A horizontal lawn sprinkler in Fig. 5 has a water flow rate of 15 Ipm introduced vertically through the center. Estimate a) The rotational speed (rpm) of the sprinkler considering frictionless pivot b) The torque required to hold the sprinkler stationary d = 6 mm R= 150 mm %3D

Q: Example: A dam holds back the water in a lake. If the dam has a small hole 1.4 meters below the…

A:

Q: What is the velocity (m/s) at section 4, if the d4=10.4 cm? The problem is steady and…

A:

Q: The pipe flow in Fig. P6.58 is driven by pressurized air in the tank. What gage pressure pj is…

A: given: Q=60 m3/hT=20°Cd=5 cmL=60+80+30=170 m

Q: When a person ice skates, the surface of the ice actuallymelts beneath the blades, so that he or she…

A: Part a) Consider the skating edge and the water above the solid ice as a liquid between two parallel…

Q: What is the velocity (m/s) at section 4, if the d4-10.0 cm? The problem is steady and…

A:

Q: A coastal power plant takes in cooling water through avertical perforated manifold, as in Fig. . The…

A: Calculate the sink strength using the relation with the depth of water. Here, Q is the volume flow…

Q: A typical pump has a head that, for a given shaft rotationrate, varies with the fl ow rate,…

A: Given, The elevation at section 1, Z1 = 50 ft The elevation at section 1, Z2 = 150 ft The efficiency…

Q: Explain Cavitation in Pumps. Support your answer with neat sketches/graphs.

A: GIVEN DATA - CAVITATION IN PUMP GIVEN WE HAVE TO EXPLAIN WITH DIAGRAM

Q: A certain axial flow turbine has an output torque M that isproportional to the volume flow rate Q…

A:

Q: P3.108 A rocket sled of mass M is to be decelerated by a scoop, as in Fig. P3.108, which has width b…

A:

Q: Find the questions 1. Stress state of fluid. 2. Piston pumps. Structure, operation. 3. The basic…

A:

Q: A wind turbine, 12 m in diameter, operates at sea level in a wind of 20 m/s. The wake or downstream…

A:

Q: Consider steady flow of water through an axisymmetric garden hose nozzle. The axial component of…

A:

Q: C- Estimate the velocity at point (2) and discharge of oil that as a petroleum engineer want to…

A: Given, Change in pressure between section 1 and 2 = P1 - P2 = 100 kPa = 100 x 103 Pa Diameter at…

Q: In Prob. it would be difficult to solve for Ω because of itappears in all three of the dimensionless…

A:

Q: A Francis radial-flow hydro turbine has the following dimensions, where location 2 is the inlet and…

A:

Q: Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23…

A: Given data          Density P=1.23 kgm3=0.002377 slugft3         Pressure P= 1.01x105 Nm2= 2116 lb…

Q: An incompressible fluid flows past an impermeable flat plate with a uniform inlet profile (Uo ) and…

A: GIvenInitial velocity=u=UoFinal velocity=u=Uo3η-η32Here η=yδ

Q: horizontal 7.5 cm diameter sharp-edged orifice with Cc = 0.063 and Cv= 0.98 is under a head of 2.30…

A: Given:d=7.5 cm =0.075 mCc=0.063Cv=0.98h=2.3 mZ2=1 m

Q: Consider the arrangement of three wind turbines in the following schematic in which wind turbine C…

A: Solution: Given Data:   To Find: (a) udef(b) VC

Q: Rocket engine nozzle is designed on sea level conditions. Explain with relevant math equations.

A: Rocket engine nozzle A rocket motor spout is a pushing spout (for the most part of the de Laval…

Q: A wind turbine rotates at speed of 300 rpm. What is the circumferential velocity at the tip of the…

A: GivenN=300rpmwind velocity V=7m/sTip speed ratio TSR =7m/s

Q: Suppose we have planned to design a hydraulic system.In this aspect, the pump selection is to be…

A:

Q: Three pipes steadily deliver water at 20°C to a large exit pipe in Fig. The velocity V3 = 8 m/s, and…

A:

Q: A centrifugal pump discharge 20 L/s against a head of 17 m when the speed is 1500 rpm. The diameter…

A: Given:Discharge, Q=20 L/s or 0.02 m3/shead, h=17 mspeed, N=1500 rpmdiameter of impeller, D=30 cm or…

Q: Q3/ if what is the steady-state flow rate of a linear reservoir that has permeability of 290 md with…

A: As per given question defind the steady-state flowrate of water bbl/day.

