A magnetic field of magnitude 0.210 T is oriented perpendicular to the plane of a circular loop. HINT (a) Calculate the loop radius (in m) if the magnetic flux through the loop is 2.60 Wb. m (b) Calculate the new magnetic flux (in Wb) if the loop radius is doubled.

A magnetic field of magnitude 0.210 T is oriented perpendicular to the plane of a circular loop. HINT (a) Calculate the loop radius (in m) if the magnetic flux through the loop is 2.60 Wb. m (b) Calculate the new magnetic flux (in Wb) if the loop radius is doubled.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter30: Magnetic Fields And Forces

Section: Chapter Questions

Problem 88PQ

See similar textbooks

Related questions

Q: An electron travels to the right, as shown in the figure below, starting in a region of zero…

Q: The figure shows a circular loop of radius a=2.1 cm concentric with a circular arc of radius b=2.8…

Q: Consider the hemispherical closed surface below. The hemisphere is in a uniform magnetic field that…

Q: The two conductors shown in the figure carry currents I = 10 A from left to right. Point P is the…

Q: A circular loop is at rest in a uniform magnetic field B of magnitude 10.8 mT that is directed to…

A: Given that, Magnetic field(B) =10.8 mT Radius (r) = 30 mm…

Q: what is the magnitude of the torque and magnetic potential energy acting on wire about an axis on…

Q: Assume a circular area A is enclosed by a wire loop that is under a constant magnetic field with…

A: The magnetic flux passing through a surface is given by : ϕ=BAcos θ Where B is the magnetic field A…

Q: A rectangular surface of length 3.5cm and width 5.25cm lies on the y-z plane at x=0. What is the…

Q: A rectangular surface of length 3.25 cm and width 5.25 cm lies on the y-z plane at x = 0. What is…

A: Given data: Length of rectangular surface is, L=3.25 cm=3.25×10-2 m. Width of rectangular surface…

Q: n the figure, take i = 0.51 A and R = 1.6 cm. Find the magnitude and direction (into or out of the…

A: Given The magnitude of the current is i=0.51 A. The value of the R is R=1.6 cm=1.6×10-2 m. The…

Q: A square coil of side 10 cm consists of 20 turns and carries a current of 12 A. The coil is…

A: Given Data:- A=0.10 m×0.10 m A=0.01 m2 N=20 I=12 AmP θ=30° B=0.80…

Q: The figure shows a closed surface. Along the flat top face, which has a radius of 1.6 cm, a…

A: GivenRadius of the top surface r = 1.6 cm = 0.016 mMagnetic field outward the top surface B = 0.14…

Q: An electron travels to the right, as shown in the figure below, starting in a region of zero…

A: Electron will be in the region of non zero field for T = 3.796*10-9 sec. Kinetic energy is K.E. =…

Q: A Gaussian surface in the shape of a right circular cylinder with end caps has a radius of 15.1 cm…

A: The magnetic flux through the closed surface is zero. The addition of the flux through the two…

Q: A uniform magnetic field passes through a horizontal circular wire loop at an angle 15.1° from the…

Q: A circular loop of wire with a radius of 15.0 cm and oriented in the horizontal xy-plane is located…

A: The average emf induced by the change in magnetic flux in a circular loop of wire is given as ε =…

Q: A wire of length 50 cm and mass of 12 g is suspended in a horizontal plane by a pair of flexible…

Q: The figure shows a closed surface. Along the flat top face, which has a radius of 1.5 cm, a…

Q: A horizontal rectangular surface has dimensions 2.80 cm by 3.20 cm and is in a uniform magnetic…

Q: An aircraft, of wing span 60 m, flies horizontally at a speed of 150 m s^–1. If the vertical…

A: Given, Wing span, l=60 m Speed, v=150 m/s Magnetic field, B=1.0×10−5T Time, t=10 s

Q: long, straight conductor carries a 1.0- A current. At what distance, r from the axis of the…

Q: Below is a perspective view of a flat surface with a dimension of 1.8 cm by 2.0 cm in a uniform…

A: dimension of surface = 1.8 cm by 2 cm magnetic flux = 0.60 mWb

Q: A small circular loop of area 2.00 cm2 is placed in the plane of, and concentric with, a large…

Q: orw A magnetic field of 2.4 T passes through a single loop square coil of side length 5.9 x 102 m…

Q: The figure below shows three edge views of a square loop with sides of length e = 0.145 m in a…

Q: Consider a rectangular loopof wire 6.8 cm by 9.2 cm in a uniform magnetic field of magnitude1.7 T.…

A: Given data: The one side of the rectangular loop is a=6.8 cm. The another side of the rectangular…

Q: A current is set up in a wire loop consisting of a semicircle of radius 4.00 cm, a smaller…

Q: A square coil of side 10 cm consists of 20 turns and carries a current of 12 A. The coil is…

Q: Using the Biot-Savart law, find the magnetic field H at the center of a square loop conductor with…

Q: A flatbed truck carries a 20-ft I-beam (perpendicular to the bed of the truck) north over a flat…

A: The length of the beam is The velocity of the beam is same as the velocity of the truck v = 29m/s…

Q: A rectangular surface of length 3.25 cm and width 5.25 cm lies on the x-y planes at z=0. What is the…

A: Length of rectangular surface l = 3.25 cm = 3.25×10-2 m Width of rectangular surface w = 5.25 cm =…

Q: Earth’s magnetic field approximates that of a dipole with a field of 6×10−5 T at the North Pole.…

