Help quickly Q.4. Find the rms value of lo and VAB =? in the circuit shown below.0.40201.60780J640277 <-120www1.602.6024077a277 < 120ww mr0.80020w1.20790

Answered: Image /qna-images/answer/99e326ee-badd-4629-b254-daa06a9ec2e8.jpg

Answered: Q.4. Find the rms value of lo and VAB…

Engineering

Electrical Engineering

Q.4. Find the rms value of lo and VAB =? in the circuit shown below.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 2, (b)…

A: In this question, find the instantaneous current with different different impedance. Draw the…

Q: Question 5 If a current 5.0 A lags the applied voltage 230 V by an angle o, it can be resolved into…

A: The solution can be achieved as follows.

Q: ll For the circuit shown R = 2 Q and L = 10 mH connected to a %3D sinusoidal voltage of an RMS value…

Q: Discuss the following term in a reactive circuit: a. Real Power b. Apparent Power c. Power Factor

Q: For the circuit shown, what is the complex power, S, consumed by the load impedance? (Assume the…

A: The complex power is given by: S=VI*where,I* is conjugate of current I. Given: Vs=150∠0°R=15ΩC=150…

Q: Two loads are placed in parallel across a 120Vrms 60Hz line. The first load draws 150VA at a Lagging…

Q: What is the equation of the current in B in the function of sin given that Two electric devices A…

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: VAvg= 2V/pi VRMS=V/sqrt(2) Where V= peak voltage

Q: 1. How much value of capacitance should you place to correct the power factor of a load consisting…

Q: When the average real power absorbed by an impedance is zero, then the impedance is: Select one: O…

A: The real power is absorbed by the resistor only when there is a combination of inductor and…

Q: An ac motor with impedance Z, (4.0 A40) O is supplied by an RMS value of 220-V, 60-Hz source. You…

A: According to question: The real power taken by the load is calculated as

Q: A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this…

A: Impedance: Impedance of a circuit is the combination of all the resistance as well as reactance. It…

Q: A sinusoidal 50 Hz voltage of 200 V (rms) supplies the following three circuits which are in…

Q: (a) Maximum values of v(t) and i(t); (b) The Root-Mean-Square (rms) values of v(t) and i(t); (c) The…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

Q: Two sinusoidal voltages of the same frequency have rms values of 8 V and 3 V. What is the smallest…

A: As the phase angles are unknown, the maximum RMS value can be,

Q: Implement the given circuit as shown using Falstad Simulation. R Find the RMS Voltage across the 15…

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: During positive half cycle ,diode is reverse biased and out put =input. Diode forward biased and…

Q: Prove that, neutral capacitance is twice of line to line capacitance

A: The capacitance between one of the conductors and a neutral point is known as neutral capacitance or…

Q: Find the following in rectangular form: a. What is the real power delivered by the source (in W)? b.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q Find the capacitance C necessary to improve the power factor to 0.95 lagging in the circuit shown…

Q: Discuss the following term in reactive circuit? a) Real power b) Apparent power G) Power factor 1.

Q: A load connected to a 120 Vrm source is drawing 1,600 VA at 0.6 power factor lag. a) What is the…

Q: When connected to a 120-V (rms), 60-Hz power line, an inductive load absorbs 4 kW at a lagging power…

A: Given as per the circuit,Power factor = 0.8cosϕ1=0.8ϕ1=cos-1(0.8) = 36.87°where ϕ1 is the phase…

Q: The given data to be used for getting the RMS Values is 0, 5, 10, 30, 50, 70, 50, 30, 10, 5, 0, -5,…

A: In this answer we will find the RMS value using all the given values as explained below. The RMS…

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

Q: An electromagnet is modeled as L=0.3H and R=200 in series, and connected to a 120V(rms) sinusoidal…

A: Solve the above questions

Q: (a). Write the instantaneous currents across the three circuit elements in terms of Vm amp > angular…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

Q: 15 Ω woa юа 10j Q 10210° Awgk/rms

Q: 800 turns while the other What is the current (in A rms) at t de has 450 turns. The high pltage side…

Q: , reactive and apparent power consumed by the lo

A: The given load is an RL load that means the power factor of the load is lagging in nature means the…

Q: For the circuit shown, what is the complex power, S, average power, P,av, and reactive power, Q,…

Q: 10 2 13.263 mH 73.683 µF Figure #6 Figure #6 shows an impedance consisting of resistance, inductance…

A: (a) Write the expression for the voltage when the frequency is in third harmonics and then find the…

Q: For the circuit shown, what is the average power, Pay, delivered by the voltage source? (Assume the…

Q: The circuit shown in Figure Q5.1 consists of a current source connected to a load via a cable. The…

A: Given circuit is - Value of current source is -

Q: five infinite-impedance volunteers,calibrated to read rms values,are connected as shown below. let…

A: First, convert the parameter of the passive elements connected in the circuit in the same unit in…

Q: For a source which has: • Vrms = 345 V • P= 8195 W • pf = 0.95 What is the rms current?

