A impedance of Z = 2553.13°Q is connected across a source with a voltage of 169.706 sin (157.080t) volts. For the circuit, find the ff.: (a) R, (b) X, (c) voltage polar form, (d) current polar form, (e) current waveform equation, (f) simplified power waveform equation.

A impedance of Z = 2553.13°Q is connected across a source with a voltage of 169.706 sin (157.080t) volts. For the circuit, find the ff.: (a) R, (b) X, (c) voltage polar form, (d) current polar form, (e) current waveform equation, (f) simplified power waveform equation.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.18P: Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of...

See similar textbooks

Related questions

Q: 1. The average power in a single-phase ac circuit with a purely capacitive load, for sinusaidal-…

Q: (b) Given that a total impedance of a series circuit is Z = 10 – j13 Q and the operating frequency…

A: In this question, Total impedance Z= 10-13j Operating frequency f= 60Hz. Sketch the series and…

Q: FN.Q3 – In the RLC circuit, vs(t) = 330.Sin(628t) Volt, R = 470 , C = 220µF and L = 65 mH. Determine…

A: RLC series circuit, If the voltage Vs is given, Find the RMS value of the source voltage power…

Q: O At the value of K where the system is marginally stable, what are the pole locations? 15j, -6 15j,…

Q: bläs 3 For the admittance locus shown below, if Vs=10Cos4t Volt. Find the maximum power delivered…

A: Given, AB=BCAB=2×0.5AB=1 The value of the admittance, Y1 is given by: Y1=G-jB=1-j The value of the…

Q: A series RLC circuit having values of ? = 250Ω, ? = 3??, and ? = 4?? is shunted across a sinusoidal…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Problem 1: Consider the circuit depicted in the attached figure. The voltage source is an AC source…

A: We have to solve part a and d. a. Expression for Z d. current magnitude at t=6.2 sec given, f=55…

Q: If a Marx generator is required to perform a 170 kV lightning impulse test, and you have capacitors…

Q: Three branches having impedances of Z1, Z2, and Z3 0, respectively, are connected in parallel. TI…

Q: The total impedance Z, of a circuit containung an inductor with inductance L and resistance R in…

A: we need to find out R and L.

Q: A series RLC circuit is connected to an AC power source, as shown in the figure. Given that the…

Q: a) Define the complete response in transient circuits? b) Plot [v() =5u(-t+1) - Su(-t- 1)]? c) What…

A: Note: Since you have posted a question with multiple subparts, we will solve the first three…

Q: 2. In the simple system below, draw the V-Q curve for the load bus if P-D0. What is the maximum…

A: As per the guidelines given, We can only provide the solution of the first question in multiple type…

Q: The characteristic impedance of a losseless transmission line is 60N. Find the inductance of the…

A: DISTORTION-LESS LINE: A line in which a wave propagates without any distortion is called a…

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: A 240-Vrms, 60 Hz source skpplies two loads as shown above. Find the capacitance of a capacitor…

Q: A single phase AC chopper supplies a pure inductive load of 0.02H from 220V, 50HZ AC supply. The…

Q: pure capacitor

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: 1.For one AC Wheatstone bridge at balance, given that ZA= 100 2, ZB=200 2, Zc-150 Q Zp is a ceil…

Q: (a) Calculate the input impedance of the infinite ladder network shown in the figure below. (Z =…

A: (a) Since, the given circuit is of the infinite length and the total impedance of the circuit will…

Q: 2. A delta-connected load with 500 resistance, 209mH inductance and 50µF capacitance in series per…

A: In this question we need to find a phase current of the given three phase circuit.

Q: Draw the power triangle associated with the source, 300230° Vrms. illustrate the apparent, active,…

A: We need to draw the power triangle and calculate the power factor for the given circuit.

Q: Objective 1-Understand ac power concepts, their relationshi 10.4 The load impedance in the circuit…

Q: Q.4. Find the rms value of lo and VAB =? in the circuit shown below.

Q: 10 2 13.263 mH 73.683 µF Figure #6 Figure #6 shows an impedance consisting of resistance, inductance…

A: (a) Write the expression for the voltage when the frequency is in third harmonics and then find the…

Q: FN.Q3- In the RLC circuit, vs(t) = 330.Sin(628t) Volt, R= 470, C=220µF andL=65 mH. Determine the…

Q: For a Cockcroft-Walton voltage multiplier circuit, if Vmax = 460 kV and n = nopt = 14, %3! (i) What…

A: Because of our policy only first 3 questions will be answered;

Q: For the frequency-domain circuit , calculate: 1. a) the rms magnitude of Vo;2. b) the average power…

A: a) the rms magnitude of Vo Applying KCL at point V0 in the given equation we get

Q: Q.1. If an RMS current of 5 A at 60 Hz flows through an inductor of 10 mH, what is its average…