Q: Compute and plot the thrust of a rocket engine for constant exhaust conditions, pe 1.00 k/m3, pe =…

A: Formula Thrust T =m .Ve + Ae(Pe-Pa)

Q: Three pipes steadily deliver water at 20°C to a large exit pipe in Fig. The velocity V3 = 8 m/s, and…

A:

Q: What is the velocity (m/s) at section 4, if the d4=5.3 cm? The problem is steady and incompressible.…

A: In steady state  Mass entering to system=Mass out from system

Q: -Example Calculate the values asystem total head against. Capacity curve for the initial condition,…

A:

Q: For H =3 m, calculate Qi and Q2. 3m KENTRANCE= 1.0 KENT = 1.0 Q1 Q2 Di- 20 cm Li=2m Dz= 50 cm t=002…

A: Given: To Find: Q1 and Q2 "Since you have asked multiple questions, we will solve the first…

Q: Three pipes steadily deliver water at 20°C to a large exit pipe in Fig. P3.8. The velocity V2 = 5…

A: Given:D1=4 cmD2=5 cmD3=6 cmD4=9 cmV2=5 m/sQ4=120 m3/h

Q: A pump impeller rotating at 1400 rpm has an outside radius of 21 cm, the vane outlet angle B2 is…

A: The theoretical head, Ho = 65.6 m. Therefore, option (b) is correct answer.

Q: lve the problem as stated below. Make your solution clear and clear. Mind your vn “Solution". Do not…

A:

Q: 1800 m/s, nozzle throat diameter of 25 cm, An ideal rocket has characteristic velocity c* = thrust…

A:

Q: Pump Patm = 100 kPa D = 3 cm The pump in Fig. P3.146 draws gasoline at 20°C from a reservoir. Pumps…

A: The data Given  T=20°C Patm=100×103N/m2

Q: IThe pump in Fig. P3.191 creates a 20°C water jet oriente to travel a maximum horizontal distance.…

A: For the maximum horizontal distance, the exit angle must be equal to 45 degrees. The equation for…

Q: Water is coming out from a tap and a falls vertically downwards. At the tap opening, the stream…

A:

Q: Imagine the plug in the sink described in Problem 8.31 leaks. If it now takes 45 seconds to fill the…

A:

Q: A large Rankine oval, with a= 1 m and h = 1 m, isimmersed in 20°C water flowing at 10 m/s. The…

A: Given, A large Rankine oval with a=1m and h=1m. Water temperature =20°C Water velocity, U∞=10m/s.…

Q: An actual small river carries seawater at a 500 m/s flow rate and the river has average depth and…

A: Given Data, Discharge of the prototype, QP =500 m3/s Depth of the prototype, DP =5 m Width of the…

Q: A one-fifth scale model of a water turbine is tested in a laboratory at T = 20°C. The diameter of…

A: Given H = 15 m ,  Q = 17 m3/hr  = 173600 m3/sN = 1500 rpmP = 450 wattat 20°C( For water ) → S = 998…

Q: Consider Fig. P3.36 as a general problem for analysis of amixing ejector pump. If all conditions ( p…

A: For volume flow

Q: A small model water turbine is tested in a flume where Cp is measured to be 0.38. Assuming dynamic…

A:

Q: Q23- Water flow through pipes of 4in and 2 in diameter, 50oft and 400ft Length, If e= 0.0031ft and…

A:

Q: b) A Pelton wheel 3.0 m diameter operates under the following conditions: Net available head, H=300…

A: Given: The diameter of Pelton wheel, D = 3.0 m The net available head, H = 300 m The rotational…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.