A laboratory on the concept of static equilibrium uses an apparatus called a force table. The force table consists of a round, level platform marked in degree increments about its circumference. In the center of the table sits a massless ring, to which three strings are tied. Each string is strung over a m, separate pulley clamped to the edge of the platform, and then tied to a freely-hanging mass, so that each string is under tension and the ring is suspended parallel to the table surface. m, m, A mass of m1 0.153 kg is located at 0, 26.5°, and a second maSs of m2 0.223 kg is located at 0, 279°. Calculate the mass m3 and the angular position 03 (in degrees) that will balance the system and hold the ring stationary over the center of the platform. kg B৪৪ m3 03

A laboratory on the concept of static equilibrium uses an apparatus called a force table. The force table consists of a round, level platform marked in degree increments about its circumference. In the center of the table sits a massless ring, to which three strings are tied. Each string is strung over a m, separate pulley clamped to the edge of the platform, and then tied to a freely-hanging mass, so that each string is under tension and the ring is suspended parallel to the table surface. m, m, A mass of m1 0.153 kg is located at 0, 26.5°, and a second maSs of m2 0.223 kg is located at 0, 279°. Calculate the mass m3 and the angular position 03 (in degrees) that will balance the system and hold the ring stationary over the center of the platform. kg B৪৪ m3 03

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

In an earlier step, an FBD was created for the bottom-most block under the assumption of equilibrium. Which statement best describes the modifications necessary if that FBD is redrawn under the assumption ay<0? The weight vector labeled F g,1 would be unchanged. The normal-force vector labeled Fn,f→1 would become shorter, but the normal-force vector labeled Fn,2→1 would become shorter by a greater amount. The weight vector labeled F g,1 would change length, becoming shorter, but the normal-force vectors would be unchanged. The diagram requires no changes because all of the forces remain the same. The weight vector labeled Fg,1 and the normal-force vector labeled Fn,2→1 would be unchanged, but the normal-force vector labeled Fn,f→1 would become shorter. Because things feel partially weightless in the elevator, all three vectors would be shorter. The weight vector labeled Fg,1 would be unchanged. The normal-force vector labeled Fn,2→1 would become longer, but…
A 400-gram package lying on a horizontal surface is attached to a horizontalstring which passes over a smooth pulley.When a mass of 200 grams is attached to the other end of the string,the package is on the point of moving.Find , the coefficient of friction.
a hanging lamp of weight 50 N hangs from a chord that is knotted at point O to other chords, one fastened to the ceiling and the other to the wall. We want to find the tension in three chords, assuming the weight of the chords to be negligible
A block with a mass m is pushed up an inclined rough surface by a horizontal force F as shown. If the block is being pushed up at a constant speed, find the magnitude of the applied force F, given that theta =35 degrees , m = 5 kg, and the kinetic frictional coefficient between the block and the inclined surface mu_k = 0.2
Let's consider a ring with a diameter of 0.1 m and a total load of -2 mC. The ring lies in the x-y plane, with its center at the origin. What is the force on a 1 mC load located at z = 3 m? In what direction would the force be on this load if it were in the x-y plane, but outside the ring?
A block of mass m is pulled along a rough horizontal floor by an applied force P as shown. The normal force N is :
It is intended to remove a stake from the ground by means of two ropes, as shown in the figure. Knowing the magnitude and direction of the force exerted on one string, determine the magnitude and direction of the force P that must be exerted on the other string if the resultant of the two forces is to be a 40-lb vertical force.
An object, of mass m, is attached to a spring balance and its weight, w, measured and recorded. What will be the result if the object is taken to the Jupiter and weighed there where the gravitational field strength is greater?
Oceanographers use submerged sonar systems, towed by a cable from a ship, to map the ocean floor. In addition to their downward weight, there are buoyant forces and forces from the flowing water that allow them to travel in a horizontal path. One such submersible has a cross-section area of 1.3 m2, a drag coefficient of 1.2, and, when towed at 5.1 m/s, the tow cable makes an angle of 30° with the horizontal. What is the tension in the cable?
In about 1915, Henry Sincosky of Philadelphia suspended himself from a rafter by gripping the rafter with the thumb of each hand on one side and the fingers on the opposite side. Sincosky’s mass was 79 kg. If the coefficient of static friction between hand and rafter was 0.70, what was the least magnitude of the normal force on the rafter from each thumb or opposite fingers? (After suspending himself, Sincosky chinned himself on the rafter and then moved hand-over-hand along the rafter. If you do not think Sincosky’s grip was remarkable, try to repeat his stunt.)
A traffic signal is supported by two cables, each of which makes an angle of 40.0 degrees with the vertical. If each cable can exert a maximum force of 7.50 * 10^2 N, what is the largest weight they can support?
Consider a pair of forces, one having a magnitude of 20N and the other magnitude of 12N .What maximum net force is possible for these two forces? What is the minimum net force possible?