A Maxwell's capacitance bridge shown in fig is used to measure on unknown inductance incomparison with capacitance. The various values at balance are:R{2} = 400 0;R{3} =6000R{4} = 1000 (2;C{4} = 0.5μFCalculate the value of R{1} and L{1}.Also calculate the value of Q-factor of coil if frequency is1000 Hz.AR₁www-E₁L₁.wwww12-E₂-I₁BD-Es-(D) DetectorR1wwwwEC4Ic.1₂N-E-I₁کسیدR4CIcB₂=1₂R₂I₁R₁IR E₂=E4EIc1,R₂ CA-=I₂ R4

Answered: Image /qna-images/answer/00577b22-a294-4306-9c39-6deebc502c0c.jpg

A Maxwell's capacitance bridge shown in fig is used to measure on unknown inductance in comparison with capacitance. The various values at balance are: R{2} = 400 ; R{3} =6000 R{4} = 1000 ; C{4} = 0.5µF Calculate the value of R{1} and L{1}.Also calculate the value of Q-factor of coil if frequency is 1000 Hz.

A Maxwell's capacitance bridge shown in fig is used to measure on unknown inductance in comparison with capacitance. The various values at balance are: R{2} = 400 ; R{3} =6000 R{4} = 1000 ; C{4} = 0.5µF Calculate the value of R{1} and L{1}.Also calculate the value of Q-factor of coil if frequency is 1000 Hz.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

27. A phasor can be represented or expressed in either rectangular form (x +j y) or polar form (z cis n) True False 28. By convention, values obtain from time domain representation are always real while in phasor domain representation, values are generally expressed in complex form. True False 31. Value of capacitance is usually affected by the following physical dimensions and construction of a capacitor: such as number of turns, its length, its cross-sectional area and the permeability of the core. True False
A cylindrical capacitor is made of two concentric conducting cylinders. The inner cylinder has radius R1 = 19 cm and carries a uniform charge per unit length of λ = 30 μC/m. The outer cylinder has radius R2 = 25 cm and carries an equal but opposite charge distribution as the inner cylinder. a. Use Gauss’ Law to write an equation for the electric field at a distance R1 < r < R2 from the center of the cylinders. Write your answer in terms of λ, r, and e0. E= b. Write an equation for the energy density due to the electric field between the cylinders in terms of λ, r, and e0. u = c. Consider a thin cylindrical shell of thickness dr and radius R1 < r < R2 that is concentric with the cylindrical capacitor. Write an equation for the total energy per unit length contained in the shell in terms of λ, r, dr, and ε0. dU/l = d. Calculate the energy stored per unit length in the capacitor in units of joules per meter. U/l = e. Calculate the electric potential difference between…
Find the relative permittivity of the dielectric material present in a parallel-platecapacitor if: (a) S = 0.12 m/, d = 80 μm, V = 12 volt, and the capacitor contains1 ?? of energy; (b)The stored energy density is 100 ?/?/, V = 200 volt, and ? =45 ??; (c) ? = 200 ??/? and ?# = 20 ??/?/.
A parallel-plate capacitor consists of square plates of edge length ℓ that are separated by a distance d, where d << ℓ. A potential difference ΔV is maintained between the plates. A material of dielectric constant k fills half the space between the plates. The dielectric slab is withdrawn from the capacitor as shown. (a) Find the capacitance when the left edge of the dielectric is at a distance x from the center of the capacitor. (b) If the dielectric is removed at a constant speed υ, what is the current in the circuit as the dielectric is being withdrawn?
A capacitor is made from two flat parallel plates placed 2 mm apart, .and its capacitance at vacuum is 10-12- F , if 200 volt applied in between then a Dielectric material was entered and its Dielectric constant Is 49 , Calculate : a) the new value of capacitance after the entrance of the Dielectric b) what is the value of charge on Dielectric material surface c) the polarization p of the Dielectric material d) calculate the displacement and the field inside the Dielectric
Hodgkin-Huxley type models represent the biophysical characteristic of cell membranes. The typical Hodgkin-Huxley model treats each component of an excitable cell as an electrical ele- ment, as shown in the figure. Extracellular medium gn(t,v) 60 w Intracellular medium (i) Explain the biological meanings of the capacitance (Cm), conductances (gn and gl), and batteries (E). (ii) State the equations for the current flowing through the lipid bilayer, and the current through a given ion channel. (iii) State the equation for the total current through the membrane of a cell with sodium and potassium channels. Explain the biophysical meaning of all parameters. (iv) Ion pumps and exchangers are represented in the model by current sources (Ip). Explain how the sodium-potassium exchanger functions.
The equation for the voltage ?(?) across a capacitor at time ? is?(?)=1?(∫?(?)???0+?0)Where ?(?) is the current passing through the capacitor, and ?0 is the initial charge. Consider a capacitor with ?=1?? and ?0=0. If ?(?)=0.1(0.2+sin0.5?) A, find ?(?) for ?=0.5 sec.
A conducting coil, with current i(t) = 4.40e−0.0250t sin(120πt), with i in amperes and t in seconds, is placed next to a second coil, end to end. At t = 0.720 s, a lab tech measures the emf across the second coil, and the result is −3.50 V. What is the mutual inductance (in mH) of the coils?
An Underground cable of length 40 Km has a conductor of diameter of 1.5 cm and a sheath of inner diameter 5 cm. If the permittivity of insulation is 3.5, Analyze the following Electrical Parameters of the UG-cables (i) the inductance per km length (ii) capacitance per km length. (iii) Natural impedance (Surge Impedance) and (iv) velocity of propagation of the travelling waves.
Q.decide if the given statement is true or false,and give a brief justiﬁcation for your answer.If true, you can quote a relevant deﬁnition or theorem . If false,provide an example,illustration,or brief explanation of why the statement is false. An external driving force E(t)= E0 cosωt produces a steady-state current of maximum amplitude when ω = 1 /√LC
A paper dielectric plate capacitor is to be experimentally tested. The metal plates and the paper material between said plates are all 20 cm in radius and subjected to 10V dc in the test. How much is the capacitance does this capacitor have in picofarads (pF), if the paper material between plates used is 2 cm thick? Input answer in 4 decimal places and in pF. Note: Relative permittivity of the paper ( εr ) : 0.4225
5 Assume that you have been tasked with evaluating a new inductor. The inductor has a Q of 1454 at 50KHZ; a 0.1mm diameter, and is fabricated by wrapping a 10meter length copper wire wound around a magnetic core. Assume the following parameters for copper wire wound around a magnetic permeability of copper is 1. A. what is the inductance of the inductor? B. Assuming that the skin affect does not affect the Q at 50KHZ at all, determine the Q at 50MHZ.