A: Motional induced emf = Blv

Q: Suppose a straight 1.00 mm diameter coper wire could float horizontally in air because of the force…

A: d=1mm B= 5×10-5 T μ = 0.01kg/m

Q: Two N-turn circular Helmholtz coils are placed parallel to one another and separated by a distance…

A: Helmholtz coil consists of two identical magnetic coils placed parallel to each other along a…

Q: A circular area with a radius of 6.50 cm lies in the xy-plane. What is the magnitude of the magnetic…

A: Given data: Radius of circle is, r=6.50 cm=6.50100=0.065 m. Strength of magnetic field is, B=0.230…

Q: A conducting bar of length L=80 cm is rotated on a conducting circular platform as shown in the…

Q: A copper wire, connected in series with a 100-2 resistor, is formed into a rectangular loop whose…

A: Resistance of resistor: R = 100 Ω length of rectangular loop: l = 2.0 m Breadth of rectangular…

Q: A rectangular surface of length 3.25 cm and width 5.25 cm lies on the y-z plane at x = 0. What is…

Q: The figure shows a circular loop of radius a=2.1 cm concentric with a circular arc of radius b-2.9…

Q: The figure below shows three edge views of a square loop with sides of length = 0.425 m in a…

Q: For a current-carrying loop attached to a fixed axis in a uniform magnetic field, what is the phase…

A: Required : What is the angular difference between when the flux is maximum and when the torque is…

Concept explainers

Magnetic Field Of Coaxial Cable

The word coaxial means same axis. So for a long straight cable to be coaxial, it must have concentric cylindrical shaped conductor around it. Coaxial cable (popularly called ‘coax’) has various applications ranging from current conductors to radiofrequency signal transmitters. This cable has lower emission losses and provides protection from electromagnetic interference which allows signals with less power to transmit over longer distances.For example, currents produced in the pickup of a stereo turntable generally travel to the amplifier through a coaxial cable.The self-inductance of a coaxial cable is another important characteristic, because it influences the propagation of electrical signals in the cable.

Question

A magnetic field of magnitude 0.210 T is oriented perpendicular to the plane of a circular loop.

HINT

(a)

Calculate the loop radius (in m) if the magnetic flux through the loop is 2.60 Wb.

(b)

Calculate the new magnetic flux (in Wb) if the loop radius is doubled.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Sketch a plot of the magnitude of the magnetic field as a function of position r for a coax (Fig. P31.27).
Assume the region to the right of a certain plane contains a uniform magnetic field of magnitude 1.00 mT and the field is zero in the region to the left of the plane as shown in Figure P22.71. An electron, originally traveling perpendicular to the boundary plane, passes into the region of the field. (a) Determine the time interval required for the electron to leave the field-filled region, noting that the electrons path is a semicircle. (b) Assuming the maximum depth of penetration into the field is 2.00 cm, find the kinetic energy of the electron.
A magnetic field directed into the page changes with time according to B = 0.030 0t2 + 1.40, where B is in teslas and t is in seconds. The field has a circular cross section of radius R = 2.50 cm (see Fig. P23.28). When t = 3.00 s and r2 = 0.020 0 m, what are (a) the magnitude and (b) the direction of the electric field at point P2?
When the current through a circular loop is 6.0 A, the magnetic field at its center is 2.0104 T. What is the radius of the loop?
Show that the magnetic field at a distance r from the axis of two circular parallel plates, produced by placing charge Q(t) on the plates is Bind=02rdQ(t)dt
Two long coaxial copper tubes, each of length L, are connected to a battery of voltage V. The inner tube has inner radius o and outer radius b, and the outer tube has inner radius c and outer radius d. The tubes are then disconnected from the battery and rotated in the same direction at angular speed of radians per second about their common axis. Find the magnetic field (a) at a point inside the space enclosed by the inner tube r d. (Hint: Hunk of copper tubes as a capacitor and find the charge density based on the voltage applied, Q=VC, C=20LIn(c/b) .)
How many turns must be wound on a flat, circular coil of radius 20 cm in order to produce a magnetic field of magnitude 4.0105 T at the center of the coil when the current through it is 0.85 A?
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
Figure P23.15 shows a top view of a bar that can slide on two frictionless rails. The resistor is R = 6.00 , and a 2.50-T magnetic field is directed perpendicularly downward, into the paper. Let = 1.20 m. (a) Calculate the applied force required to move the bar to the right at a constant speed of 2.00 m/s. (b) At what rate is energy delivered to the resistor? Figure P23.15 Problems 15 through 18.
A toroid has a major radius R and a minor radius r and is tightly wound with N turns of wire on a hollow cardboard torus. Figure P31.6 shows half of this toroid, allowing us to see its cross section. If R r, the magnetic field in the region enclosed by the wire is essentially the same as the magnetic field of a solenoid that has been bent into a large circle of radius R. Modeling the field as the uniform field of a long solenoid, show that the inductance of such a toroid is approximately L=120N2r2R Figure P31.6
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
Two long, parallel wires carry currents of 20.0 A and 10.0 A in opposite directions (Fig. OQ22.13). Which of the following statements is true? More than one statement may be correct. (a) In region I, the magnetic field is into the page and is never zero. (b) In region II, the field is into the page and can be zero. (c) In region III, it is possible for the field to be zero. (d) In region I, the magnetic field is out of the page and is never zero. (e) There are no points where the field is zero. Figure OQ22.13 Objective Questions 13 and 14.