A: In this question we need to find RMS current .

Q: A pure inductor of 20.0 mH is connected to a source of 220 V. Find the RMS value of current in the…

A: Given, Source voltage, Vsrms=220 V Inductance, L = 20 mH Frequency of source, f = 50 Hz

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

Q: Calculate: Reactive, apparent and active power of the circuit, consider the power supply 120V rms…

Q: Compute the expected power factor of the circuit given the different capacitance.

Q: R1 3002 V1 |120Vrms C1 60HZ 8.84uF 0°

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

Q: Determine the total equivalent impedance of the circuit as shown. Note: the student must put the…

A: In this question, choose the correct option All are parallel branches so What is equivalent…

Q: Find the RMS value of the source voltage, Reactance of C (Xc), Total Impedance, Current in the…

A: In this question, We need to Find the RMS value of the source voltage, Vrms = Vm /√2 Reactance of C…

Q: a-Calculate and draw the load current for the steady-state condition b-Find the RMS values of the…

A: It is given that: Vs=300 Vf=50HzRL=2 ohmL=0.04 H

Q: 4. A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 n,…

Q: For a source which has load has the following characteristics: • Vrms = 125 20° V • P= 400 W • pf =…

A: In this question we will find current and reactive power. .

Question

Help quickly

Q.4. Find the rms value of lo and VAB =? in the circuit shown below.
0.40
20
1.60
780
J640
277 <-120
www
1.60
2.60
240
77a
277 < 120
ww mr
0.80
020
w
1.20
790

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the rms value of the signal shown
Consider the sinusoidal voltage: v(t) = 125cos (250πt –25°) V. a.What is the maximum amplitude of the voltage? b.What is the frequency in hertz? c.What is the angular frequency in radians per second?
The given data to be used for getting the RMS Values is 0, 5, 10, 30, 50, 70, 50, 30, 10, 5, 0, -5, -10v. Find the RMS value.
Find the steady-state expression for vo(t) if vg=30sin50,000tV. Suppose that vo(t)=V0cos(ωt+ϕ), where −180∘<ϕ≤180∘.Determine the values V0,ω, and ϕ.
find the rms
Consider the following equation: v (t) = 110 sin(78.5 t) Calculate: Frequency (f) = ? Time period (T) = ? Peak Voltage (Vp) = ? Average voltage (VAVG) = ? RMS voltage (VRMS) = ? Sketch the labelled waveform showing Peak voltage, full cycle and half-cycle times.
A transformer has a ratio of 4:1. The high voltage side is connected to a 240 Vrms source. The low voltage side (secondary) is connected to an impedance ZL = 20 + j10 Ω.a. (in Vrms) What is the value of the source voltage when referred to the secondary? b. (in A rms) What is the current at the secondary?c. (in V rms) What is the voltage at the secondary?
The rms value of the sinusoidal voltage supplied to the convenienceoutlet of a home in the United States is 120 V. What is the maximumvalue of the voltage at the outlet?
a) What is the time domain expression for the current? b) If the load impendance is created by an inductor with value L=375 mH, find the phaser voltage Vx? c) If the load impendance is created by a capacitor with value C=16.7 uF, find the phaser voltage Vx?
The rms output voltage of an AC source is 150 V and the operating frequency is 90 Hz. Which of the following equation gives the output voltage as a function of time? a. (150 ?) sin(283?)b. (150 ?) sin(565?)c. (212 ?) sin(283?)d. (212 ?) sin(565?)
Consider the sinusoidal voltage v(t)=100cos(1000nt-65°)V. A. What is the maximum amplitude of the voltage? B. What is the frequency in HERTZ and in RADIANS PER SECOND? C. What is the phase angle in RADIANS and in DEGREES?
The root mean square (or RMS) is anothermeasure of average value, often used with oscillating functions(for example, sine and cosine functions that describe the current,voltage, or power in an alternating circuit). The RMS of a function ƒ on the interval [0, T] isCompute the RMS of ƒ(t)= A sin(Ѡt), where A and v arepositive constants and T is any integer multiple of the period ofƒ, which is 2∏/Ѡ.