Answered: A line was measured by EDM found…

A line was measured by EDM found 4032.32 m, what is the probable error in this distance if the EDM precision is t (2 mm+3 ppm)?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter1: Introduction: The Nature Of Science And Physics

Section: Chapter Questions

Problem 20PE: (a) A person's blood pressure is measured to be 1202 mm Hg. What is its percent uncertainty? (b)...

See similar textbooks

Related questions

Q: The area of a round tabletop is computed from a measurement of its radius. If the fractional…

A: A= πr2

Q: the answer is 5 sigfigs. what is the correct answer in 3 sig figs?

A: Given θr = 26.016 °

Q: 5.6 A pipe with a 16 in. diameter carries water having a veloc- ity of 3 ft/s. What is the discharge…

Q: When reading a digital device, which of the following would be an appropriate decimal place to…

A: Random error arise from the fluctuations which are most easily observed by making multiple trials of…

Q: A radiographic exposure of the chest was taken at 72 inches and had an exposure of 50 mR What would…

Q: In a Measurement ,the Expected value is 56 V and the measured value is 52 V. Find (i) Absolute error…

A: Given Expected value. Is 56 Measured value is 52.

Q: Using this equation g=4pi^2/T^2 Determine the slope of the best-fit line and solve for g. These are…

Q: th of a baseline is 402.267 m. A mean observation for the distance is 402.251 m with a standard…

A: Given values:- Calibrated length of a baseline,(CL)=402.267 m ----(1) Mean observation…

Q: Why using within '2-measurement standard deviations' is preferred instead of comparing it to…

A: In this question we have to answer why standard deviation is preferred over comparing with…

Q: A series of four measurements of the ratio of the circumference to diameter of a disk are made. The…

A: The result of these measurement are as below. 3.140, 3.133, 3.132, 3.133 The experimental value is…

Q: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…

A: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…

Q: Given the most probable value of a quantity to be 35.86. If the Error Ratio is 1:163, What is the…

A: Suppose quantity is E . So by error analysis Relative error in( E )= ∆E/E

Q: Given the following measurements (in metric and English respectively) of a metal cylinder: length =…

Q: How to calculate 1/a exp?

A: Required : Value of 1/aexp We can find 1/aexp by taking the reciprocal of aexp . The table of…

Q: Questions 1. What is the conversion factor between kg/m' and g/cm"? Express your experimental values…

A: Given a) convert kgm3 into gcm3b)mass density of mercury=13,6gcm3diameter(containig mercury)…

Q: what is the relationship between precision and uncertianity in a measurement?

A: Measurement Uncertainity has following parameters: 1) Precision : It given an idea about the…

Q: If the standard deviation of a sample is given to be 62.5 then find its variance.

A: Standard deviation is the square root of variance. Therefore variance is the square of standard…

Q: Find the average, variance and the standard deviation for the following: 1.23, 1.24, 1.18, 1.19,…

Q: Given that P = Find the maximum percentage error in calculating P if the percentage error in…

Q: Do percent errors and percent difference give indications of accuracy or precision?

A: Accuracy is a measure of the degree of closeness of a measured or calculated value to its actual…

Q: An infant’s pulse rate is measured to be 130 ± 5 beats/min. What is the percent uncertainty in this…

A: Formula for calculating percent uncertainty can be express as - Where

Q: Calculate B(0). Draw B (measured values)- n curve for current 1A (remarks: see Fig2 and equation 2…

A: B=nμ0 I2R μo=4π x10-7 T.m/A When n=75 : B = 3.623 mT When n=150 B= 7.246 mT When n=300 B= 14.49 mT

Q: When measuring a shaft with a specified diameter of 0.50 ± 0.01, what minimum descrimination should…

A: Given that, A shaft with a specified diameter of 0.50 ± 0.01. We need to find the minimum…

Q: in the Potentiometer experiment, which of the tollowing must bo true cbout the wire on themeter…

A: in the potentiometer experiment the wire used must have uniform cross sectional area. Option A is…

Q: An infant’s pulse rate is measured to be ( 132 ± 6 ) beats/min. What is the percent uncertainty in…

A: Given Data: The pulse rate is measured as: 132±6 beats/min

Q: In a Measurement ,the Expected value is 72 V and the measured value is 63 V. Find (i) Absolute error…

