10 2 13.263 mH 73.683 µF Figure #6 Figure #6 shows an impedance consisting of resistance, inductance and capacitance being supplied by a non-sinusoidal voltage “v". Given that "v" is given by v = 180Sin377t – 90Sin754t + 60Sin1131t – 45Sin1508t + .. Determine a. The amplitude of the third harmonic of the circuit current “i" b. The active power dissipated in the circuit c. The circuit power factor

10 2 13.263 mH 73.683 µF Figure #6 Figure #6 shows an impedance consisting of resistance, inductance and capacitance being supplied by a non-sinusoidal voltage “v". Given that "v" is given by v = 180Sin377t – 90Sin754t + 60Sin1131t – 45Sin1508t + .. Determine a. The amplitude of the third harmonic of the circuit current “i" b. The active power dissipated in the circuit c. The circuit power factor

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Given the sinusoidal voltage ?(?)=50cos⁡(30?+10?) V. Find the following: (a) the amplitude, ?? (b) the period, T (c) the frequency, f (d) the angular frequency, ? and (e) ?(?) at t=10 ms
Consider the sinusoidal voltagev(t)=150cos(120πt−60∘)V What is the maximum amplitude of the voltage? What is the frequency in hertz? What is the frequency in radians per second? What is the phase angle in radians? What is the phase angle in degrees? What is the period in milliseconds? What is the first time after t=0 that v= 150 V? The sinusoidal function is shifted 125/18ms125/18ms to the right along the time axis. What is the expression for v(t)? What is the minimum number of milliseconds that the function must be shifted to the left if the expression for v(t) is 150sin(120πt)V?
Question 1 a) You are a student of Accra Institute of Technology who is offering the course Signals and Systems. Would you classify a discrete-time sinusoidal signal as periodic or non-periodic? Give reasons for your answer. Support your answer with mathematical formulations if necessary.
24. In time domain represenatation of a signal, a signal with an expression of 220 cos (377t -90) is also equal to +220 sin (377t) True False 25. A phasor can be represented or expressed in either rectangular form (x +j y) or exponential form (z cis n) True False 26. To perform phasor multiplication, its better expressed the phasors in polar form and then get the product of all the individual magnitudes (amplitudes)and get the difference of all the individual arguments (phase angles). True False
For the circuit below, do the analysis in the frequency domain and find the expression for the current in the capacitor iC(t) and the current in the inductor iL(t).Consider the following waveforms for the generator (in volts):a)v1(t) = sintb)v1(t) = costc)v1(t) = 2sint/2+2cos2t. The capacitor makes it easier for the electric current for low or high frequencies? And the inducer?
a) What is the time domain expression for the current? b) If the load impendance is created by an inductor with value L=375 mH, find the phaser voltage Vx? c) If the load impendance is created by a capacitor with value C=16.7 uF, find the phaser voltage Vx?
A series RLC circuit having values of ? = 250Ω, ? = 3??, and ? = 4?? is shunted across a sinusoidal voltage given by the expression ?(?) =200 sin(200?? − 16°) ?. Look for the following: a. The equivalent impedance of the connection b. The phasor and instantaneous current flowing through the connection c. Draw the phasor diagram of the supply voltage and the total current. What is the phase difference of the two? d. What is the phasor and instantaneous voltage across the capacitor? e. If a 75?? capacitor is shunted across the load, what is now the value of the equivalent impedance in the connection?
For the sinusoidal wave form shown, find Vrms?
Q5. For an exhibition project you are designing a circuit of signal processor which can be connected to 230V, 50 Hz supply have a 5.0 H inductor, 80 μ F capacitor and 40Ω resistor kept in series. How can you evaluate the rms current and average power delivered to the circuit? Based on your observation, evaluate the potential drop across capacitance and inductor. Comment about that r m s voltage found in this circuit is less than peak voltage? Justify it with your answer. If you remove the inductor and connect a bulb in series with a capacitor. What will happen to the brightness of bulb if it is connected to DC source and then to an AC source. Assess and find reason for your observations in each case.
A sinusoidal voltage is given by the expressionv=10 cos (3769.91t−53.13∘) V.Find (a) f in hertz; (b) T in milliseconds; (c) Vm; (d) v(0); (e) ϕ indegrees and radians; (f) the smallest positive value of t at which v=0;and (g) the smallest positive value of t at which dv/dt=0
Please answer quickly "Usually and by convention in computation, a practical inductor has both inductance and internal resistance connected in parallel." True False "To perform phasor multiplication, its better expressed the phasors in polar form and then get the product of all the individual magnitudes (amplitudes)and get the difference of all the individual arguments (phase angles)." True False "In time domain represenatation of a signal, a signal with an expression of 220 cos (377t -180) is also equal to +220 cos (377t)." True False
A resistor, an inductor, and a capacitor are connected in parallel to an ac source with voltage amplitude V and angular frequency v. Let the source voltage be given by v = Vcosvt. (a) Show that each of the instantaneous voltages vR, vL, and vC at any instant is equal to v and that i = iR + iL + iC, where i is the current through the source and iR, iL, and iC are the currents through the resistor, inductor, and capacitor, respectively. (b) What are the phases of iR, iL, and iC with respect to v? Use current phasors to represent i, iR, iL, and iC. In a phasor diagram, show the phases of these four currents with respect to v. (c) Use the phasor diagram of part (b) to show that the current amplitude I for the current i through the source is I = √(I2R) + (IC - IL)2 . (d) Show that the result of part (c) can be written as I = V/Z, with 1/Z = √ (1/R2) + [ωC - (1/ωL)]2.