Q: Solution in phasor domain representation is a method that can both consider the steady state and…

A: A phasor is represented only for steady state Two waves are said to be in phase if the phase…

Q: In an electric power system, it is given that the effective impedance of the generator station is Rs…

Q: HW # 7.1 Vp = 50 sin(@t), R1 = 1kN , If the firing angle is 30°, draw %3D Vp=Vm sinot R Vo the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

Q: a) A single-phase AC waveform is represented by the equation; v(t) = 400 sin(3142t + 0.25) V…

Q: 1) For the circuit shown blow， calculate ?_out assuming that ?_1 = 5?Ω ?_2 = 15?Ω and ?_in 12V .…

A: It is given that: R1=5ΩR2=15ΩVin=12 V

Q: Find the instantaneous voltage at 200us of the 10Vpk 1kHz sinusoidal source. v(200us) = ? Volts

A: The solution is given below

Q: 1. Fill in the table by converting the values into the equivalent forms. Unless otherwise specified,…

Q: Given the applied source and network below: a. Determine the sinusoidal expression for the source…

A: The solution can be achieved as follows.

Q: For the circuit shown below, Given that V= 10020°V, and I= 30430°Ams then the values of P2 rms and…

Q: In the Transmission Line Simulator, th Transmission Line is composed of wh parameter/s? O A. The…

A: Transmission line simulator useful to know behaviour of transmission line under various load…

Q: A series circuit of RLC with following parameters, R=15 ohm, L-20 m H Farad. VT=169.7 sin (337t-30)…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

f only

A impedance of Z = 25453.13°Q is connected across a source with a voltage of 169.706 sin (157.080t) volts.
For the circuit, find the ff.: (a) R, (b) X, (c) voltage polar form, (d) current polar form, (e) current waveform
equation, (f) simplified power waveform equation.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is connected at source end which is delivering 0.5 Pu of active power and the transmission line is compensated with a series capacitance of 0.5 Pu. Find the load angle with series capacitance compensation ?
A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this impedance is a series combination of a 120Ω resistor and another passive component. If the circuit has a sinusoidal voltage source whose frequency is 120 Hz. What is the value of the component in series with the 120Ω resistor? (Note: Express the value assuming a metric scaling of μ(10-6). Provide your answer in decimal form, up to 3 decimal places.)
If the values of real power and reactive power is specified for a bus, then it is called as PQ bus. Select one: True False
Let a series RLC network be connected to a source voltage V, drawing a current I. (a) In terms of the load impedance Z=ZZ, find expressions for P and Q, from complex power considerations. (b) Express p(t) in terms of P and Q, by choosing i(t)=2Icost. (c) For the case of Z=R+jL+1/jC, interpret the result of part (b) in terms of P,QL, and Qc. In particular, if 2LC=1, when the inductive and capacitive reactances cancel, comment on what happens.
A source whose voltage is ? (?) = 50√2 cos (?? + 30 °) ? supplies a load of impedance ? = (4 + ?3) Ω. We want to know: a) the active, reactive and apparent power consumed by the load. b) the power of a capacitor that must be installed in parallel with the load to raise its power factor to 0.97 delayed.
Calculate the velocity factor of a coaxial cable used as atransmission line, with the characteristic impedance of 30 ohms,capacitance of 20pF/m and a 80uH/m inductance.
For the configuration shown in the figure below, determine Zi if Vs = 40 mV, Sense = 0.5 kΩ, and Ii = 20 µA
Derive the power angle equation for a power system network and draw the corresponding curve.
The 9 Ω resistor in the circuit is replaced with a variable impedance Zo. Assume Zo is adjusted for maximum average power transfer to Zo. 1. a) What is the maximum average power that can be delivered toZo?2. b) What is the average power developed by the ideal voltage sourcewhen maximum average power is delivered to Zo?3. c) Choose single components from Appendix H to form animpedance that dissipates average power closest to the value in part(a). Assume the source frequency is 60 Hz.
Three branches having impedances of 3+j4 Ω, 16−j12 Ω, and−j4 Ω, respectively, are connected in parallel. What are the equivalent(a) admittance, (b) conductance, and (c) susceptance of the parallelconnection in millisiemens? (d) If the parallel branches are excited froma sinusoidal current source where i=8 cosωt A, what is the maximumamplitude of the current in the purely capacitive branch?
Explain in detail (no mathematical expressions) the following termsused in microwave theory: Characteristics impedance, Dominantmode, Impedance matching, Characteristics admittance
1. For the following sinusoids, determine which one leads and by how much a. ?(?) = 10cos (4? − 60°) and ?(?) = 6sin (4? + 50°)b. ?ଵ(?) = 4cos (377? + 10°) and ?ଶ(?) = −20cos(377?)c. ?(?) = 13 cos(2?) + 5 sin(2?) and ?(?) = 15cos (2? − 11.8°)