A: (i) The absolute error is given by : (ii) The relative error is given by :

Q: The same data was then plotted, and the standard deviation was found the be 0.0894 cm. Find the…

Q: Find the greatest possible error of each measurement below. (a) 6.15 mm (b) 538538 in

A: Write the expression for the greatest possible error (GPE). GPE=precision2 Precision is the smallest…

Q: No. of Sig Figs Uncertainty 1125 cm 6.010 m? 2600. kg | |

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Therefore, what can you conclude about percent error values that are lower, compared to higher? What…

A: Error percentage is given as, Error Percentage = ((Measured Value - Actual value )/Actual Value )x…

Q: Is the formula dimensionally correct E=1/2 mv

Q: A cell membrane is 4.81 nm thick. How thick is it in inches?

A: The given dimension is Now, from unit conversions, we know that

Q: You repeat a measurement that contains random error many times, construct a histogram of your…

A: Given: Full Width Half Measurement of the histogram is = 1.9…

Q: A series of four measurements of the ratio of the circumference to diameter of a disk are made. The…

Q: You are tasked to measure a 2.1 m door with using only a ruler. On your first try, you recorded a…

Q: WHAT IS THE ERROR FORMULA FOR THIS 3 y = 27³ у O

Q: You are tasked to measure a 2.1 m door with using only a ruler. On your first try, you recorded a…

Q: From the data obtained by a group of students below, compute the experimental densit of the material…

A: Given:- The standard density of the capper is =8.9 g/cm3 Diameter of the copper D= 3.25 cm =3.25 X…

Q: (4i+2j)cross(2i-3j) find it's cross product?

A: Solution: a = (4i+2j) b = (2i-3j) to find the cross product

Q: The table shows the set of five measurements recorded in a laboratory. The precision of 3rd…

A: Precision tells us to what resolution or limit, the quantity is measured by a measuring instrument…

Q: Pound per square.inch, psi (1psi = 6895 Pa) true O False

A: Given data: 1 psi Required: Convert 1 psi to Pa

Q: he measurement of the brass cylinder is taken. The diameter is 2.0 cm, height is 4.0 cm, and nass is…

Concept explainers

Half Life

The concept of Half Life has numerous practical applications some of them includes figuring out the effective drug dosage to finding out when a radioactive becomes safe to use. If you look for a career in Nuclear Physics you will need this concept.

Question

1) A line was measured by EDM found 4032.32 m, what is the probable error in this distance if
the EDM precision is + (2 mm+3 ppm)?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A good-quality measuring tape can be off by 0.50 cm over a distance of 20 m. What is its percent uncertainty?
(a) A person's blood pressure is measured to be 1202 mm Hg. What is its percent uncertainty? (b) Assuming the same percent uncertainty, what is the uncertainty in a blood pressure measurement of 80 mm Hg?
When nonmetric units we used in the United Kingdom, a unit of mass called the pound-mass (lbm) was used, where 1 lbm = 0.4539 kg. (a) If there is an uncertainty of 0.0001 kg in the pound-mass unit, what is its percent uncertainty? (b) Based on that percent uncertainty, what mass in pound-mass has an uncertainty of 1 kg when converted to kilograms?
What is the precision of 0.003000 cm
A good-quality measuring tape can be off by 0.50 cm overa distance of 20 m. What is its percent uncertainty?
A measurement of the circumference of a disk has an uncertainty of 2.6mm. How many mea-surements must be made so that this circumference can be estimated with an uncertainty of only0.52 mm?
When measuring a shaft with a specified diameter of 0.50 ± 0.01, what minimum descrimination should the measuring device have?
What, roughly, is the percent uncertainty in the volume of a spherical beach ball of radius r = 0.84 ± 0.04 m?
A series of four measurements of the ratio of the circumference to diameter of a disk are made. The results of these measurements are: 3.140, 3.133, 3.132, 3.133. The average of the four measurements is the experimental value for Pi-Lab and the accepted value is Pi = 3.141. What is the percent error of these measurements? a) 1 % b) 2% c) 0.5% d)0.2%
If f(x) = x2-7x+10, then what is the minimum value of f(x)?
2 sig figs only
The error in two readings of A are 0.01 and -0.03, then mean absolute error is ?