A load of 500 kg that is on the hydraulic lift is going to be lifted as shown in the figure, pouring oil (D = 780 kg/m3) into a thin tube. Determine what height h must be to begin lifting the weight.

Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…

A: According to Torricelli’s theorem, Here, vx, g and h represent the speed of the water coming out…

Q: A solid cylinder with base area A= 20 cm^2 is placed completely underwater as shown in the figure.…

A:

Q: The small piston of a hydraulic lift (see figure below) has a cross-sectional area of 2.70 cm2, and…

A:

Q: Calculate the fluid force on one side of a semicircular plate of radius 10 ft that rests vertically…

A:

Q: The maximum gauge pressure in a hydraulic lift is 17 atm. What is the largest size vehicle (kg) it…

A:

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A:

Q: The small piston of a hydraulic lift has a cross-sectional area of 3.9 cm2 and its large piston has…

A:

Q: An oil tank has draft (depth under water) of 25 m in salt water. Assuming its sides are vertical.…

A: Given: An oil tank has a draft of 25m in saltwater. Assuming its sides are vertical. what is its…

Q: A jet of water squirts out horizontally from a hole near the bottom of the tank shown in the figure.…

A:

Q: what depth, h (in meters), does the boat sink into the water? i.e. how far down does it sink, to…

A: Given data:   The density of wooden raft  is: ῤr = 401.4 kg/m3 The surface area of the wooden raft…

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

A: Data provided:   Area of small piston (A1) = 30 m2 Force on small piston (F1) = 100 N Force on large…

Q: 7. The 500 kg load on the hydraulic lift shown below is to be raised by pouring oil of mass density…

A: Pascal's law states that the pressure applied to the static and incompressible fluid is transmitted…

Q: A hydraulic lift has two pistons: a small one of cross-sectional area 5.00 cm- and a large one of…

A: Given: area of small piston, a = 5 cm2  area of large piston, A = 300 cm2 mass on large piston, M =…

Q: Consider the hydraulic lift shown in the figure. The small piston has an area Aj of 0.0330 m², and…

A: A) As per Pascal’s principle, Here, P1 and P2 are the pressures at the pistons of area A1 and A2,…

Q: (10.14) The maximum gauge pressure in a hydraulic lift is 17.0 atm. What is the largest-size vehicle…

A:

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

A:

Q: A hydraulic cylinder lifts a car (F2) delivering a force of 15000 N. The diameter of the small…

A:

Q: Calculate the pressure on the top lid of a chest buried under 4.00 m of mud with density equal to…

A: GivenHeight of mud, h1=4 mDensity of mud, ρ1=1.75×103 Kg/m3Depth of lake of water, h2=10 m

Q: What would be the height of water column which will produce a pressure of one atmosphere?

A: GivenPressure P = 1atm = 101325 PaKnown Density of water ρ = 1000 kg/m3

Q: The pipe flow in Fig. P3.12 fills a cylindrical surge tank as shown. At time t = 0, the water depth…

A:

Q: You wish to design a hydraulic lift such that it can lift a maximum load of 5000 kg.  Your input…

A: given: F1min=50NF1max=100 NA1 = 1 mm2=1*10-6m2F2=5000kg*9.8 m/s2=49000 N we have to find A2max

Q: The figure to the right shows the shape and dimensions of a small dam. Assuming the water level is…

A:

Q: A block of wood of 2m x 1m x 1m in size and of specific gravity 0.75 is floating in water. What is…

A: Volume of the block V=2m×1m×1m=2 m3 Specific gravity of the block =0.75 Density of wood ρ=0.751000…

Q: Area = 15 cm2 Area = 65 cm2 %3D %3D

A: Area of smaller side = 15 cm2area of larger side = 65 cm2mass of rock = 55 kg weight of rock = mg  =…

Q: A car weighs 9800 N and sits on the hydraulic lift that utilizes a piston with a cross section area…

A:

Q: Find the pressure in atmospheres in the water at the base of a Dam if the water in the reservoir is…

A: Given data: Height of the reservoir h =20m 1 atm =1.1×105 N/m2

Q: The hydraulic lift's small piston with an area of 30 m^2 is subjected to a force of 100 N. To have…

A:

Q: The area of the small piston in a hydraulic jack is 0.75 m². The area of the large piston is 3.0 m2.…

A:

Q: If the pressure in a hydraulic press is increased by an additional 10 N/cm2, how much extra load…

A: The pressure on the hydraulic press,

Q: What is the depth of a lake if pressure of 8×105 [Pa] acts upon its bottom?

A: The pressure at the bottom of the lake,

Q: What force (in N) must be exerted on the master cylinder of a hydraulic lift to support the weight…

A: Given data: Mass of a car is, m=2400 kg. Diameter of master cylinder is, d1=1.70 cm =0.017 m.…

Q: 1 m 2 m E 2 m H 1 m -2 m -1 m-

A:

Q: a hydraulic lift where a mass of 50 kg at the piston (point 1) balances a mass of 950 kg at point…

A:

Q: A schematic of a homemade hydraulic jack is shown in the figure below, with cylindrical tube ends of…

A:

Q: A force of 30. N is applied to the input piston of a hydraulic jack. If the input and output piston…

A: Given data:  Force on input piston (F1) = 30 N Area of input piston (A1) = 0.20 m2  Area of output…

Q: The 500-kg load on the hydraulic lift is to be raised by pouring oil (p = 780 kg/m³) into a thin…

A: Given data, Load mass = 500 kg Diameter = 1.2 m Density of the oil = 780 kg/m3

Q: An automobile of mass 600 kg is supported by a hydraulic lift having a large piston of…

A: (a)          Since the pressure is same at all points, The pressure applied to the piston and pedals…

Q: The inside diameters of the larger portions of the horizontal pipe depicted in the figure are 2.50…

A: Fluids are defined as the material that has the special property of being able to flow. This…

Q: A hydraulic jack is used to lift objects such as automobiles. If the input force is 250 N over a…

A: Given data The input force is given as F1 = 250 N. The distance over the input force is applied is…

Q: 3.99 The hydrometer shown sinks 5.3 cm in water (15°C). The bulb displaces 1.0 cm³, and the stem…

A: Archimedes principle states that the buoyant force is equal to the weight of the displaced water. A…

Q: In a hydraulic system, the radius of the large piston in a hydraulic Jack is 2.23 inches. The radius…

A:

Q: d the pressure in atmospheres at the base of Dam if the water in the reservoir is 220 meters deep.…

A: Excess pressure due to liquid column =h.d.g Where h = height of liquid  And d = density of liquid

Q: ) What is the flow rate in cm/s? 141.4 cm3/s ) What is the diameter (in cm) of the stream 0.200 m…

A:

Q: hat is the flow rate of water that moves at an average speed of 2.8 m/s through a uniform pipe with…

A: Volume flow rate is Q=Av=πd24v

Q: Consider the hydraulic lift shown in the figure. The small piston has an area ?1 of 0.0330 m2, and…

A: Pressure is defined as the force applied per unit area of a surface. Fluids are the states of matter…

Q: A hydraulic lift's first cylinder has a 4.5 cm-diameter while a second cylinder has a 17.8…

A:

Q: A largest tank open to the atmosphere at the top and filled with water develops a small hole in its…

A: