A link has a transmission speed of 1010 bits/sec. It uses data packets of size 2000 bytes each. The efficiency of the stop-and-wait protocol in this setup is exactly 30%. Determine the value of the one-way propagation delay in milliseconds. Assume that the acknowledgement has negligible transmission delay, and its propagation delay is the same as the data propagation delay. Consider the same transmission speed and packet size for Go back-N protocol with window size 8 and find the channel utilization

Q: Consider two systems A and B connected with each other and bound to stop and wait protocol. System A…

A: in stop and wait protocol ,packet lost during transmission  is the only packet retransmitted…

Q: Consider a reliable data transfer protocol that uses only negative acknowledgments. Suppose the…

A: Justification: A NAK-only protocol is not preferable to a protocol that uses ACKs especially when…

Q: Consider a channel that can lose packets but has a maximum delay that is known. Modify protocol…

A: FSM of modified RDT 2.1 that includes sender timeout and retransmits:

Q: Consider a half-duplex point-to-point link using a stop-and-wait scheme, in which a series of…

A: Half duplex data transmission means that data can be transmitted in both directions on a signal…

Q: Consider the Go-Back-N and selective-repeat protocols, suppose the sequence number space is of size…

A: • Go Back N allows the transmission of new packets before earlier ones are acknowledged.• Go back N…

Q: Assume that there are only two stations, A and B, in a bus CSMA/CD network. The distance between the…

A: The Answer is in Below steps

Q: Once the media information reaches the receiver, it must be played out at the right time. In…

A: Problems: Difficult to find the distribution of the jitter variables. The latency added by the…

Q: Data packets containing 100 bits are transmitted over a communication link. Given that the…

A: Data packets containing 100 bits are transmitted over a communication link. Given that the…

Q: Consider the rdt 3.0 protocol. Draw a diagram showing that if the network connection between the…

A: Message exchange using rdt 3.0 protocol: The below diagram represents a network connection between…

Q: Consider the task of developing a reliable protocol. If we assume the CRC code used is capable of…

A: CRC stands for Cyclic Redundancy Check which is an error control method. This contains generator…

Q: Consider there are 4 stations in the token ring. There is only one packet in the ring. Suppose if…

A: Token ring:- A token ring network consists of a local area network (LAN) whereby all the computers…

Q: Consider there are 4 stations in the token ring. There is only one packet in the ring. Suppose if…

A: The given case is of delayed token transmission, where the transmitter or sender is sending the…

Q: A link has a transmission speed of 106 bits/sec. It uses data packets of size 1000 bytes each.…

A: Given: A link has a transmission speed of 106 bits/sec. It uses data packets of size 1000 bytes…

Q: Consider the Go-Back-N (GBN) and Selective Repeat (SR) protocols with a sender window size of 4 and…

A: Only the ACKs of the first and last packets, in the sender window size, reached the destination.

Q: In a network, If P is the only packet being transmitted and there was no earlier transmission, which…

A: Question. In a network, If P is the only packet being transmitted and there was no earlier…

Q: 3.1 Consider a Go-Back-N ARQ protocol, whereby the window size is 6. Segments with sequence numbers…

A: Dear Student, According to Go-Back-N ARQ protocol if acknowledgment is not received for a single…

Q: In a network, two systems are connected and the distance between the system is 5000 km. The…

A: Given that, Distance= 5000 Km Propagation speed= 2*107 m/s Bandwidth= 500 Mbps Packet size= 108 bits…

Q: Consider two nodes (A, B) sharing the same broadcast channel of speed R =10Mbps. The propagation…

A: Given that, Nodes A and B are share same Broadcast address. Bandwidth of the channel= 10 Mbps…

Q: Assume that there is a constant roundtrip delay between the sender and the recipient, and that the…

A: Introduction: Consider the RDT 3.0 protocol, which is used to securely convey data from a sender to…

Q: Suppose that KJ sends 3596 back-to-back packets, with each packet composed of 14,000 bits, to TA…

A: To find delay

Q: Consider the Go-Back-N (GBN) and Selective Repeat (SR) protocols with a sender window size of 4 and…

A: ANS: - There is a slight difference between Go-Back-N(GBN) and Selective Repeat protocol, that is: -…

Q: Consider the Go-Back-N protocol, with a window size N = 50. Suppose 30 packets are sene, büt the…

A: Given Go Back N where N is the size of the window. Window size N=50 Number of packets sent= 30…

