A lightning bolt discharges 3.0 x 1021 electrons in 300 s. What is the average current during thedischarge? Take e 1.6 x 10-19Ca. 1.6 Ab. 96 AC. 1.25 Ad. 0.625 AOc3. What is the potential difference across each of the 10 2 resistors in the diagram shown below?12 V20.022.0010.0 02.a. 0.8 Vb. 4.0 Vc. 8.0 Vd. 16 VOd

Answered: Image /qna-images/answer/b3c2ae0a-ff50-4df9-9a10-65186cf9ecc0.jpg

Answered: A lightning bolt discharges 3.0 x 1021…

A lightning bolt discharges 3.0 x 1021 electrons in 300 s. What is the average current during the discharge? Take e 1.6 x 10-19C a 1.6 A b. 96 A C. 1.25 A d. 0.625 A 3 O a

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter26: Current And Resistance

Section: Chapter Questions

Problem 50CP: Material with uniform resistivity is formed into a wedge as shown in Figure P26.50. Show that the...

See similar textbooks

Related questions

Q: 3.7×1020 electrons are flowing past any point in a wire per minute (electron charge = -1.6×10-19 C).…

A: Given : Number of electron , N = 3.7*1020 Time, t = 1 minute = 60 s electron charge, q…

Q: The quantity of charge q (in coulombs) that has passed through a surface of area 2.05 cm2 varies…

A: Area of the surface is A = 2.05 cm2 The equation of charge is q = 8t3-5t+6 Time of flow is t = 0.900…

Q: A flashlight uses batteries that add up to 1.5 V and has a power output of 0.53 W. (a) How much…

A: Voltage = 1.5 volts Power output = 0.53 W

Q: Can someone help me solve this problem? A 9.00-V battery delivers a current of 1.27 A to the…

Q: A Healt defibrillator is used to enable the heart to start beating if it has stopped. This is done…

Q: A total of 2.0 x 1013 electrons pass a given point in a wire in 15 s. What is the current in the…

Q: A silver wire 2.6 mm in diameter transfers a charge of 420 C in 80 min. Silver contains 5.8 x 1028…

Q: typical lightning bolt may last for 0.172 s and transfer 1.05 ✕ 1020 electrons. Calculate the…

A: Given: The time interval is 0.172 s. The number of electrons is 1.05x1020.

Q: The quantity of charge q (in coulombs) that has passed through a surface of area 2.10 cm2 varies…

Q: A 5MV battery is connected across a load having a Resistance of 180 KQ. How much current flowing in…

A: Given that the value of voltage and resistance.Then We have to determine the the current flowing in…

Q: A current of 2 A flows through a gold wire with a radius of 3 cm and a length of 15 m. There are…

A: Current (I) = 2 A radius (r) = 3 cm Length (L) = 15 m number of free electrons per unit volume =…

Q: The human body can exhibit a wide range of resistances to current depending on the path of the…

A: Current electricity is the flow of electrons in a conductor. The potential generated when a current…

Q: (1) A silver wire 1.00 mm in diameter transfers a charge of 65.0 C in 1 hr. 15.0 min. Silver…

Q: An aluminum wire having a radius of 7.53 mm and carrying a current of 86.2 mA is connected in a…

A: let the density of the electrons is denoted by n, the charge of electrons is denoted by e, the…

Q: A 12-V car battery is used to power a 20.00-W, 12.00-V lamp during the physics club camping…

Q: A 120 V potential difference is applied to a space heater whose resistance is 19Q when hot. (a) At…

Q: 1.00 M2 A conducting sphere is charged by an emf source & through a 1.00 MQ resistor. When the…

A: Given Resistance is R=1.00×106 Ω Charge is Q=1.00×10-6 C Current is I=1×10-3 A Permittivity of free…

Q: A typical lightning bolt may last for 0.187 s and transfer 1.03 ✕ 1020 electrons. Calculate the…

Q: The quantity of charge q (in coulombs) that has passed through a surface of area 2.10 cm2 varies…

Q: A 120 V potential difference is applied to a space heater whose resistance is 17 Q when hot. (a) At…

Q: A 120 V potential difference is applied to a space heater whose resistance is 15 Q when hot. (a) At…

A: Given Voltage V=120V Resistance R=15Ω

Q: A steady current of 2.5 A exists in a wire for 4.0 min, (a) How much total charge passed by a given…

Q: 1.15 When a car has a dead battery, it can often be started by connecting the battery from another…

A: Given: v=12vI=40At=1.5min=90s

Q: A current of 10.0 A is flowing in a wire. (a) In 1.00 min, how many coulombs of charge pass by a…

Q: PROBLEM 1: A silver wire 2.6 mm in diameter transfers a charge of 420 C in 80 min. Silver contains…

A: Given that, Diameter of wire = 2.6 mm Charge = 420 C Time = 80 min Number of electron = 5.8×1028

Q: Currents up to 30 A can be carried by 10 gauge copper wire. (a) What is the resistance of 80 m of 10…

Q: A 9.0 V battery supplies a 2.5 mA current to a circuit for 5.0 h. a. How much charge has been…

A: a) If q amount of charge is transferred from the negative to the positive terminal within time t…

Q: The graph shows the current through a 1.0 Ω resistor as a function of time.a. How much charge flowed…

A: Given Resistance R = 1.0 Ω

Q: A 120 V potential difference is applied to a space heater that dissipates 438 W during operation.…

Q: Some makes of older cars have 6.00 V electrical systems. (a) What is the hot resistance (in 0) of a…

Q: 1. Consider a cylindrical wire that has conduction electron density 6.0 x 1028 and radius 0.5 mm. An…

A: The average velocity obtained by charged particles (e.g. electrons) in a material owing to an…

Q: An electric car is designed to run off a bank of 12.0-V bat- teries with total energy storage of…

Q: A total of 2.0 × 1013 electrons pass a given point in a wire in 15 s. What is the current in the…

A: Given, Total 2.0 × 10^13 electrons Passing time=15 sec qe = 1.6x10-19 C Current is defined as rate…

Q: 30. A high-energy proton accelerator produces a proton beam with a radius of r = 0.90 mm. The beam…

Q: An electric clothes dryer has a heating element with a resistance of 8.6 2. (a) What is the current…

A: Resistance of the heating element is R=8.6 Ω Voltage is V = 240 V Current (I) in the element is…

Q: The lightbulb in the circut diagram above has a resitance of 1.0 ohm. Consideter the potetial…

A: (A) Write the Ohm’s law.

Q: A 9.0 V battery supplies a 1.5 mA current to a circuit for 5.0 h.(a) How much charge has been…

A: Given : V = 9.0 V I = 15 mA = 0.0015 A t = 5.0 h = 5 x 3600 = 18000 seconds

Q: A steady current of 2 mA flows through a wire. How much charge passed through the wire in three and…

Q: In a wire with a 2.17 mm² cross-sectional area, 7.19 × 1020 electrons flow past any point during…

Q: Using Kirchhoff's rules (and given E = 70.1 V, E2 = 61.7 V, E3 = 79.6 V) calculate the following.…

Q: The quantity of charge q (in coulombs) that has passed through a surface of area 2.10 cm² varies…

A: Write the given values with the suitable variables. A=2.10 cm2=2.10×10-4 m2q=4t3+5t+6t=0.9 s Here,…

Q: 22. 1. If electricity costs 15 Bz per kilowatt - hour, how much does it cost to operate a 220 V…

Q: A 9.0 V battery supplies a 2.5 mA current to a circuit for 5.0 h.a. How much charge has been…

A: Given data The potential difference of the battery is Vo=9.0 V The current is Io=2.5 mA The time is…

Q: If 3.0 x 1015 electrons flow through a section of a wire of diameter 2.0 mm in 2.0 s, what is the…

A: Given, n=number of electron=3×10^15 Time=2s

Q: 1. Consider a cylindrical wire that has conduction electron density 6.0 × 1028 4 and radius 0.5 mm.…

A: Electron density n = 6.0×1028 m-3 Radius of wire r = 0.5 mm = 5×10-4 m Current i = 4.8×1017…

Question

100%

A lightning bolt discharges 3.0 x 1021 electrons in 300 s. What is the average current during the
discharge? Take e 1.6 x 10-19C
a. 1.6 A
b. 96 A
C. 1.25 A
d. 0.625 A
Oc
3.

What is the potential difference across each of the 10 2 resistors in the diagram shown below?
12 V
20.02
2.00
10.0 0
2.
a. 0.8 V
b. 4.0 V
c. 8.0 V
d. 16 V
Od

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

We are directed to solve only 1st question

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

For the circuit shown in Figure P28.24, calculate (a) the current in the 2.00-11 resistor and (b) the potential difference between points a and b.
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
In the circuit of Figure P28.30, determine (a) the current in each resistor and (b) the potential difference across the 200- resistor.
Consider the circuit shown in Figure P18.11. Find (a) the potential difference between points a and b and (b) the current in the 20.0- resistor. Figure P18.11
When resistors with different resistances are connected in parallel, which of the following must be the same for each resistor? Choose all correct answers, (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
The current-versus-voltage behavior of a certain electrical device is shown in Figure OQ27.9. When the potential difference across the device is 2 V, what is its resistance? (a) 1 (b) 34 (c) (d) undefined (e) none of those answers
Consider the combination of resistors shown in Figure P18.8. (a) Find the equivalent resistance between point a and b. (b) If a voltage of 35.0 V is applied between points a and b, find the current in each resistor. Figure P18.8
Why is the following situation impossible? A technician is testing a circuit that contains a resistance R. He realizes that a better design for the circuit would include a resistance 73R rather than R. He has three additional resistors, each with resistance R. By combining these additional resistors in a certain combination that is then placed in series with the original resistor, he achieves the desired resistance.
Three 100- resistors are connected as shown in Figure P21.41 The maximum power that can safely be delivered to any one resistor is 25.0 W. (a) What is the maximum potential difference that can be applied to the terminals a and b? (b) For the voltage determined in part (a), what is the power delivered to each resistor? (c) What is the total power delivered to the combination of resistors?
Choose the words that make each statement correct. (i) When two or more resistors are connected in series, the equivalent resistance is always [(a) greater than; (b) less than] any individual resistance. (ii) When two or more resistors are connected in parallel, the equivalent resistance is always [(c) greater than; (d) less than] any individual resistance.
Using Kirchhoffs rules, (a) find (he current in each resistor shown in Figure P28.51 and (b) find the potential difference between points c and f.
Three 60.0-W, 120-V lightbulbs are connected across a 120-V power source, as shown in Figure P18.50. Find (a) the total power delivered to the three bulbs and (b) the potential difference across each. Assume the resistance of each bulb is constant (even though, in reality, the resistance increases markedly with current). Figure P18.50