A hotel builds a water (1.00 g/cm³) fountain that is fed by a din = 14.9 cm diameter cylindrical pipe that carries water horizontally hbelow = 8.92 m below the ground. The pipe turns upward and eventually fires water out of the d. = 6.78 cm diameter end of the cylindrical pipe, which out is located habove = 1.72 m above the ground, with speed Vout = 33.2 m/s. What gauge pressure is required in the underwater horizontal pipe for this fountain? Vout habove hbelow din 7.24 atm 4.18 atm 6.24 atm Vin dout

A hotel builds a water (1.00 g/cm³) fountain that is fed by a din = 14.9 cm diameter cylindrical pipe that carries water horizontally hbelow = 8.92 m below the ground. The pipe turns upward and eventually fires water out of the d. = 6.78 cm diameter end of the cylindrical pipe, which out is located habove = 1.72 m above the ground, with speed Vout = 33.2 m/s. What gauge pressure is required in the underwater horizontal pipe for this fountain? Vout habove hbelow din 7.24 atm 4.18 atm 6.24 atm Vin dout

Name: 3A hotel builds a water (1.00 g/cm) fountain that is fed bya din = 14
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: 3A hotel builds a water (1.00 g/cm) fountain that is fed bya din = 14.9 cm diameter cylindrical pipe that carrieswater horizontally hbelow = 8.92 m below the ground. Thepipe turns upward and eventually fires water out of the= 6.78 cm diameter end of

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 14.80AP: The water supply of a building is fed through a main pipe 6.00 cm in diameter. A 2.00-cm-diameter...

See similar textbooks

Similar questions

Does atmospheric pressure add to the gas pressure in a rigid tank? In a toy balloon? When, in general, does atmospheric pressure not affect the total pressure in a fluid?
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
How tall must a water-filled manometer be to measure blood pressures as high as 300 mm Hg?
The water supply of a building is fed through a main pipe 6.00 cm in diameter. A 2.00-cm-diameter faucet tap, located 2.00 m above the main pipe, is observed to fill a 25.0-L container in 30.0 s. (a) What is the speed at which the water leaves the faucet? (b) What is the gauge pressure in the 6-cm main pipe? Assume the faucet is the only leak in the building.
Unreasonable Results A fairly large garden hose has an internal radius of 0.600 cm and a length of 23.0 m. The nozzle-less horizontal hose is attached to a faucet, and it delivers 50.0 L/S. (a) What water pressure is supplied by the faucet? (b) What is unreasonable about this pressure? (c) What is unreasonable about the premise? (d) What is the Reynolds number for the given flow? (Take the viscosity of water as 1.005103(N/m2)s .)
A submarine is stranded on the bottom of the ocean with its hatch 25.0 m below the surface. Calculate the force needed to open the hatch from the inside, given it is circular and 0.450 m in diameter. Air pressure inside the submarine is 1.00 atm.
In about 1657. Otto von Guericke, inventor of the air pump, evacuated a sphere made of two brass hemispheres (Fig. P9.89). Two teams of eight horses each could pull the hemispheres apart only on some trials and then with greatest difficulty, with the resulting sound likened to a cannon firing. Find the force F required to pull the thin-walled evacuated hemispheres apart in terms of R, the radius of the hemispheres, P the pressure inside the hemispheres, and atmospheric pressure P0. Figure P9.89
(a) What is the density of a woman who floats in freshwater with 4.00% of her volume above the surface? This could be measured by placing her in a tank with marks on the side to measure how much water she displaces when floating and when held under water (briefly). (b) What percent of her volume is above the surface when she floats in seawater?
Liquid toxic waste with a density of 1752 kg/m3 is flowing through a section of pipe with a radius of 0.312 m at a velocity of 1.64 m/s. a. What is the velocity of the waste after it goes through a constriction and enters a second section of pipe with a radius of 0.222 m? b. If the waste is under a pressure of 850,000 Pa in the first section of pipe, what is the pressure in the second (constricted) section of pipe?
The human brain and spinal cord are immersed in the cerebrospinal fluid. The fluid is normally continuous between the cranial and spinal cavities and exerts a pressure of 100 to 200 mm of H2O above the prevailing atmospheric pressure. In medical work, pressures are often measured in units of mm of H2O because body fluids, including the cerebrospinal fluid, typically have nearly the same density as water. The pressure of the cerebrospinal fluid can be measured by means of a spinal tap. A hollow tube is inserted into the spinal column, and the height lo which the fluid rises is observed, as shown in Figure P9.83. If the fluid ruses to a height of 160. mm, we write its gauge pressure as 160. mm H2O. (a) Express this pressure in pascals, in atmospheres, and in millimeters of mercury. (b) Sometimes it is necessary to determine whether an accident victim has suffered a crushed vertebra that is blocking the flow of cerebrospinal fluid in the spinal column. In other cases, a physician may suspect that a tumor or other growth is blocking the spinal column and inhibiting the flow of cerebrospinal fluid. Such conditions ran be investigated by means of the Queckensted test. In this procedure, the veins in the patients neck are compressed lo make the blood pressure rise in the brain. The increase in pressure in the blood vessels is transmitted to the cerebrospinal fluid. What should be the normal effect on the height of the fluid in the spinal tap? (c) Suppose compressing the veins had no effect on the level of the fluid. What might account for this phenomenon?
If the gauge pressure inside a rubber balloon with a 10.0-cm radius is 1.50 cm of water, what is the effective surface tension of the balloon?
Why is it difficult to swim under water in the Great Salt Lake?