Q: (a) Show that for any TCP, if the window size remains constant, then the amount of data transmitted…

A: (a) • Assume that following a particular transmission, the window size remains constant. • As a…

Q: If a communication system has packets with sequence numbers from 0 to 3, what is the maximum send…

A: To find: What is the maximum send and receive window size for the Selective-Repeat protocol? With…

Q: Consider the Go-back-N protocol with a sequence number space {0,1,2,3} and a window size N=3, and…

A: In Go-Back-N ARQ,N is the sender's window size. Suppose we say that Go-Back-3, which means that the…

Q: Consider the Go-Back-N protocol, with a window size N = 50. Suppose 30 packets are sent, but the…

A: Here we use Go-back-N protocol: ========================================== given that window size=50…

Q: Consider a scenario in which Host A wants to simultaneously send packets to Hosts B and C. A is…

A: Here, A can start sending another packet only after receiving Acknowledgment from B and C. Hence, we…

Q: In this problem, we consider sending real-time voice from Host A to Host B over a packet-switched…

A: Host A converts analog voice to a digital 64 kbps bit stream on the fly. Host A then groups the bits…

Q: The distance between two microwave towers, with the link capacity 100 Mbps, is 24 Km and the speed…

A: Introduction

Q: Consider a stop-and-wait protocol where the channel does not corrupt any packets (no bit errors) but…

A: Below is the complete explanation about stop-and-wait protocol with delay of packets (or)…

Q: In a network using the Go-Back-N protocol with m = 3 and the sending window of size 7, the values…

A: ANSWER:-

Q: Consider a packet of length L that begins at end system A and travels over three links to a…

A: Given terms are            Packet size,L = 1200 bytes= 1200* 8  Link transmission rate of all three…

Q: Consider there are 4 stations in the token ring. There is only one packet in the ring Suppose if the…

A: Explanation: The given case is of delayed token transmission, where the transmitter or sender is…

Q: Suppose we need to design a stop-and-wait, reliable data transfer protocol between a sender A and a…

A: It is defined as the simplest flow control method. In this, the sender will send one frame at a time…

Q: Suppose station X sends a message with 15 packets to station B using sliding window of size 4,…

A: Introduction :

Q: Consider there are 4 stations in the token ring. There is only one packet in the ring. Supposeif the…

A: Actually, THT stands for Token Holding Time.

Q: Consider two hosts, A and B, connected by a single link of rate R bps. Suppose that the two hosts…

A: Introduction: The transmission delay (dtrans) refers to the time duration that is required to…

Q: Consider two hosts, A and B, connected by a single link of bandwidth R bits per sec. Suppose that…

A: The answer is...

Q: Consider a link of length 1000 km with 10° bps rate connecting a sender and receiver. Assume a fixed…

A: Sliding window Protocol: In this protocol, the size of the sender window is always equal to the size…

Q: Given that two nodes start to transmit a packet of length "L" at the same time at the rate "R". The…

A: No collision were taken since the other nodes is able to finish transmission before the new packet…

Q: Consider sending a large file of F bits from Host A to Host B. There are two links (and one router)…

A: Introduction

Q: D) Consider sending a packet contains 1100 bits from Host A to Host B in a store and forward…

A: Given Data : Packet size = 1100 Bits Number of links = 10 links Number of packets in the queue = 5…

Q: Suppose that KJ sends 3596 back-to-back packets, with each packe composed of 14,000 bits, to TA over…

A: To find delay

Q: Under IPV6, fragmentation is implemented in end nodes only, unlike IPV4 where fragmentation can be…

A: Fragmentation is a common event on packet switched networks. This error happens when a large packet…

Q: Consider in the SW-ARQ protocol a packet can at most be retransmitted for 5 times, before it is…

A: Automatic Repeat ReQuest (ARQ): Systems which robotically request the retransmission ofmissing…

Q: Consider a simplified time slotted MAC protocol, where each host always has data to send and…

A: Introduction :Given , Time slotted MAC PROTOCOLprob. = 0.2max. throughput = 0.16 frameswe have to…

Q: Consider the Go-Back-N (GBN) and Selective Repeat (SR) protocols with a sender window size of 4 and…

A: Note: As you have asked a multipart question, as per our policy we will solve the first three parts…

Q: A is to send a packet of size L bits to Host B. Ignore the processing and queuing delays. Suppose s…

A: The answer is

Q: Consider two-dimensional parity scheme: a) Choose any random packet entries such that the following…

A:

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.