandwidth of the channel is 5 kbps, how long does it take to send a frame of 100,000 bits out of this device? What is the maximum data rate of a channel with a bandwidth of 200 kHz if we use four levels of digital signaling?
Four channels, two with a bit rate of 120kbps and two with a bit rate of 880kbps, are to be multiplexed using multiple-slot TDM with no synchronization bits.Answer the following questions: a. What is the size of a frame in bits? b. What is the frame rate? c. What is the duration of a frame? d. What is the data rate?
In a digital transmission, the receiver clock is 0.05 percent faster than the sender clock. How many extra bits per second does the receiver receive if the data rate is 1 Mbps?
Assume we need to download text documents at the rate of 500 pages per second (each page is 24 lines with 80 characters per line (8 bits per character)). What is the required bit rate of the channel?
A planet located far from Earth is around 9 x 1010 meters away. If a stop-and-wait protocol is employed for frame transmission on a 64 Mbps point-to-point link, what is the channel utilization? Assume that the speed of light is 3 108 m/s and that the frame size is 32 KB.
Suppose we want to download text documents at the rate of 100 pages per second. Assume that a page consists of an average of 24 lines with 80 characters in each line. What is the required bit rate of the channel?
8. A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps.What is the throughput if the system (all stations together) produces?a. 1000 frames per second?b. 500 frames per second?c. 250 frames per second?
A distant planet is about 9 x 1010 metres from the surface of the Earth. What is the channel utilisation of a point-to-point connection that operates at 64 megabits per second and uses a stop-and-wait protocol for frame transmission? Let's say that the speed of light is 3 108 metres per second, and that the frame size is 32 kilobytes.
Suppose BanglaLink has 40 voice channels, each of 60 Mega Bytes per Second. They use synchronous TDM to multiplex these channels. If four characters at a time is multiplexed (four characters in each output slot), answer the following questions: iv) What is the output data rate? v) Input bit duration? vi) Output bit duration?